Vision MARK-1 Manuel utilisateur
USER GUIDE
Overview.........................................................4
Getting Started with the Vision MARK-1.....7
1. Charge the Device................................7
2. Turn ON the Device..............................7
3. Unlocking the Screen...........................8
4. Connect to Wi-Fi....................................9
5. Sign in to the Organization
Portal with Insitucloud Account........11
6. Install a Materials App.......................12
7. Ready to Make Measurements.........13
Getting to Know Your Device......................14
1. Status Bar and Navigation Bar.........14
2. Basic Gestures....................................15
3. Turn OFF or RESTART the Device.....15
4. Plugging in an Insight Module..........15
Using Apps.....................................................16
1. Finding Apps.......................................16
2. Switch Between Recently Used
Apps.....................................................17
3. Close Apps..........................................17
4. Adding an App to the Home
Screen..................................................19
5. Move or Remove Home Screen
Apps.....................................................20
Change Your Settings...................................21
1. Quick Settings.....................................21
2. Change the Brightness......................22
3. Battery.................................................22
4. Change the Volume............................24
5. Additional Settings.............................24
Safety Precautions.......................................25
Regulatory Notices.......................................28
Contents
4
The Vision MARK-1 performs rapid
materials assessments on location
and during materials use which
allows for better control, helps
to prevent materials defects,
and improves overall quality in a
manufacturing process.
Note: In order to make materials measurement on the
device, the Vision MARK-1 needs a specic Insight module
and materials probe that correspond to the
materials being measured.
Overview
5
The Vision MARK-1 performs rapid
materials assessments on location
and during materials use which
allows for better control, helps
to prevent materials defects,
and improves overall quality in a
manufacturing process.
Note: In order to make materials measurement on the
device, the Vision MARK-1 needs a specic Insight module
and materials probe that correspond to the
materials being measured.
Front
Charging
Port
LED Status
Indicator
(RYG)
Power
Button
Volume
Control
Insight
Port
6
Back
Humidity
Sensor
Lanyard
Straps
7
1. Charge the Device
Before using the Vision MARK-1, plug in the
power cord and fully charge it.
2. Turn ON the Device
To turn ON the Vision MARK-1, press and hold
the power button for a few seconds and you
will see the Insituware logo appear on the
screen.
Getting Started with the
Vision MARK-1
8
3. Unlock the Screen
To unlock the screen, swipe your nger up
from the bottom of the screen.
To lock the screen, press the power button
once.
9
4. Connect to Wi-Fi
From the Home screen tap the Settings app.
Tap Network & Internet.
10
Toggle the button to turn Wi-Fi on, then
select a listed network.
Enter the network password (if applicable) to
nish connecting to Wi-Fi.
Table des matières
Autres manuels Vision Instrument de mesure
Manuels Instrument de mesure populaires d'autres marques
Endress+Hauser
Endress+Hauser Proline Promag 50 Caractéristiques techniques
Siemens
Siemens SITRANS F Coriolis FCT030 Manuel de la liste des pièces
KLINGER
KLINGER CMF V Series Manuel utilisateur
EXFO
EXFO FTB-2 Manuel d'exploitation et d'entretien
Keysight
Keysight M8290A Manuel utilisateur
ADTEK
ADTEK MW-5 Manuel utilisateur