WebGate webeye 2.0 b101 Manuel utilisateur

WebEye 2.0 B101
Installation Guide
(v 2.3)

FCC Compliance Statement
Caution : Any changes or modifications in construction of this device which are not expressly approved
the party responsible for compliance could void the user's authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications, However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution
Change or Modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment
Warning
1. Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
2. Disposal of used batteries according to the general recommendations against the environmental
pollution.
3. Do not throw the batteries into a fire, and do not heat, short-circuit or attempt to disassemble the
batteries.

Important Notice
1. WebEye is not weatherproof. Please note the environmental specifications that are included in the
manual. For outdoor usage, equip a weatherproof case to protect the WebEye from water, moisture, or
extreme temperature changes (higher or lower than the specifications noted below). The WebEye can be
cleaned by gently wiping with a clean dry cloth.
2. Be sure to use the DC adapter that is provided by Web Gate Inc. Connecting WebEye directly to an AC
current may cause damage to the WebEye.
3. Be cautious in handling WebEye. Physical shock such as dropping the unit may damage the WebEye
and void warranty.
4. The WebEye is made of aluminum. Be sure that it is fastened tightly during installation to avoid any
human injuries. Make sure to place away from the reach of children.
5. If WebEye does not operate properly, please contact your WebGate distributor for after sales service.
Unauthorized personnel are prohibited from disassembling the product. Disassembly will automatically
result in void of service warranty.
6. Camera surveillance laws may differ for each country and from province to province. Contact the local
region representative to avoid any violations and to apply for authorized purposes only.

Contents
Introduction..................................................................................................................................6
1. What is WebEye 2.0 B101?..................................................................................................6
2. Supplied accessories ..........................................................................................................7
3. Descriptions & Function......................................................................................................9
3.1. Using tapping screw......................................................................................................10
4. Installing & Connecting..................................................................................................... 11
4.1. Installing WebEye 2.0 setup program........................................................................... 11
4.2. System requirements of PC.......................................................................................... 11
4.3. Installig program ...........................................................................................................12
5. Connecting & Running......................................................................................................15
5.1. Connecting WebEye 2.0 B101 to Network ...................................................................15
5.1.1. Connecting to PC directly......................................................................................15
5.1.2. Connecting to local Network..................................................................................16
5.2. Changing IP address & Login.......................................................................................17
5.3. Setting Network.............................................................................................................18
5.3.1. When connected to Ethernet.................................................................................18
5.3.2. When connected to xDSL......................................................................................18
5.3.3. When connected to PSTN.....................................................................................19
5.3.4. Setting WRS(Dynamic IP registration) ..................................................................19
5.4. Setting video.................................................................................................................21
5.5. Changing admin password & Registering user.............................................................22
5.6. Viewing image via browser...........................................................................................23
6. Using Input / Output...........................................................................................................25
6.1. Connectinsg power.......................................................................................................26
6.1.1. Connecting DC power ...........................................................................................26
6.1.2. Connecting AC power............................................................................................27
6.2. Connecting & Setting serial port...................................................................................27
6.2.1. Connecting RS232.................................................................................................27
4

6.2.2. Connecting RS422.................................................................................................27
6.2.3. Connecting RS485.................................................................................................27
6.3. Connecting & Setting sensor input ...............................................................................28
6.3.1. Specification...........................................................................................................28
6.3.2. Diagram of sensor input ........................................................................................28
6.3.3. Connecting.............................................................................................................28
6.3.4. Setting sensor input...............................................................................................29
6.4. Video input impedance (DIP) setting switch.................................................................30
6.5. Video input / output.......................................................................................................30
6.6. Setting external device..................................................................................................30
Appendix ...................................................................................................................................32
#1. Specification ...................................................................................................................33
#2. How to recognize manufacturing date.........................................................................35
5

Introduction
1. What is WebEye 2.0 B101?
WebEye 2.0 B101 is a network video server solution with an integrated Internet server, image comp
ression device, flash memory, and many other features. No other hardware is necessary for use.
It relays video source from a CCTV camera to network and provides real time images over networks
and the Internet. Simply provide power and connect LAN cable and video cable to it.
Key features
Real-time monitoring through Network
4.5 MB Flash Memory for Homepage customization
Max. 100 simultaneous users support
RS 232 and RS 485/RS422 port support for PTZ control
Embedded Linux OS for excellent stability
Wavelet compression (30%~300% greater efficiency than JPEG) for higher refresh rate and
crisper images
4 external sensors support
S/W motion detection
Event triggered E-Mail & FTP sending function
Easy setting
Dynamic IP (DHCP) support (xDSL, Cable modem, PSTN)
Two ways audio support
6

2. Supplied accessories
Unpack and check all the items as below.
1. B101 (1)
2. DC POWER SUPPLY (1)
(FREE VOLTAGE)
3. AC POWER CORD (1)
4. CD-ROM (INCLUDING SOFTWARE &
MANUAL)(1)
5. ETHERNET CABLE (1, RED)
(UTP CATEGORY 5 CROSS CABLE)
6. ETHERNET CABLE (1, IVORY)
(UTP CATEGORY 5 DIRECT CABLE)
7

7. PSTN CABLE (1)
8. TAPPING SCREW (4)
9. PLASTIC ANCHOR (4)
8

3. Descriptions & Function
(1) Video Input
(2) Video Output
(3) Impedance Switch
(4) Serial Communication
(5) Sensor Input
(6) Ethernet
(7) Power
9

3.1. Using tapping screw
This is how to attach WebEye 2.0 B101 to wall or ceiling.
1) Make a hole (diameter: Φ6.5, depth: 30mm or above)
2) Insert the supplied plastic anchor into the hole.
PLASTIC
ANCHOR
TAPPING
SCREW
3) Fix WebEye 2.0 B101 with tapping screw.
10
Table des matières
Autres manuels WebGate Matériel réseau
Manuels Matériel réseau populaires d'autres marques

Matrix Switch Corporation
Matrix Switch Corporation MSC-HD161DEL Manuel utilisateur

B&B Electronics
B&B Electronics ZXT9-IO-222R2 Manuel utilisateur

Yudor
Yudor YDS-16 Manuel utilisateur

D-Link
D-Link ShareCenter DNS-320L Manuel utilisateur

Samsung
Samsung ES1642dc Instructions d'utilisation

Honeywell Home
Honeywell Home LTEM-PV Instructions de montage












