Vivotek AM-10F Manuel utilisateur

IP Surveillance

Installation Guide

AM-10F Mounting Bracket

VIVOTEK Multi-lens Dome Series

In-ceiling Mount

Rev. 1.0

Corresponding part number:

AM-10F: 100213100G

Document part no.: 625053200G

AM-10F Mounting Bracket Package Contents

Revison History:

Rev. 1.0: Initial release.

Applications

hanging rod

rail

secondary keel

main keel

Ø27.5cm ≦25mm

English

WARNING:

1. If the need should arise, add hanging rods to strengthen your suspended ceiling

structure.

2. Select a suitable location where the camera is free from accidental damage, tampering,

or harsh environmental conditions.

3. Locate a place for the installation where the camera can not be intentionally or

unintentionally interfered.

4. Select a solid and at mounting surface that can support the combined weight of the

camera and associated hardware. Vibration and temperature range should also be taken

into consideration.

Compatible VIVOTEK Cameras

Standard suspension ceiling tile

installation:

MA9322-EHTV

Weight: main body: 2705g; bracket: 1084g

Up to 60cm or 2 feet

60cm 30cm

Installation

OPEN Ø275 mm

275mm

1. Remove a ceiling tile from your suspended ceiling. Drill a hole on the ceiling tile that is

275mm in diameter.

2. Assemble the bracket hang rod with the two bracket stands.

Bracket hang rod

Bracket stand

English

3. Place the bracket assembly at the desired location. Spread and place the bracket

stands onto the secondary keels (or ceiling rails).

Secondary keel

on the suspension ceiling

Secondary keel

on the suspension ceiling

4. Fasten 2 included athead screws to secure the positions of bracket stands on the hang

rod. Once done, you can temporarily remove the assembly from the ceiling and proceed

with the following steps.

5. Insert the long threaded bolt through the adapter plate and the center hole on the hang

rod. Use hex nuts, lock washers, and plain washers to secure the positions of these

components. The combination details are shown below. Do not completely tighten the

hex nuts yet.

Adapter plate

Hex nut

Flat washer

Hex nut

Flat Washer

Lock washer

Bolt

English

6. Secure the MA9322's top mounting plate to the adapter plate using the included Phillips

screws.

7. Loosen or tighten the hex nuts and lock washers on the top and bottom of the hang rod.

Adjust the position of the whole conguration relative to the ceiling tile. The mounting

plate should be a little bit higher than the lower edge of the ceiling tile. Make sure you

can still press the release button on the mounting place from the top of the ceiling tile in

case you need to un-install the camera.

8. Tighten the hex nuts on top and below the hang rod when the adjustment is done.

9. Install the ceiling tile.

10. Lift and install the whole conguration into place. To do so, you may need to open the

adjacent ceiling tile on the suspension ceiling. Refer to the camera's QIG for the rest of

the installation details.

Table des matières

Autres manuels Vivotek Support et étagère

Vivotek

Vivotek AF101 Manuel utilisateur

Vivotek

Vivotek AM-518 Manuel utilisateur

Vivotek

Vivotek AM-412 Manuel utilisateur

Vivotek

Vivotek Fixed Dome AM-528 Manuel utilisateur

Vivotek

Vivotek AM-412 Manuel utilisateur

Vivotek

Vivotek AM-412 Manuel utilisateur

Vivotek

Vivotek Fixed Dome Series Manuel utilisateur

Vivotek

Vivotek AM-218 Manuel utilisateur

Vivotek

Vivotek Bullet Series Manuel utilisateur

Vivotek

Vivotek AM-21M Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur