URBANGLIDE RIDE 8 Plus Manuel utilisateur

RIDE 8 Plus

« Translation of the original instructions »

URBANGLIDE is a brand imported by the company PACT GROUP,

Located at 33 rue du Ballon –93160 Noisy Le Grand –France

PO3131

ENGLISH P.1

FRENCH P.14

SPANISH P.27

GERMAN P.40

ITALIAN P.53

PORTUGUESE P.66

DUCTH P.79

SUMMARY

SAFETY AND PRECAUTION

Protective equipment 1

Driver’s advice 1

Procedures and driving conditions 1

Usage of the charger 2

Battery 2

Maintenance 2

Transport 3

Using the scooter 3

Rebus 3

The different parts 4

Unfolding step 5

Using the screen 5

Folding step 4

USE

Security 4

Mounting the handlebar 6

Adjusting of the folding device 6

SAFETY AND PRECAUTION

Please read the manual carefully before using the product and read the risks and safety tips in the manual.

The use of an electrical product can be dangerous if the user is not watchful. Misuse and non-respect with

the safety instructions does not affect the company in event of accident. Self-judgment and common sense

are necessary for users to detect the possible dangers.

Please verify the current regulations and laws in your country to know where and how to use your product

legally. You must comply with the rules and laws that applicable to vehicles and pedestrians.

•Protective equipment

Always wear the following protective equipment:

-Approved and certified helmet according to your location

-Knee pads and elbow patches

-Long sleeve t-shirt and long pants

-Gloves

-Shoes with rubber soles, never drive in barefoot or sandal. Verify to make the laces made and keep

them as far as possible from the wheels and the internal system.

•Driver’s advice

This device may be used by children over 8 years of age and by persons with reduced physical, sensory or

mental capabilities or lack of experience or knowledge, if properly supervised, or if instructions for use of

safely, were given to them and the risks were apprehended. Children under 8 must not play with the product.

Cleaning and user maintenance should not be performed by unattended children. Do not touch the engine

or the brakes of the product immediately after use, these parts may be extremely hot. The maximum weight

of use is 120 kg.

Procedures and driving conditions

Please verify the current laws and rules in your country before using the product. Look around when using

the product and pay attention to all possible risks. It is important to respect the rights and properties of

everyone. For your safety do not start the accelerator if you are not on the product. This product is not

designed to make jumps, acrobatic tricks and skids.

Never drive on roads, near vehicles, stairs, hills, swimming pools or other streams. Please hold the

handlebars with both hands. Never go on the product with more than one person. Be sure to keep your

fingers and other body parts away from hot parts during use (Brake, motor, chain). Never use the product

with a Mp3 player, or with your smartphone at hand.

Never use the product to pull anything, as this may damage the components and wear out the battery. Never

put the product in contact with water, the electrical components can be damaged and create a dangerous

situation. Roll only on flat and solid surfaces. Avoid surfaces with gravel, holes, ice, which can lead to loss

of control of the product. Do not drive at night or in areas where visibility is reduced. Do not ride indoors

where there are carpets as they can interfere.

After each use, verify that each piece is in its proper place, and that it is not damaged. Before each use,

verify the following points:

-The brakes are in good condition

-All components are in good condition and in their places

-The parts with defects in the last use have been repaired or replaced according to the manufacturer's

conditions.

People who have medical follow-up or treatment such as: cardiac people, pregnant women, irresponsible

people, people with back or neck problems, should not use the product.

When not using your scooter, use the kickstand to keep itupright. To do this, straighten the metal bar located

under the tray of your scooter. You can adjust the height of the handlebar using the buttons on the sleeve.

Press the button and pull your handlebars up to raise your handlebars.

•Usage of the charger

A plastic cap is located on the loading port of your scooter, remove it to load your product, and do not forget

to put it back before using your scooter so as not to damage the loading port. Before using the product, it is

necessary to charge it. A long charge may be necessary before the first use. Please refer to the battery

indicator, you can charge your battery at any time to ensure the constant power. It is not necessary to wait

until the battery is completely empty to charge it.

