Whalen WS3060926FP Manuel utilisateur
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION.
PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Whalen Furniture Mfg., Inc. Page 1 Factory No. 15548
Date 2014-07-11 Rev. 1 Factory: DOGULU
PRINCETON 44'' Media Fireplace
Model # WS3060926FP
ADULT ASSEMBLY AND SET-UP REQUIRED
If you have any questions regarding assembly or if parts are missing, DO NOT return this item to the
store where it was purchased. Please call our toll-free customer service number and have your
instructions and parts list ready to provide the model name, part name or factory number:
1-866-942-5362
Pacific Standard Time: 8:30 a.m. - 4:30 p.m., Monday - Friday
Or visit our web site 24 hours a day, 7 days a week for product assistance at
www.whalenfurniture.com
LOT NUMBER:
DATE PURCHASED: / /
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 2 Factory No. 15548
QUALITY GUARANTEE
We are confident that you will be delighted with your Whalen Furniture purchase.
Should this product be defective in workmanship or materials or fail under normal use, we will
repair or replace it for up to one (1) year from date of purchase. Every Whalen Furniture product is
designed to meet your highest expectations. We guarantee that you will immediately see the value of
our fine furniture.
This warranty gives you specific legal rights and you may also have other rights which vary from
province to province (state to state).
Customer Service: 1-866-942-5362
8:30 a.m. - 4:30 p.m., PST, Monday to Friday
www.whalenfurniture.com
MANUFACTURER: Whalen Furniture Mfg., Inc.
CATALOG: PRINCETON 44'' Media Fireplace (WS3060926FP)
DATE OF MANUFACTURE: Aguest 2014
MADE IN CHINA
MAXIMUM RECOMMENDED WEIGHT LOADS
FITS UP TO MOST 50” FLAT PANEL TVs
MAXIMUM LOAD 135 lb. (61.2 kg)
MAXIMUM LOAD 15 lb. (6.8 kg)
MAXIMUM LOAD 50 lb. (22.6 kg)
PLACE TV BEHIND THE STOPPER
THIS UNIT IS NOT INTENDED FOR USE WITH CRT TVS. USE ONLY WITH FLAT
PANEL TVS AND AUDIO/VIDEO EQUIPMENT MEETING RECOMMENDED SIZE AND WEIGHT LIMITS.
NEVER USE WITH LARGER/HEAVIER THAN RECOMMENDED FLAT PANEL TVS OR EQUIPMENT. TO
AVOID INSTABILITY, PLACE FLAT PANEL TV IN THE CENTRE OF THE UNIT; DO NOT ALLOW TV TO
OVERHANG UNIT IN ANY DIMENSION. IMPROPERLY POSITIONED FLAT PANEL TVS, OR FLAT
PANEL TVS OR OTHER EQUIPMENT THAT EXCEED RECOMMENDED SIZE AND WEIGHT LIMITS
COULD FALL OFF OR BREAK THE UNIT, CAUSING POSSIBLE SERIOUS INJURY.
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 3 Factory No. 15548
Important
Before you begin: Open, identify and count all parts prior to assembly. Lay out parts on a flat and non-
abrasive surface. You will need the parts identified on page 4 of this instruction manual.
NOTE: IT IS VERY IMPORTANT TO USE GLUE WITH DOWELS. EXCESS GLUE CAN BE WIPED
OFF WITH DAMP CLOTH.
Insert the Dowel at least half way by tapping lightly with a rubber mallet, IF NECESSARY.
CAM LOCK SYSTEM OPERATION
HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS
1. Screw the Cam Bolt into the threaded inserts on the panel. Connect both panels together; making sure Cam
Bolt goes into the pre-drilled hole on the end of panel for Cam Lock.
2. Insert the Cam Lock into the pre-drilled large hole on the panel. Make sure the arrow on the face of Cam
Lock faces out and points towards Cam Bolt.
3. Take a Phillips screwdriver and rotate the Cam Lock clockwise to lock the Cam Bolt in place.
4. Plug the Cam Lock Cover into the cross slot of the Cam Lock to conceal the Cam.
You are now ready to assemble the KD unit.
XXFINAL
12 43
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 4 Factory No. 15548
Parts and Hardware List
Please read completely through the instructions and verify that all listed parts and hardware are present
before beginning assembly.
A- Mantel Base with Fireplace (1)
B- Top Panel (1) C- Upper Back Panel (1)
D- Upper Side Panel (2) E- Upper Partition Panel (1) F- Adjustable Shelf (2)
(1) Cam Lock (2) Cam Bolt (3) M8 x 30 mm Wood Dowel (4) Cam Lock Cover
(12+1 extra) (12+1 extra) (6+1 extra) (14+1 extra)
(5) 1/2” Washer Head Screw (6) Shelf Support (7) Acrylic Stopper
(16+1 extra) (8+1 extra) (1)
(8) Remote Control with Battery Glue Touch-up Pen Tipping Restraint Hardware Kit (2)
(1) (1) (1) (Included in plastic bag)
Tools required: Phillips screwdriver and Rubber Mallet (not provided).
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 5 Factory No. 15548
Assembly Instructions
1. Unpack the unit and confirm that you have all the hardware and required parts.
2. With the help of an assistant, remove the Mantel Base (A) from the box, and place it near the final
installation location. Securely screw six Cam Bolts (2) into the designated small holes by Phillips
screwdriver, as shown above.
