V-TAC VT-41150 Manuel utilisateur
INSTALLATION INSTRUCTION
TRIPOD STAND FOR FLOODLIGHT (VT-41150)
INTRODUCTION & WARRANTY
2
YEAR
WARRANTY
*
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT:
FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST
DEALERS. V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B
SUPPORT@V-TAC.EU
Thank you for selecting and buying V-TAC Tripod Stand. V-TAC will serve you the
best. Please read these instructions carefully before starting the installing and
keep this manual handy for future reference. If you have any another query,
please contact our dealer or local vendor from whom you have purchased the
product. They are trained and ready to serve you at the best.The warranty is valid
for 2 years from the date of purchase. The warranty does not apply to damage
caused by incorrect installation or abnormal wear and tear. The company gives no
warranty against damage to any surface due to incorrect removal and installation
of the product. This product is warranted for manufacturing defects only.
Model Power Max Length Body Type IP Ra�ng Input Power Unit Color Dimension
VT-41150 10W - 100W 1.5 meters Aluminium IP65 AC:90-240V,50/60Hz Yellow; Black 900x940~1800mm
1) Adjust the lower part of the Tripod stand as shown in Fig 1. (Make sure the lower
part of the stand is in locked position before you proceed to further steps)
2) Install the floodlight (fixture) on the mounting bar as shown in Fig 2. Make sure it’s
fixed properly by installing the mounting screws. (Fixture not included)
3) Once the floodlight (fixture) is installed fix the mounting bar on the top of the stand
as shown in Fig 3. Make sure it’s fixed properly using the mounting screw. Please do
not over tighten the screw.
4) Stand height can be adjusted by using turning screws as shown in the Fig 5. Once
you loosen the screw you can increase or decrease the height as per requirement and
at the desired position tighten the turning screw (as shown in fig 4).
6) Once you have completed the above steps you can now power the floodlight
(fixture) (Floodlight/fixture not included).
Note: Please switch OFF the power before starting the wiring installation of the
floodlight (Fixture)
INSTALLATION DIAGRAM
FIG 1 FIG 2
FIG 3 FIG 4
940~1800mm Adjustable
Table des matières
Autres manuels V-TAC Accessoires pour appareils photo