Please do not use the charger of other brand, these can damage the battery of your product. To ensure a

normal life cycle, it is important to charge your battery at least once every 3 months, even if you are not

using the product. It is imperative to use the supplied charger which is specially designed for this scooter.

Avoid shocks and contact with water, these are factors not covered by the warranty that may damage the

battery.

The supplied charger is "smart", it will stop at 100% of the charge and not damage the battery. The charger

must be in perfect condition during each use, verify the wires, the condition of connection ends and

connectors. If the product does not charge, the charger may be defective, it needs to be replaced.

The charger must be used only by an adult, it is important to unplug it from both sides when not charging.

•Battery

Please do not store the battery in extreme temperatures. Store it below 30 ° C and above 0 ° C. If you do

not use your product for 60-90 days, the battery may get worse. This loss of autonomy is due to lack of use

and is therefore not covered by the warranty.

At the end of its cycle, the battery must be discarded separately from the undifferentiated generic waste.

Discard the batteries in the containers provided for this purpose. The recovery and recycling of batteries

contributes to protect the environment and material resources conservation.

•Maintenance

Please store your product in a dry, dust-free place, and avoid leaving it in a humid area or under the sun for

too long. To clean your appliance, use a damp cloth and mild detergent. Do not use alcohol, gasoline,

kerosene, or other corrosive chemical solvents to clean your appliance, which will damage its appearance

and structure.

Constantly verify the condition of components of your product, if any part is damaged, please replace it

before using the product. If a part is not working, falling and injuring may occur. Do not disassemble the

scooter in case of breakdown, otherwise the warranty will cancel. Before any intervention, it is advisable to

turn off your scooter. For all spare parts, please contact your dealer

•Transport

If you wish to transport your product by air or other means of transport as well as its battery, please contact

the local authorities and the carrier beforehand to obtain the possible prohibitions and limits of transport.

Lithium batteries are considered dangerous in many countries. Please make sure that the access and

transport are allowed before travelling. International law prohibits the transport of lithium batteries by air.

•Using the scooter

To turn on your product, press the Power button, then press the accelerator to advance. To move forward,

place both feet on the board, and use the right trigger on your handlebars to advance your scooter. To brake,

you can use the left trigger on your handlebar, or press the rear fender with your foot to reduce the speed of

your scooter. Before each use, please check that the wheels are not clogged, that the brakes are working

and that no warning message is displayed. Using the scooter for long periods can cause vibrations that can

be unpleasant, make poses regularly. When stopped, use the stand to stabilize your product. Unfold it with

your foot. To warn other users of your presence, use the horn located on the handlebars. Use the LED on

the front of your product to light your way in dark places.

•Rebus

THIS TROTTINETTE CONTAINS LITHIUM BATTERIES THAT MUST BE RECYCLED SAFELY. Recycling:

The battery must be removed before being discarded. Before any work, remember to turn it off and unplug

it from the power outlet.

USE

The different parts

To move forward, place both feet on the board, and use the right trigger on your handlebars to move your scooter

forward.

To brake, you can use the left trigger on your handlebars, or pull the rear mudguard with your foot to reduce the

speed of your scooter.

Folding steps

Unfolding Folding

1. Switch off the scooter and store the stand.

2. Press the folding button with your foot or hand and fold the scooter.

3. Continue bending until you hear the "click" sound.

Unfolding steps

1. Press the folding button.

2. Hold the scooter platform and raise the handlebar until you hear the "click" sound. If you have not heard the

sound, repeat and hold the folding button with your foot to make it easier to unfold.

Using the screen

Press the folding

button

Location of the bending

axis after bending

CAUTION: Do not pinch your fingers when folding the scooter!

Press the folding button

Location of the bending

axis after bending

1. The battery indicator shows the remaining

battery level in real time.

