Advanced Rear View Camera User Manual
CAUTION
Before installing the Rear View Camera, please ensure that you read and
understand the User Guide.
- The normal operating power source for this device is DC12V.
(Operating Voltage is DC5V to DC15V)
- Please ensure that the power is off when installing.
- The camera has been waterproofed. Do not open, damage, alter or place heavy
items on the power cord.
Any of these actions may cause an electrical short circuit, which may lead to fire
or electrical shock.
- There is a distance difference between an actual camera and the monitor,
so please give attention to user after installation.
- Do not wipe out or scratch by using sharp things, it may cause a blur the image
(faulty image. In this case, we could not offer a warrant service)
- Use only the recommended power accessories. Use of power sources not expressly
recommended for this equipment may lead to overheating, distortion of the
equipment, fire, electrical shock or other hazards.
2. Installation & Connections
System Configuration Diagram
1) Select a position for the camera installation on rear of the vehicle.
(Rear garnish or side of number plate lamp)
2) Please make a space to put the cable harness inside the trunk after
installing the camera.
3) Like picture above, please connect the extension cables to the camera
cables.
4) Connect RED wire to +DC12V power cable of the rear lamp,
and connect BLACK wire to the body of vehicle or GND of the lamp.
5) Connect RCA cable to video input port of the monitor.
6) Connect the Extension Cables with the View Mode Controller.
※Rear lamp will be turned on when changing ‘R’ gears and the Rear View
Camera is going to be operating at the same time.
The camera images will be displayed with the monitor.
Made In Korea
1. Package Contents
