ViewZ VZ-42D2iP Manuel utilisateur

42-INCH D2iP

IP OUTPUT MONITOR

USER MANUAL

Please read this manual thoroughly before use, and keep it handy for future reference.

SAFETY INSTRUCTION ………………………………………………………….……

2 ~ 3

CAUTIONS ……………………………………………………………..........................

FCC RF INTERFERENCE STATEMENT …………………………….......................

CONNECTING WITH EXTERNAL EQUIPMENT ……………………………………

CONTROLS AND FUNCTIONS ………………………………………………………..

7 ~ 10

MOUNTING GUIDE ……………………………………………………………………..

POWER MANAGEMENT ………………………………………………………………

SPECIFICATION ………………………………………………………………………

TROUBLE SHOOTING GUIDE ………………………………………………….........

- 1 -

This Monitor was

Manufactured by ISO 9001

Certified Factory

Important Safety Instruction

1. Read these instructions.

2. Keep these Instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s

instructions.

8. Do not install near any heat sources such as radiators, heat registers,stoves, or other

apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug.

Apolarized plug has two blades with one wider than the other.

Agrounding type plug has two blades and a third grounding prong.

The wide blade or the third prong are provided for your safety.

If the provided plug does not fit into your outlet, consult an electrician for replacement

of the bsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,

convenience receptacles and the point where they exit from the apparatus.

11. Only use attachment/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or

sold with the apparatus. When a cart is used, use caution when moving

the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused

for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus

has been damaged in any way, such as power-supply cord or plug is damaged, liquid has

been spilled or objects have fallen into the apparatus the apparatus has been exposed to

rain or moisture does not operate normally or has been dropped.

- 2 -

- The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,

such as vases, shall be placed no the apparatus.

14 Minimum distances(e.g. 10cm) around the apparatus for sufficient ventilation.

“WARNING – To reduce the risk of fire or electric shock, do not expose the apparatus to rain or moisture.”

“The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids,

such as vases, shall be placed on the apparatus.”

This symbol is intended to alert the user to the presence of uninsulated:

dangerous voltage with in the product’s enclosure that may be of sufficient

magnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating

and maintenance(servicing) instructions in the literature accompanying the

appliance.

- 3 -

CAUTION

The power supply cord is used as the main disconnect device, ensure that the socket-outlet is

located/installed near the equipment and is easily accessible.

ATTENTIONN

Le cordon d`alimentation est utillsé comme interrupteur général. La prise de courant doit être

située ou installée à proximité du matériel et être facile d`accès

▶NEVER REMOVE THE BACK COVER

Removal of the back cover should be carried out only by qualified personnel.

▶DO NOT USE IN HOSTILE ENVIRONMENTS

To prevent shock or fire hazard, do not expose the unit to rain or moisture.

This unit is designed to be used in the office or home. Do not subject the unit to vibrations,

dust of corrosive gases.

▶KEEP IN A WELL VENTILATED PLACE

Ventilation holes are provided on the cabinet to prevent the temperature from rising.

Do not cover the unit or place anything on the top of unit.

▶AVOID HEAT

Avoid placing the unit in direct sunshine or near a heating appliance.

▶TO ELIMINATE EYE FATIGUE

Do not use the unit against a bright back ground and where sunlight or other light sources will

shine directly on the monitor.

▶BE CAREFUL OF HEAVY OBJECT

Neither the monitor itself nor any other heavy object should rest on the power cord.

Damage to a power cord can cause fire or electrical shock.

- 4 -

NOTE

This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television reception which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio, TV technician for help.

- Only shielded interface cable should be used.

Finally, any changes or modifications to the equipment by the user not expressly approved by

the grantee or manufacturer could void the users authority to operate such equipment.

▶DOC COMPLIANCE NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital

apparatus set out in the radio interference regulation of Canadian Department of

communications.

- 5 -

Rear Connection

1. DC 12V OUT

2. UPGRADE SELECT S/W

3. UPGRADE 1

4. RJ45

5. UPGRADE 2

6. IP RESET

7. HDMI IN

8. AC IN

- 6 -

FRONT KEY CONTROL

1. SOURCE/SELECT

Selects an input source.

Enters a submenu or accepts your selection in the OSD menu.(OSD menu works with HDMI

only.)

2. MENU/EXIT

Activates or exits the OSD.

Moves previous menu or status in the OSD.