2. To turn the scooter on, press the On/Off button,

to turn it off, press it for 3 seconds.

3. Once turned on, press the On/Off button once

to turn on the front light. Press it once more to

turn it off.

4. Once turned on, press the On/Off button twice

to change the speed mode. When the "S" is not

displayed, you are in first gear, when the "S" is

flashing, you are in second gear, and when it is

static, you are in third gear.

Buton

Screen

Mounting the handlebar

Assembly

Disassembly

Adjusting of the folding device

To assemble the handlebars of your scooter, follow these steps:

1. Insert the two handles into the handle of your scooter.

2. Screw the two handles

Screw adjustment

Locking pin

To disassemble the handlebars of your scooter, follow these steps:

1. Unscrew the two handles of the handle of your scooter.

2. Remove both handles.

1.When the space in the folding device is too

large, the upper screw can be turned to the

right with an Allen key and the left and right

screws must be adjusted.

2.Before adjustment, make sure that the

scooter is in the adjustment lock state and

after adjustment, that the folding switch is

elastic and can be used normally. The locking

pin may normally fall down.

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels URBANGLIDE Scooter

URBANGLIDE

URBANGLIDE URBANRIDE 55 Manuel utilisateur

URBANGLIDE

URBANGLIDE 500 CT Instructions de fonctionnement

URBANGLIDE

URBANGLIDE RIDE 62R Instructions de fonctionnement

URBANGLIDE

URBANGLIDE MANUEL D'UTILISATION ECROSS PRO BOOST Instructions de fonctionnement

URBANGLIDE

URBANGLIDE 160 CITY Manuel

URBANGLIDE

URBANGLIDE ECROSS MAX 2X2 Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 62s Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 85XL Instructions de fonctionnement

URBANGLIDE

URBANGLIDE RIDE 100 PRO Instructions de fonctionnement

URBANGLIDE

URBANGLIDE RIDE 350 CT Manuel utilisateur

URBANGLIDE

URBANGLIDE C6 Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 100 MAX Manuel utilisateur

URBANGLIDE

URBANGLIDE BIKE 140 Instructions de fonctionnement

URBANGLIDE

URBANGLIDE E-CROSS Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 85 L Manuel utilisateur

URBANGLIDE

URBANGLIDE F2 Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 85 L Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 81 BOOST Manuel utilisateur

URBANGLIDE

URBANGLIDE SUV100 BT Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 69L Manuel utilisateur

URBANGLIDE

URBANGLIDE URBANRIDE 80AE Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 61s Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 85S Manuel utilisateur

URBANGLIDE

URBANGLIDE RIDE 100s Manuel utilisateur

Manuels Scooter populaires d'autres marques

TEKTRO

TEKTRO CHEETAH Manuel utilisateur

Douglas

Douglas Vespa Sprint Guide d'installation

PLAYTIVE

PLAYTIVE AS-2448 Manuel utilisateur

Ebinger

Ebinger DONKEY XL Manuel utilisateur

Flyer

Flyer Mountain Guide de l'utilisateur

BackCountry eBikes

BackCountry eBikes Storm Manuel utilisateur

equipmed

equipmed FreeRoam II Manuel utilisateur

Yoto

Yoto Lion Manuel utilisateur

WESTHILL BIKES

WESTHILL BIKES LINK Manuel utilisateur

BAnff

BAnff eProdigy series Manuel utilisateur

Winther

Winther 475 Manuel utilisateur

Jetson

Jetson JBZL17 Manuel utilisateur

First Choice Mobility

First Choice Mobility Roma Medical Corella S741 Manuel utilisateur

Carrera

Carrera impel Manuel utilisateur

Afikim

Afikim Superlight SL-3 Manuel utilisateur

CareCo

CareCo ZOOM Manuel utilisateur

Douglas

Douglas Vespa G.S. Manuel utilisateur

Gazelle

Gazelle with BOSCH System Manuel utilisateur