Viessmann VITOCROSSAL 300 Manuel utilisateur

Installation Instructions

Assembly of Boiler Sections, Part No. 7134 271

for Vertomat VSB-17 to -89

and Vitocrossal 300, CT3-17 to -89 boilers

5285 410 v1.1 11/2007

Safety and Installation Requirements

Please ensure that these instructions are read and understood before commencing installation. Failure to comply with the

instructions listed below can cause product/property damage,severe personal injury, and/or loss of life.

Working on the equipment

The installation, adjustment, service,

and maintenance of this product must

be done by a licensed professional

heating contractor who is qualified and

experienced in the installation, service,

and maintenance of hot water boilers.

There are no user serviceable parts on

the boiler, burner, or control.

Ensure main power supply to

equipment, the heating system, and all

external controls has been deactivated.

Close main gas supply valve. Take

precautions in all instances to avoid

accidental activation of power during

service work.

Ensure that the installation

literature of other components

is referenced.

Assembly Instructions

Never put any tools, bolts or any other

parts inside the combustion chamber.

1. Clean combustion chamber surfaces

with stainless steel wire brush

5”/127 mm from the edges.

Do not use solvents. Use only clean

towels and/or rags.

2. Apply supplied tape on the edge

of the front cone section as

illustrated, and finish with 3”/76 mm

loop tabs.

3. Apply supplied tape 3/8“/10 mm

from edge of main boiler section as

illustrated, and finish with 3”/76 mm

loop tabs.

4. Apply generous amount of supplied

Dirko silicone evenly between the

combustion chamber edge and the

steel ring welded to the front

section .

Do not discard empty tubes! Empty

tubes are used for removal of excess

silicone. See next step.

Please file in Service Binder

Fig. 1

Assembly of combustion chamber

IMPORTANT

Fig. 2

Assembled combustion chamber shown

Viessmann Manufacturing Company Inc.

750 McMurray Road

Waterloo, Ontario •N2V 2G5 •Canada

Tel. (519) 885-6300 •Fax (519) 885-0887

www.viessmann.ca •[email protected]

Viessmann Manufacturing Company (U.S.) Inc.

45 Access Road

Warwick, Rhode Island •02886 •USA

Tel. (401) 732-0667 •Fax (401) 732-0590

www.viessmann-us.com •[email protected]

Assembly Instructions (continued)

5. Join front cone section with main

boiler section and ensure that a

gasket has been placed between the

water connection flanges. Tighten all

four bolts around the boiler section

and the flanges. Scrape off

excess silicone from the inside of the

combustion chamber with end of the

empty silicone tube.

6. Using a disposable latex glove (with

liquid soap or hand moisturizer), or

plastic trowel, and smooth silicone

strip on the inside of the combustion

chamber.

7. Remove tape (after approx. 4 hours)

by carefully pulling out tabs from the

combustion chamber.

Wash hands when finished.

Ensure that there are no gaps in the

silicone seal along the joint of the

two sections.

8. Install gaskets on common boiler

supply header and tighten flanges

with the nuts and bolts provided.

Front cone section

Main boiler section

Printed on environmentally friendly

(recycled and recyclable) paper.

5285 410 v1.1 Technical information subject to change without notice. Printed on environmentally friendly

(recycled and recyclable) paper.

Autres manuels pour VITOCROSSAL 300

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Viessmann Chaudière

Viessmann

Viessmann VITOROND 100 VR1 Series Manuel d'instructions

Viessmann

Viessmann Vitodens 100-W Guide rapide

Viessmann

Viessmann VITOCROSSAL 200 Manuel utilisateur

Viessmann

Viessmann VITOLADENS333-F Mode d'emploi

Viessmann

Viessmann Vitodens 200-W System Mode d'emploi

Viessmann

Viessmann Vitodens 200-W System Manuel utilisateur

Viessmann

Viessmann Vitodens 200 WB2 11-44 Manuel utilisateur

Viessmann

Viessmann Vitodens 100-W B1HF Series Guide rapide

Viessmann

Viessmann Vitodens 100-W Guide de démarrage rapide

Viessmann

Viessmann VITODENS Manuel utilisateur

Viessmann

Viessmann Vitoflex 300-RF Series Guide d'installation et d'utilisation

Viessmann

Viessmann KOB PYROT KRT SERIES Manuel d'instructions

Viessmann

Viessmann Vitocrossal Manuel utilisateur

Viessmann

Viessmann Vitocrossal 200 CM2 500 Mode d'emploi

Viessmann

Viessmann VITODENS 050-W Manuel utilisateur

Viessmann

Viessmann Vitoflex 300-RF 150 Guide d'installation et d'utilisation

Viessmann

Viessmann Vitodens 100-W Guide rapide

Viessmann

Viessmann VITOCONTROL-S, WB2B Manuel utilisateur

Viessmann

Viessmann Vitodens 200-W System Guide rapide

Viessmann

Viessmann VITOLIGNO 300-P Mode d'emploi

Viessmann

Viessmann Vitodens 111-W Guide de démarrage rapide

Viessmann

Viessmann Vitodens 200-W System Manuel utilisateur

Viessmann

Viessmann VITOPLEX 300 Mode d'emploi

Viessmann

Viessmann Vitodens 200-W System Guide de démarrage rapide

Manuels Chaudière populaires d'autres marques

Vaillant

Vaillant uniSTOR VIH SW GB 500 BES Manuel utilisateur

Radijator

Radijator BIO max 23.1 Manuel utilisateur

Brunner

Brunner BSV 20 Manuel utilisateur

Buderus

Buderus Logamax GB062-24 KDE H V2 Manuel utilisateur

Potterton

Potterton 50e Fiche technique

UTICA BOILERS

UTICA BOILERS TriFire Manuel utilisateur

Joannes

Joannes LADY Series Manuel

ECR International

ECR International UB90-125 Manuel d'instructions

Froling

Froling FHG Turbo 3000 Manuel utilisateur

Froling

Froling P4 Pellet 8 - 105 Manuel utilisateur

U.S. Boiler Company

U.S. Boiler Company K2 Manuel utilisateur

Henrad

Henrad C95 FF Manuel utilisateur

NeOvo

NeOvo EcoNox EF 36 Manuel utilisateur

Potterton

Potterton PROMAX SL 12 Manuel utilisateur

Eco Hometec

Eco Hometec EC 25 COMPACT Manuel utilisateur

Baxi

Baxi Prime 1.24 Manuel utilisateur

REXNOVA

REXNOVA ISA 20 BITHERMAL Manuel utilisateur

Radiant

Radiant R2K 55 Manuel