TS631 INSTRUCTION MANUAL
Step-by-Step Directions for programming TS631 Time Switch
Power On - Time Switch goes into time mode displaying Microsound TS631, the current day and time.
When programming is finished, the time switch must be in this mode.
To ring the bell manually, press B while in this mode
D Changes to the next mode
# Changes back to the last mode
A. To set the alarm time (when the bell/siren must be triggered)
1. Press D once to go into “Enter new alarm” mode.
2. Press
*
once to start programming the alarm times
3. Press: 1 for Monday / 2 for Tuesday / 3 for Wednesday /
4 for Thursday / 5 for Friday / 6 for Saturday / 7 for Sunday,
the cursor will then jump over to the zeros.
4. Enter time in 24 hour format hours 00: minutes :00: seconds :00
Note: Seconds must always be 00
E.g. 0 7 :4 5 :0 0 or 1 2 :0 0 :0 0 .
5. Press A to accept your new alarm. To clear an alarm time, press C .
6. Display will again show: Mon 00:00:00
7. Continue entering your alarms. When finished press D or # .
B. To view the alarms that have been programmed
1. Press
*
to view the times that have been programmed.
2. Press B to move forward to the next time. This can be done until the display shows “No more Alarms”.
To move back through alarms press A .
3. To delete only a selected alarm, press C while the alarm is shown on the display. The display will show
the next alarm.
4. Press # to go back to the time mode or D to go to the next mode
TS631 30 September 2009 Page 2 of 4
