VALCOBABY LATITUDE Manuel d'installation et d'exploitation

Thank you for purchasing a quality Valco Baby product. Please read and follow the instructions outlined in this

guide carefully. Familiarise yourself with the construction and safety features; be sure that you understand all

the warnings and safety guidelines before use.

Retain this guide in a safe place for future reference.

PRODUCT REFERENCE GUIDE

Due to our policy of continuous product

development, this product is constantly

evolving. It is possible that some features or

procedures outlined here have changed since

this document was written.

If you are unsure of any procedure shown

here, please contact us via the web at

[email protected] to obtain the most

up to date information before use. Include

the batch number, which can be found on a

sticker on the frame.

All pictures and diagrams herein are provided

for illustration purposes only. Actual product,

colour or fabric may vary. Valco Baby reserves

the right to modify or alter any specication

or colour without notice or obligation to

modify any product previously purchased

FURTHER INFORMATION

In Australia/New Zealand

www.valco.com.au

In North America only

www.valcobaby.com

1800 610 7850

LATITUDE

STROLLER

vs201010

assembly

FIGURE A

1. Lift the handle upward toward you. The frame will

begin to open.

2. Continue opening the frame until you hear it

“click” into the fully locked position.

IMPORTANT: CHECK THAT ALL SEAT STUDS ARE FULLY

ENGAGED BEFORE USE

Install the rear axle/brake bar

FIGURE B

3. With the brake levers (3a) facing AWAY from the

stroller, align the plastic brake housings with the

rear legs (3b). Firmly push each housing onto the

corresponding leg until it locks into place. Test by

pulling on the rear axle.

Insert rear wheels

FIGUre C

4. Depressing the button in the centre hub of the

rear wheel, insert each wheel axle in turn, into

the wheel hub. Push the wheel as far as it will go

before releasing the button.

IMPORTANT: PULL EACH WHEEL SLIGHTLY BACK TOWARDS YOU

TO ENSURE THAT IT HAS FULLY ENGAGED IN THE AXLE.

Insert Front wheels

5. Insert each front swivel wheel over the housing

on the front legs. IMPORTANT: BE SURE THAT THE

SWIVEL LOCK LEVER IN THE HOUSING IS AT THE

TOP.

6. To x the front wheel in the non swivel position,

turn the wheel so that the two notches on both

housings line up. Press down rmly on the swivel

lock until it locks into place.

to Install the bUmper bar

FIGURE D

7. Align the ends of the bumper bar with the

housing located on either side of the seat.

8. Insert the ends into the housing. Keep pushing

until they lock into place.

This bumper bar is NOT adjustable.

IMPORTANT: NEVER LIFT YOUR STROLLER BY THE BUMPER BAR.THE

FRONT BAR IS NEITHER A RESTRAINING NOR CARRYING DEVICE.

aDJUstInG the Footrest

9. To lower/raise the footrest, simultaneously press

the release buttons and move the footrest to the

desired position.

click

PRESS

InstallInG the hooD

FIGURE E

10. Align the plastic hood housings over the corresponding

housing on either side of the stroller frame. Align

EACH straight track on the stroller housing with the

corresponding “channel” in the hood housing. Slide

the hood housing downward over the track so that it

completely engages on to the stroller frame.

11. Fix the velcro strap around each handle bar to secure the

hood completely.

UsInG the harness

FIGURE F

Your child MUST always be harnessed while in the stroller.

TO OPEN YOUR HARNESS:

12. Push down on both Buckle Prongs.

13. Simultaneously press the release button in the

centre of the buckle.

14. Lift the buckles from the Buckle Housing.

TO SECURE YOUR CHILD IN THE HARNESS:

15. Overlap buckles (15a) and (15b) so that they t together

to form one complete buckle.

16. Insert the completed buckle into the Buckle Housing

until it engages securely in place.

aDJUstInG yoUr hanDle

FIGURE G

17. Your handle can be adjusted to multiple positions. Press

the centre locking button while simultaneously moving

the handle up or down. Releasing the button will allow the

handle to lock into the next available position. Your stroller

comes equipped with a Safety Tether (17a). Secure the

strap to your wrist to stop the stroller rolling away.

NOTE: ALWAYS USE THE TETHER STRAP WHEN A CHILD IS

IN THE STROLLER

seCUrInG yoUr brakes

18. With your foot, press down on the centre of the brake

lever to simultaneously engage the brake in both wheels.

To release, simply lift the lever with your foot.

IMPORTANT: ALWAYS TEST THAT THE BRAKES ARE FULLY

ENGAGED BY PUSHING THE STROLLER FORWARD AND

BACKWARD.

to FolD yoUr latItUDe stroller

FIGURE H

19. IMPORTANT: BEFORE FOLDING, THE SEAT MUST BE IN A

RECLINE POSITION OF AT LEAST 30%. IF THE SEAT IS NOT

RECLINED, THE HOOD MAY POP OFF THE FRAME DURING

FOLDING. Pressing the centre locking button (19a), turn the

secondary release lock (19b) anti-clockwise and hold it in

the open position. Push the handle frimly downward as far

as it will go as it presses down on the spring frame release

mechanism. As you feel the frame release, push down on

the handle and the frame will fold “backward” (19c)

20. You can lock the frame closed by stretching the locking

strap over the frame, placing the metal catch over the

rivet head in the chassis.

HINT: FOR MOST COMPACT RESULTS YOU MAY NEED

TO TURN THE FRONT WHEEL.

