Vicovation Vico-Marcus 5 Dual Manuel utilisateur
Vico-Marcus 5 Dual
Quick Guide
DUAL
Index
English 02
Deutsch 19
Русский 37
中文 55
English
02
Vico-Marcus 3 Outlook Introduction:
Thank you for choosing Vico-Marcus 5 Dual Full HD Car
Camcorder. Please follow the installation guide for more detail
when using Vico-Marcus 3, and notice our highlight parts as
important reminders.
Vico-Marcus 5 Dual Installation Guide
Vico-Marcus 5 Dual Standard accessories:
Installation guide
Warranty card
1. Power button
2. Down / Mute (Switch front/rear display)
3. Up / MENU
4. Start/Stop record/Confirm
5. Emergency Record / Return
6. Micro SD card slot
7. USB / Power socket
8. HDMI output
9. External GPS socket
10. Speaker
11. Full HD cable slot
12. 2.0” TFT LCD Display
13. LED indicator
(Red=Recording, Green=Stand by, Red Flashing=No SD
Card)
14. Bracket socket
15. Mega Pixel Lens
Device
Rear camera
Rear Camera
Bracket
Suction Bracket
Cigar Car Charger
3M Sticker
Bracket
Full HD Cable
Quick Mounting
Bracket
English
03
Quick Mounting Bracket Installation
CPL filter
Mounting Bracket
1.
2.
3.
There’s one quick mounting bracket in Marcus 5 Box.
Please check the following steps to reconnect quick mounting
bracket with suction bracket.
Please loosening the cap nut on
Ball Head of Suction bracket
first, and pull out T-type ball
head.
Insert Quick mounting back into
notches. Please notice the cap nut
needs to be placed on ball head
firstly. And properly fasten the cap
nut after you put on Marcus 5.
CPL filter is optional accessory, not including in box. Users
can choose Marcus CPL filter or any 52mm standard CPL
filter.
CPL filter will lower a little bit brightness of image. Please
adjust it especially for night-time record. You can 1. Adjust
CPL angle. 2. Set EV value. 3. Or you may Disassemble
CPL filter at night.
Please notice that CPL filter is NOT recommended if your
car has film on the windshield.
English
04
Type A: Marcus 5 + Standard Suction Bracket
Vico-Marcus 5 equipped with Quick mounting bracket
module, you may switch it into Suction bracket or Sticker
bracket. We listed 2 ways of installation below with Suction
bracket integrated type.
Suction Bracket & Quick Mounting
Bracket Installation
Please notice
that the direction
of Suction
handle faces
forward the
windshield.
Special Notice:
If there is a safety airbag inside the front pillar, please ask for professional
assistance. Try not to embed the cable on your own.
The cable, connecting front and rear cameras, is special designed (Full HD
Cable). Please make sure not bend the cable too hard when embedding it.
Please restore the Weatherstrip after embedding the cable.
Please apply original VicoVation Vico-Marcus 5 Dual car charger to avoid
unstable behaviors of the device.
Marcus 5 Dual special car charger is NOT compatible with other Vico products.
1.
2.
3.
4.
First Time Installation
English
05
DIY Installation and wiring
Best Area
How to embed the cable easily (DIY):
Type 1 : (Dotted line)
Starting from front camera, extend the cable along the top of Sunvisor on
passenger seat. Enter the Headlining and extend toward the back side to
connect rear camera.
Type2: (Solid Line)
Starting from front camera, extend the cable along the top of sunvisor on
passenger seat and going down to floor along with the front pillar. Then
extend to back side connecting with rear camera.
English
06
First Time Operation
1.
2.
1.
2.
3.
4.
5.
6.
Insert Micro SD card firstly.
(Please aware the direction of
Micro SD card data pins.)
SD card under Class10 is
forbidden.
After power on, device will boot up and enter into recording
mode. The initial 3-second recording period is protected from
stopping. To enter MENU is not limited by these 3 seconds.
Please setup system time and format Micro SD card manually
for the first time operation.
To remove Micro SD card, please stop recording or power off
firstly to protect recording data.
Please use Micro SD card (SDHC/SDXC) with level Class10
only.
Normal Recording Time Table
(Not including 6 sets (12 Videos) Emergency
Record)
Marcus 5 uses standard Micro SD card slot format.
Marcus 5 becomes card reader (Slave device) in connection
with PC by USB cable. To operate Marcus 5, please connect
it with cigar car charger or USB power adaptor.
Micro SD
8GB
16GB
32GB
64GB
Video Bit Rate
1296p 30fps
60 mins
120 mins
250 mins
520 mins
16Mb/s
1080p 60fps
60 mins
120 mins
250 mins
520 mins
16Mb/s
1080p 30fps
75 mins
166 mins
347 mins
710 mins
12Mb/s
720p 60fps
100 mins
215 mins
445 mins
910 mins
9Mb/s
720p 30fps
180 mins
375 mins
765 mins
1545 mins
6Mb/s
English
07
1.Video settings
2.Function Settings
3.Display settings
4.Audio settings
5.Playback settings
6.System settings.
Main Display
Recording mode
1.
2.
Under normal recording, icons represent
(From upper left side):
Red dot recording sign/ Current Time/
Recording Size/ G-Sensor function sign/
Emergency Recording Numbers.
Icons in bottom side:
Emergency record/ Recording sign/
Menu/ Voice recording/ mute switch/
Switch front/rear display
Power ON/Off
User Interface
5/10
5/10
English
08
Setting Detail
1.
2.
3.
Set video resolution and EV value. 1080p 30fps is recommended.
Setup sensibility of G-Sensor (Default setting is OFF).
G-Sensor Settings
GPS Settings
Video Settings
GPS relative function can be only activated while GPS
installed correctly.
After booting, GPS function will be activated after GPS
signal received.
After successful GPS positioning, a Blue Arrow will pop out
at the top of display to confirm GPS features are activated.
To activate this function, please install Marcus GPS Mouse
(Optional) and plug the GPS socket properly.
5/10
English
09
Setting Detail
(optional Marcus GPS mouse)
LDWS (Lane Departure Warning System)
When current speed reach your setting
value (For example: 60km/h), Marcus 5
will notify drivers with Beep sound and
alert Icon while lane departure.
When current speed over 60km/h,
Marcus 5 will notify drivers with Beep
sounds and alert Icon if distance
between car in front reaches 5~7
meters.
FCWS (Forward Collision Warning System)
Marcus 5 has to be calibrated
to improve the accuracy for
LDWS/FCWS activation.
After set LDWS/FCWS ON,
baseline will show up on
monitor when back to
Recording Mode. Please align
the Red line with horizon.
Baseline will vanish after 30
seconds.
Calibration
5/10
Table des matières
Autres manuels Vicovation Caméra embarquée
Vicovation
Vicovation Vico-Opia2 Manuel utilisateur
Vicovation
Vicovation Vico-WF1 Manuel utilisateur
Vicovation
Vicovation Vico-DS2 Manuel utilisateur
Vicovation
Vicovation Vico-Marcus 3 Manuel utilisateur
Vicovation
Vicovation Marcus 4 Manuel
Vicovation
Vicovation Vico-Marcus 4 Manuel
Vicovation
Vicovation Marcus 2 Manuel utilisateur
Vicovation
Vicovation VICO-MF3 Manuel utilisateur
Vicovation
Vicovation Vico-WF1 Manuel utilisateur
Vicovation
Vicovation Vico-Marcus 3 Manuel technique
