KEEP WARM - After the steaming time has elapsed, an audible
beep will sound 5 times and the “STEAM” icon will disappear. The
steamer will enter a 1 hour keep warm mode indicated by a
“WARM” icon and “00” in the display. During the keep warm mode,
the steamer will periodically turn off and on to maintain food at serving
temperature. When the keep warm mode is finished, the steamer will beep and
“OFF” and “10” will appear in the display.
If you want to cancel the “WARM” cycle, press the “START/STOP” button.
DELAY COOKING
1. Follow steps 1 - 4 from the “STEAMING” directions. Note: Do not
press the “START/STOP” button.
2. Press the “SET DELAY” button. The “SET” icon and 6:00 will be
displayed.
3. Pressing the “STEAM TIME” buttons will adjust the delay time up or down
between 00 and 12 hours. Note: Hold either button down to scroll quickly.
4. Press the “SET DELAY” button to accept the delay time. Once the
button is pressed, the hourglass icon will be displayed which
means the timer is counting down to 0:00. When the timer reaches
0:00, the unit will beep once and start the steaming cycle.
•If you decide to change the delay time after it has been set, press the “SET
DELAY” button and you will be back in “SET” mode. After changing the delay
time, be sure to press “SET DELAY” again to start the timer.
•If you decide to change the steam time when in the delay mode, press the
“START/STOP” button and you will be back in the steam timer mode. Note:
The delay timer will have to be reset after you change the steam time.
ADD WATER ALARM – when the steamer is out of water or the water
level is too low to complete the steaming cycle, the steamer has a self-
protection feature that will stop the steaming operation. An audible
beep will sound for 50 seconds and the “ADD WATER” icon will appear in the
display.
If this happens, push any button to stop the alarm. The steam time and “OFF” will
appear in the display. Add cold water through the drip tray handles or remove the
drip tray and add cold water directly into the heating base. Allow a few seconds for
the heater to cool down. Start the steamer up again by pushing “START/STOP”
button; the steamer will resume the cycle. If the steamer goes back into the alarm
mode, let the steamer cool down for a longer period of time and push the
“START/STOP” button again.
6