3 / 4. ▼/ ▲

Moves another option in the OSD.

5 / 6. ◀/ ▶

Adjust the volume or menu settings.

The first production goods do not have the speaker and stereo out, so this function does not

work.

7. POWER ON/OFF( / I )

Turns the power ON or OFF. There will be a few seconds delay before the display appears.

8. POWER LED

Turned on: Blue color.

Turned off: LED off

- 7 -

OSD Menu Description

All picture, sound settings and setup for the monitor can be adjusted in the OSD menu.

(On Screen Display)

To adjust the OSD screen:

1. Press the Menu button to enter the OSD menu.

2. Press the ▲/▼ buttons to select the desired option. The selected option is highlighted.

3. Press the ▶button to enter the submenu for adjusting items.

4. Change the value you wish to adjust by using the ▲/▼ buttons.

5. Press the ◀button to exit the submenu for adjusting items.

6. Press the Menu button to exit the OSD menu.

A. PICTURE

Submenu

Definition

Brightness

Adjusts the brightness level for video performance (range 0-100).

Contrast

Adjusts the intensity of the image (range 0-100).

Color Temp

Adjusts the color of the picture Choices are Warm, Normal, Cool, and User

(Red , Green, and Blue).

Zoom

Sets the aspect ration for the monitor. Choices are 16:9 and 4:3.

- 8 -

Table des matières

Autres manuels ViewZ Moniteur

ViewZ

ViewZ VZ-173PM-HDR Mode d'emploi

ViewZ

ViewZ Smart AD PVM Series Guide de l'utilisateur

ViewZ

ViewZ VZ-HD-PVM N Series Manuel utilisateur

ViewZ

ViewZ 215LEDSN Manuel utilisateur

ViewZ

ViewZ VZ-215LED-E Manuel utilisateur

ViewZ

ViewZ vz8rtc Manuel utilisateur

ViewZ

ViewZ 23-INCH WIDE TFT-LED CCTV MONITOR Manuel utilisateur

ViewZ

ViewZ VZ-IBX-T Series Manuel utilisateur

ViewZ

ViewZ 40" WUXGA Manuel utilisateur

ViewZ

ViewZ VZ-PVM-Z2B3N Manuel utilisateur

ViewZ

ViewZ VZ-IP-PVMN Series Manuel utilisateur

ViewZ

ViewZ VZ-19CME Manuel utilisateur

ViewZ

ViewZ TIM Series Manuel utilisateur

ViewZ

ViewZ VZ-43UHD Manuel utilisateur

ViewZ

ViewZ VZ-IP-PVMN Series Manuel utilisateur

ViewZ

ViewZ VZ-CGM Series Manuel utilisateur

ViewZ

ViewZ VZ-49ENB Manuel utilisateur

ViewZ

ViewZ 9.7-INCH TFT-LED Manuel utilisateur

ViewZ

ViewZ TIM Series Manuel utilisateur

ViewZ

ViewZ VZ56SM Manuel utilisateur

ViewZ

ViewZ 17-INCH PREMIUM Manuel utilisateur

ViewZ

ViewZ SMART AD PVM Series Manuel utilisateur

ViewZ

ViewZ VZ-IBX-T Series Manuel utilisateur

ViewZ

ViewZ VZ-185RCR Manuel utilisateur

Manuels Moniteur populaires d'autres marques

Linear Acoustic

Linear Acoustic LQ-1000 Manuel utilisateur

AOC

AOC I2579V Manuel utilisateur

Gateway

Gateway FPD1520 Manuel utilisateur

Furuno

Furuno Mu 120c Manuel utilisateur

Asus

Asus VB171D - 17" LCD Monitor Manuel utilisateur

Dell

Dell S2230MX Instructions d'utilisation

Philips

Philips 107C64 Manuel utilisateur

Dell

Dell S2409WFP Manuel utilisateur

EverFocus

EverFocus EN-7517E Manuel utilisateur

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manuel utilisateur

Dell

Dell Precision 7680 Mode d’emploi

LG 50PM1M - - 50" Plasma Panel Manuel utilisateur

Bosch

Bosch DDU 9 Manuel utilisateur

Acer

Acer A231HL Manuel utilisateur

Philips

Philips 86BDL4152T Manuel utilisateur

NEC

NEC AccuSync LCD5V Manuel utilisateur

Emay

Emay SleepO2 Manuel utilisateur

IBM

IBM 6360 Instructions d'installation