PRESS

DOWN HOLD

DOWN

PUSH

RELEASE

HOLD

CLICK

15a 15b

19a

19b

19c

ALWAYS PUT THE

SEAT INTO A RECLINE

POSITION BEFORE

FOLDING

In Australia/New Zealand

www.valco.com.au

In North America only

www.valcobaby.com

1 800 610 7850

valco

baby

yoUr reClInInG aDJUstment

FIGURE I

Our system offers an almost innite amount of individual

seat adjustments.

TO RECLINE: While squeezing the centre release

mechanism in a pincer action, ease the seat down to

the desired position.

TO INCLINE: Place your hand at the centre of the rear of

the seat. Pull the incline strap while gently pushing

on the rear of the seat until the desired position has

been reached.

PRESS PULL

WARNING

• FOLLOW THE MANUFACTURER’S INSTRUCTIONS.

• PUT ON ALL THE BRAKES WHENEVER YOU PARK THE PRAM/STROLLER.

• DO NOT LEAVE CHILDREN UNATTENDED.

• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS PRAM/STROLLER.

• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU ADJUST THE PRAM/STROLLER. OTHERWISE THEY MAY

BE INJURED.

Remember, your child’s safety is your responsibility...

•NEVER USE ON StAIRS OR ESCALAtORS.

• AlwAys use the tether strAp when the stroller is in use.

• the CorreCt use AnD MAintenAnCe oF this VehiCle Are essentiAl.

• Be sure thAt All ClAMps AnD BuCkles Are seCurely FixeD AnD in plACe BeFore use

• when in the stroller, your ChilD Must AlwAys weAr the sAFety hArness, CorreCtly FitteD AnD ADjusteD, At

All tiMes.

• the MAxiMuM weight oF the ChilD For whiCh this stroller wAs intenDeD is 20kgs.

• CAn Be useD FroM A newBorn BABy onwArDs. A CoCoon, speCiAlly DesigneD to Be useD with A stroller, is

reCoMMenDeD when Any Fully reClining stroller is useD with A newBorn.

• neVer run with A newBorn BABy in Any prAM or stroller until the ChilD CAn sit up unAssisteD

(ApproxiMAtely 6 Months).

• CheCk All pArts BeFore use For BreAkAge or FAtigue. DisContinue use iMMeDiAtely iF Any pArt is FounD to Be

DAMAgeD or Broken.

• MAxiMuM loAD oF BAskets: 3.5kgs.

• Do not CArry ADDitionAl ChilDren. this stroller is MAnuFACtureD For the use with one ChilD only

• AlwAys Be AwAre oF the risks proViDeD By Fire AnD other signiFiCAnt sourCes oF heAt suCh As rADiAtors,

etC. whiCh MAy Be in the iMMeDiAte ViCinity oF your stroller.

• it MAy Be unsAFe to use Any ACCessories other thAn VAlCo BABy ApproVeD ones.

• this proDuCt is intenDeD For DoMestiC use only. it is not intenDeD For CoMMerCiAl use.

Should the chassis become wet, dry off promptly before storing. If this pram is used near the ocean or salted

roads, spray the chassis and seat frame with water and dry. We recommend a rust inhibiting product should

be used to prevent rust and fatigue on metal parts.

We recommend that you wipe down axles and lubricate the wheels every 3 months. Sand and dirt can grind

down axles, if you live near the beach or in a dusty environment you must wipe down the axles and wheels

then lubricate them monthly.

AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. MOVING PARTS ARE BEST LUBRICATED

WITH SILICONE BASED PRODUCTS. DO NOT USE OIL BASED PRODUCTS.

Table des matières

Autres manuels VALCOBABY Poussette

VALCOBABY

VALCOBABY URBAN ULTRALIGHT STROLLER Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY Twin Toddler Seat Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY velo Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY ZEE Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY TRIMODE Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY Mini Marathon Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY SNAP Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY Zee Spark Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY REBEL Q Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY EVO2 for 2 Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY SNAP Manuel utilisateur

VALCOBABY

VALCOBABY Slim Twin Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY Vee Bee SCOUT Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY ION STROLLER Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY VEEBEE CO-RIDER Manuel utilisateur

VALCOBABY

VALCOBABY ZeeTwo Manuel utilisateur

VALCOBABY

VALCOBABY Latitude Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY RAD Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY REBEL Q Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY BUGGSTER BASSINET Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY Runabout Series Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY Spark Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY VEE BEE LIO Manuel d'installation et d'exploitation

VALCOBABY

VALCOBABY snap ultra Manuel d'installation et d'exploitation

Manuels Poussette populaires d'autres marques

Hauck

Hauck Priya Trioset Manuel utilisateur

CHILDHOME

CHILDHOME CWQDN Manuel utilisateur

Dreamer Design

Dreamer Design Rebound GST Manuel utilisateur

Britax

Britax STEELCRAFT AGILE Manuel utilisateur

Graco

Graco 7427 Manuel utilisateur

Comfort

Comfort COMPASS Manuel utilisateur

OBaby

OBaby Aura Manuel utilisateur

Tutek

Tutek Tirso Manuel utilisateur

Babify

Babify Dual Plus Manuel utilisateur

Graco

Graco Stroller Manuel utilisateur

Special Tomato

Special Tomato Jogger Manuel utilisateur

Chicco

Chicco CORTINA TOGETHER TWO-PASSENGER STROLLER Manuel utilisateur

Otto Bock

Otto Bock Kimba neo Manuel utilisateur

Milly Mally

Milly Mally ROYAL Guide de démarrage rapide

Hauck

Hauck DUETT 3 PRAM Manuel utilisateur

BOB

BOB DUALLIE Manuel utilisateur

Nuna

Nuna Pepp Manuel utilisateur

Britax

Britax B2 Manuel utilisateur