3. Place the Top Panel (B) on a level and protective surface with the holes facing up. Securely screw six Cam
Bolts (2) into the designated small holes by a Phillips screwdriver. As show.
Cam Bolt
(12 used in this step)
②
A
A/B
B
2
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 6 Factory No. 15548
Assembly Instructions
4. Insert one Wood Dowel (3) into the middle hole of the Upper Side Panels (D). Lightly tap in with a rubber
mallet, if necessary. Make sure that you use a small amount of glue with both ends of all dowels.
NOTE: It is very important to use a small amount of glue on both ends of dowels.
5. Align the inserted Wood Dowels (3) under one Upper Side Panel (D) with the large hole on the Top Panel
(B), and then press them together. Make sure that the front molding of the Upper Side Panel (D) faces
inward. Secure the Upper Side Panel (D) in place by engaging two Cam Locks (1) (Refer to page 3 on Cam
Lock system operation supplement).
6. Repeat the same procedure to attach the other Upper Side Panel (D) at the opposite end.
7. Fasten the Upper Partition Panel (E) to the center of the Top Panel (B) by using two Cam Locks (1) and one
Wood Dowel (3). As shown.
D
D
E
B
B
D/E
3
1
M8 x 30 mm Wood Dowel
(3 used in this step)
③
Cam Lock
(6 used in this step)
①
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 7 Factory No. 15548
Assembly Instructions
8. Insert one Wood Dowel (3) into the middle end hole of the Upper Side Panels (D) and Partition Panel (E)
respectively. Fasten last assembly to the Fixed Shelf of the Mantel Base (A) by engaging six Cam Locks (1).
9. Plug the provided Cam Lock Covers (4) onto the visible Cams Locks to conceal the Cams.
A
4
B
D
D
E
A
M8 x 30 mm Wood Dowel
(3 used in this step)
③
Cam Lock
(6 used in this step)
①
Cam Lock Cover
(14 used in this step)
④
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 8 Factory No. 15548
Assembly Instructions
10. Now, go back and securely tighten all the Cam Locks and the Screws. Make sure that all the parts are tight
and there are no gaps between the parts. This will help keep the unit square.
11. Pick up the Back Panel (C) and align the pre-drilled holes against the upper long edge with the pilot holes
on the back stretcher of the Top Panel (B). Attach the Back Panel (C) in place using the provided 1/2”
Washer Head Screws (5). As shown.
Fireplace
5
B
C
D
C
B
#6 x 1/2” Washer Head Screw
(16 used in this step)
⑤
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 9 Factory No. 15548
Assembly Instructions
12. Open the side doors and insert the Shelf Supports (6) into the desired holes inside the side compartments.
Make sure you place the four Shelf Supports in the same level so the shelf is not tilted. Properly rest the
Adjustable Shelves (F) onto the Shelf Supports (6).
6
F
6
F
B
Shelf Support
(8 used in this step)
⑥
Model # WS3060926FP
Please call for replacement parts or assistance: 1-866-942-5362
Whalen Furniture Mfg., Inc. Page 10 Factory No. 15548
Assembly Instructions
NOTE: You must install the Acrylic TV Stopper to prevent the TV from tipping when placing your flat
panel television directly on the Top Panel (B).
13. Remove the tape of the Acrylic Stopper (7) and place it in the cut-out of the acrylic stopper template on the
front of the Top Panel (B). Make sure it is properly aligned before applying pressure.
14. Remove the acrylic stopper template carefully, as shown above.
B
B
B
Acrylic Stopper
(1 used in this step)
⑦
Table des matières
Autres manuels Whalen Cheminée intérieure
Whalen
Whalen WSLWFP54-6 Manuel utilisateur
Whalen
Whalen WMFP31EC-1 Manuel
Whalen
Whalen Middleton WSF48WV23-DB Manuel utilisateur
Whalen
Whalen Shelby WSF72SY26C Manuel utilisateur
Whalen
Whalen Farmstead WSF60FM23R-AO Manuel utilisateur
Whalen
Whalen Millstead WSF60MS26GAO Manuel utilisateur
Whalen
Whalen WH300-26C2D-RGBM Manuel utilisateur
Whalen
Whalen WSF48FM23R-AO Manuel utilisateur
Whalen
Whalen Windham Manuel utilisateur
Whalen
Whalen FP32EC23I-1BC Manuel utilisateur
Whalen
Whalen Bookcase Media Fireplace Manuel utilisateur
Whalen
Whalen Evanston MNFP48ES23GA Manuel utilisateur
Whalen
Whalen WMFP60FH-9 Manuel utilisateur
Whalen
Whalen SF122-23A Manuel utilisateur
Whalen
Whalen WMFP60EC-7 Manuel utilisateur
Whalen
Whalen SUMCMF-23 Manuel utilisateur
Whalen
Whalen Barston WMFP48EC-25DC Manuel utilisateur
Whalen
Whalen WMFP54HL-23 Manuel utilisateur
Whalen
Whalen Barston WMFP48EC-25EP Manuel utilisateur
Whalen
Whalen MNFP60PV26WT Manuel utilisateur
