Valcom V-2000A Manuel utilisateur
alcom -2000A Overhead Paging System Configuration
To configure a alcom -2000A overhead paging system, ensure that Battery Feed is off. Connect 8x8 adapter to the
Tip and Ring connectors. Learn more.
Objective
Configuring a alcom -2000A overhead paging system for 8x8 services.
Disclaimer: 8x8 is not Responsible for configuration or deployment of legacy 3rd party
Paging devices, please consult the Original Equipment Manufacturer for support. 8x8 X
Series does not support FXO 3rd party devices
Applies To
alcom -2000A overhead paging system (FXS Mode Only)
Procedure
1. Ensure that the Battery Feed is on.
◦ In the on position this sets this as Station and or Loop Start Trunk (FXS Mode)
2. Connect your 8x8 adapter to the the Tip and Ring as shown on the image below.
https://support.8x8.com/devices-accessories/overhead-paging/valcom-v-2000a-overhead-paging-system-configuration
Updated: Wed, 06 Dec 2023 12:43:23 GMT
Powered by
1
Autres manuels pour V-2000A
3
Table des matières
Autres manuels Valcom Contrôleurs
Valcom
Valcom V-VCU Manuel utilisateur
Valcom
Valcom PagePac Plus V-5323100 Manuel utilisateur
Valcom
Valcom PagePac V-5335100 Manuel utilisateur
Valcom
Valcom VL-9998RM Manuel utilisateur
Valcom
Valcom PagePac Plus V-5323100 Manuel utilisateur
Valcom
Valcom V-2000 Manuel utilisateur
Valcom
Valcom V-1092 Manuel utilisateur
Valcom
Valcom V-1092 Manuel utilisateur
Valcom
Valcom Pagepac Plus V-5335621 Manuel utilisateur
Valcom
Valcom V-1092 Manuel utilisateur
