V-tech VC2610 Manuel utilisateur
RM5887 Floor Stand
2
1. Insert the First extension (A) onto the Second
extension (B), aligning the slot in between.
Make sure the DC socket is out on opening of
the Second extension and ready for connection.
2. Let the cable jack of the Extension cable pass
through from the back of the base.
3. Pick one pole and pass the cable jack through
the pole, then connect the pole with the Base.
Install the oor stand
4. Pass the cable jack through the connector (K)
pipe, the second pole, the second connector
(K) pipe, and the third pole in turn.
Align the slot between the poles and
connector (K) pipes and connect all three poles
firmly with the pipes.
A
B
3
6. Pass the cable jack through the Second
extension (B), to the opening.
Then connect the Second extension to the
connector (J) pipe.
5. Pass the cable jack through the connector (J)
pipe, then connect the pipe with the third
pole.
7. Connect the cable jack with the DC socket, then secure the
cable with the Extension cover (C).
B
D
C
4
8. Place the floor stand near the crib. Open the base cover, and put the water bag into the base to
prevent the stand from falling. Then, cover the base cover.
5
9. Install the Baby Unit onto the First extension (A). Connect the adapter to the end of the cable and the
power supply to power up the Baby Unit.
Slide the switch to ON to power your Baby Unit on.
Floor stand installation is completed.
Autres manuels V-tech Support et étagère
Manuels Support et étagère populaires d'autres marques
Salamander
Salamander Acadia AC/W/L400/WH Manuel utilisateur
Fohhn
Fohhn VAT-09 Guide de l'utilisateur
ricoo
ricoo FS0522 Manuel utilisateur
AMSOIL
AMSOIL BMK-22 Guide rapide
Kargo Master
Kargo Master 48220 Manuel utilisateur
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur
