Live chat: Info.legendbrands.com
15180 Josh Wilson Road
Burlington, WA 98233
800-932-3030
CleanerLivingProducts.com
For detailed instructions and product information,
download the manual under “Documents”
at VDC.cleanerlivingproducts.com
TECHNICAL SUPPORT AND SERVICE
Item: 108007 124005 C
MAINTENANCE
DAILY OR AFTER EACH USE
AS NEEDED
» Wipe exterior surfaces with a damp cloth. To restore exterior shine, use an automotive vinyl
cleaner/protectant product.
Before servicing, turn off all controls, then unplug machine.
Empty/rell tanks
1. Empty recovery tank.
Switch off blower and heater. With the
vacuum hose still attached to the unit,
lift the vacuum hose above the height of
the vacuum intake to drain any water in
the hose into the recovery tank.
Remove vacuum hose from
recovery tank. Turn the tank
release twist latch and slide the
recovery tank forward and up.
Keep the vacuum inlet tipped
upward to avoid drips from the
vacuum intake. While holding the
tank upright, unscrew tank cap.
Carefully pour into a
suitable drain, such as
a toilet or utility sink.
2. Rell solution tank (as shown on
previous page) whenever you empty
the recovery tank or when you notice
that solution is no longer owing from
the spray nozzle.
3. Resume cleaning.
» Press accessory tool control lever to release water pressure, then disconnect vacuum hose.
» Rinse solution tank.
» Clean strainer cup and oat ring. Remove deck plate cover, lift out parts shown and rinse clean.
» Rinse recovery tank.
» Reassemble unit and turn on blower motor ONLY. (DO NOT turn on heater.) Allow blower to
run for 2 minutes. This helps to remove any remaining moisture from the blower.
» Coil power cord and secure with strap.
When the cleaning solution is used up: 1) empty the recovery tank and 2) rell the solution tank.
NOTICE: Follow all instructions to avoid damaging machine and
voiding warranty.
• Use only manufacturer’s recommended cleaning solutions and accessory tools.
• Add defoamer to recovery tank in case of excessive foaming.
• Keep cord away from heated surfaces.
• To unplug, grasp the plug, not the cord. Do not pull cord to unplug.
• Protect from freezing to avoid damage to internal components.
• Do not immerse end of vacuum hose in liquid.
• Do not use as a dry vacuum.
• To prevent growth of mold and mildew inside tanks, always drain recovery
tank after use.
• Do not modify machine from its original design.
Read and understand manual before operating.
