Pair with Controller
Pair Additional Wireless Keypad and Mini Controller
1) They all are already paired when out of factory, if no problem, the users do not need to do this operation in using.
2) One Mini Controller can be connected by five pcs of Wireless Keypad and Exit Button maximum.
To pair the Wireless Keypad and Mini Controller:
Wireless Keypad: * Master Code # 9 0 #
Mini Controller: Remove the back cover, and press the button “Pair”
If pair successfully, there will be one beep from both the controller and the keypad, you can add the keypad continuously
If not, there will be three short beeps, then please repeat the setting.
The keypad does not need to be entered * for exit in this step.
Reset to Factory Default
Open the back cover of the wireless keypad, press the button “RST” on the main board, hold it for 5 seconds, release it
until hear a long beep, means reset to factory default successfully.
After that, all settings except the relay time will be back to factory defaults, the users’ information will still be retained.
At the meanwhile, please pair the wireless keypad and wireless exit button with the mini controller again.
Low Battery Reminding
With 3 pieces 3A (AAA) battery, the wireless keypad can work continuously for at least 1 year, basing 30 times
PIN/card input a day.
If low battery of the wireless keypad, there will be 3 beeps when every key is pressed, and the LED will stay in Orange,
then please replace the batteries within one week.
