Veto 8996 Manuel utilisateur

Model: 8996

MINI POCKET

THERMO-ANEMOMETER

WITH COMPASS

OPERATION MANUAL

INTRODUCTION

FEATURES

Congratulations on your purchase of this

unique Thermo-Anemometer, the meter

features in measuring Air Velocity, Temp.,

Relative Humidity with Dew Point, Wet-

Bulb Temperature, and compass

function.

Simple and easy to operate, 6 wind units

selectable.

A pocket-knife design makes it convenient

and portable, easy to use and to get a

precision reading.

Read thoroughly before using the meter,

the unit was calibrated before shipment.

There are several models of mini anemo-

meter and weather meter available,

please contact with your store for more

detail information.

Windspeed : displays real time

windspeed

Max. Windspeed : display the Max.

windspeed

Avg. Windspeed: display 10-sec

average windspeed

Compass

Temperature

Windchill

Humidity(sensor is pre-calibrated)

Wet Bulb Temp.

Dew Point Temp.

Delta Temperature

RANGE / RESOLUTION

Meter per second

Feet per minute

Knot

Kilometer per hour

Mile per hour

Beaufort

Relative Humidity

Dew Point

Centigrade

Fahrenheit

1.1~20.0

60~3937

0.4~38.8

0.8~72.0

0.5~44.7

0.1~99.9

-20~50

-15~50

-5~122

1~8

0.1

Range

Unit

MPS

FPM

KNT

KPH

MPH

RH%

"RS" stands for Resolution.

This package contains:

The meter x 1

Battery x 1 CR 2032

Operation manual

Strap

Paper box

MATERIAL SUPPLIED

WBT

WCI

Windchill

Wet Bulb Temp.

-5~50

-20~50

0.1

8.8.8.8

---

--- ---

---

------ ---

Detended at 180 for fully opened.

Detended at 90 for tripod

mountable.

8.8.8.8

1.8.8.8

ON/OFF

HOLD

UNITS

MODE

POWER SUPPLY

The meter is powered by 1 pc CR 2032

Lithium battery. To check the battery

when:

1. First time use

2. The low battery symbol appears on LCD

3. The meter can not power on

To install the battery:

1. Turn off the meter.

2. Turn the battery compartment cover in

a CLOCKWISE direction to remove it.

3. Replace the old battery

with one new CR 2032

lithium battery

4. Make sure the battery is

in place and the polarity is correct.

5. Affix the battery compartment cover by

turning it in a COUNTER-CLOCKWISE

direction.

BAT

2032

OPEN

NOTE:

1. Dispose the lithium battery in

accordance with local / state / or

national waste disposal codes.

2. Remove battery from instruments

that you do not plan to use for a

month or more. Do not leave

battery in instrument.

1. Vane impeller

2. Wind direction indicator

3. LCD display

4. ON/OFF and MODE key

5. UNITS key

6. Battery compartment(on rear)

7. Swivel handle and storage case

8. Lanyard holder

9. Precision thermistor & Humidity

sensor

10. Tripod mount ( on the bottom)

1 01 0

FULL DISPLAY:

Though you have seen CI(Comfort Index)

in below drawing, it is not available for this

model 8996.

MPHKPHFPMMPSBFKNT

MAX AV WBT DPWCIG

T CI

ead

Tail

ross

POWER ON / OFF

To monitor the air velocity measurement,

always position the meter to the air

source from the rear of the meter .i.e. the

display face to the user .

Press the “ “ key to turn on the meter.

Auto power off in 5 minutes, or press

“ “

To disable the auto power off, before

power on, pressing key

until a “ n ”appeared on the screen and

then release keys to return to normal

mode.

key for 3 sec onds to turn the

power off.

“ “ + UNIT

SELECT MODE

Press mode key to change the mode. The

sequence is Current windspeed → Max.

Windspeed → 10 sec average wind-

speed → Compass → Temperature →

Windchill → Humidity → Wet Bulb →

Dew Point → Delta T

→

→ → →

→

POWER ON / OFF

Delta T means the difference between the

ambient air temperature and the dew point

temperature.

SELECT UNIT

UNIT

To switch temperature unit, press

key under temperature mode.

To switch windspeed unit, press

key under windspeed mode.

WIND DIRECTION / COMPASS

Turn on the meter, press mode key to

select and enter into Compass mode.

Point the meter in the direction of travel or

target and get a steady compass reading.

Press and hold UNIT key until

“Headtailcross” appear on LCD, com-

pass reading will then flash three times.

Release UNIT key and point the meter

into the wind until you have a steady

compass reading. Press and hold UNIT

key until “Compass reading” start

flashing.

It flashes three times, and the wind meter

will then display head or tail wind.

Press UNIT key to see the crosswind.

To exit, press MODE key.

To calibrate the compass, under com-

pass mode, press MODE + UNIT key

until 30 seconds countdown appears

on LCD.

Rotate the meter twice slowly according

to the direction as below drawing, each

turn takes 15 seconds.

COMPASS CALIBRATION

After 2 turns (30 seconds), the LCD

show ”End” to indicate the calibration

is completed.

NOTE:

1. Calibrate the compass after a new

battery is installed.

2. To get an accurate compass reading,

it is suggested to run this simple

calibration procedure before use.

UNITS CONVERSION TABLE

1 KPH

0.6222

0.54

54.69

0.2778

1.6071

0.8679

87.89

0.4464

MPH

KPH

KNT

FPM

MPS

1 FPM

0.00508

0.01138

0.01829

0.00987

1 MPS

196.87

1.944

3.6

2.24

1 KNT

1.1523

1.8519

101.27

0.5144

To replace the impeller, use a small

screwdriver to loosen the set-screw

found on the back of the windmeter.

Then remove the impeller by twisting the

impeller assembly clockwise (if you are

facing the back of the windmeter) to the

"O" position marked on the rear of the

rear of the meter.

Install a new impeller by following these

instructions in reverse.

VANE REPLACEMENT

NOTE: The anemometer is very accurate

at low and mid-range air speeds.

Constant use at very high speeds, such

as measurements out a fast-moving car

window may damage the impeller's

bearing and reduce over-all accuracy.

1 MPH

 L

 



 

  º

  °

  º

 

 

 ± °



  

 

 

 º

 º

 º

 

 

 

 º

 

 º

 

 º 

° 

 

 

 Meter/ Battery /Manual/



Autres manuels Veto Thermomètre

Veto

Veto 880D Manuel utilisateur

Manuels Thermomètre populaires d'autres marques

Delton

Delton 981A Manuel utilisateur

Baker

Baker MM2P Manuel utilisateur

Tarmo

Tarmo 320281 Manuel utilisateur

Citizen

Citizen CTD 504 Manuel utilisateur

TFA

TFA 14.1500 Manuel utilisateur

Vive

Vive DMD1010 Manuel utilisateur

Gotemp

Gotemp THB4002 Manuel utilisateur

GREISINGER

GREISINGER G 1202 Manuel utilisateur

Amprobe

Amprobe TMD-53W Manuel utilisateur

Trotec

Trotec BP10 Manuel utilisateur

Radiance instruments

Radiance instruments RT616 Series Manuel utilisateur

Eurolec

Eurolec IR151 Manuel utilisateur

Scaneo

Scaneo TS42B Manuel utilisateur

Sper scientific

Sper scientific 800043 Manuel utilisateur

Microlife

Microlife NC 200 Mode d’emploi

Motorola

Motorola MBP69SN Guide de configuration

The MeatStick

The MeatStick The MeatStick Manuel utilisateur

Hama

Hama TH35-A Manuel utilisateur