CAMIP5 Rev.01
27.10.2010 ©Velleman nv
4
11.1 +5V DC output 11.3 alarm input
11.2 output (GND) 11.4 input (GND)
6. Hardware installation and operation
•Choose a location for the camera, keeping following guidelines in mind:
•Do not install the camera in locations where extremely high or low temperatures or excessive
vibrations may occur.
•Avoid mounting the camera near high electro-magnetic fields.
•Do not aim the camera at the sun or other extremely bright objects.
•The camera can be used free standing or in combination with the included mounting bracket. When
the mounting bracket is used, attach it to the wall or ceiling using the 2 included screws. Place the
CAMIP5 on top and secure it with the centre screw. Determine the desired angle and tighten the
joint screws.
•Connect the antenna to the antenna connector [7] and/or connect a network cable (included) to the
RJ45 jack [9].
Note: it is possible to connect the camera straight to the RJ45 port of a computer. In this case a
crossed cable (not incl.) should be used and network settings must be configured manually.
•Use of the alarm connector:
•Connect an external alarm switch (e.g. a PIR sensor) to the alarm input [11.3] and the input
GND [11.4]. The CAMIP5 can be programmed to handle events triggered on this input,
•Connect an alarm output device (e.g. a buzzer) to the 5V DC output [11.1] and the output
(GND) [11.2]. In case an alarm condition exists, the output [11.1] will be high (5V DC).
Note: the output can also be enabled with the and buttons in the ‘for operator’ window (see
further).
•When desired, an external speaker system can be connected to the audio output [8].
•Plug the DC connector of the power adaptor into the 5VDC input jack [12]. Only use the included
adaptor or one with the same specifications.
•Plug the adaptor into a suitable mains outlet (100~240V AC/50~60Hz).
Notes:
•It takes about 30s for the camera to initialise.
•During initialisation the camera will start moving to test the pan/tilt functionality.
•When the image appears out of focus, turn the lens [3] to adjust.
7. Software installation
•Insert the included CD-ROM into a suitable computer system (not incl.).
System requirements: CPU ≥2.06 GHz / memory ≥256MB / network ≥10 MB / video card ≥
64MB memory / recommended OS: Windows 2000 or XP / Mac.
Windows
•Locate the software installer IPCamSetup.exe and double click it.
