UDI R/C U52G Manuel utilisateur

U52G

This product supports GPS positioning and

is recommended for outdoor flight!！

This wifi camera pinpoint is 5G,

please confirm whether the phone is supported.

▲This product is suitable for users over 14 years old.

▲Stay away from the rotating propeller

▲Read the<important statement and safety guidelines >carefully.

Operation

Guidance

Ready Before Take Off

Drone Preparation

Navigation Light

(Front) Green

Navigation Light

(Rear) Red

TF card slot

Navigation Light

(Front) Green

Navigation Light

(Rear) Red

Base

Propeller A

Front

Rear

Camera

Drone Battery

Drone upper

housing

Propeller B

Propeller A

Power Switch

Top cover

Battery Charge

Drone Battery

Original Charging cable

Connect the original charging cable with the drone battery, and then connect other

USB charging port. The red USB indicator light keeps bright when charging and the

light turns green when fully charged.

Battery Installation

Battery power is insufficient in the original plant. It must be charged saturated

before it can be used.

▲Only use the original charging line; suggest select Adapters with output current of 5V 2A .

Power adapter (not included)

②

①

Drone buckle

you need to squeeze up and down

of the battery buckle and then put

out the battery box is fine.

Disassembly:

Put the battery into the battery

compartment and push it into position.

Installation:

Installation of TF Card

Insert the TF card into the slot on the

side of the fuselage, and pay attention

to the metal contact surface orientation

of the TF card.

TF card is not included

(

Suitable for 1080P only

)

Transmitter Preparation

Battery Installation

Power Switch

Indicator Light

Left stick /

Follow (press down)

Take off /

Landing button

Return button

Right stick/

Encircle (press down)

Video Photo

Phone(not include)

Open the battery cover of the remote controller and place the same type of battery

with saturated capacity according to the'+-'electrode indication in the battery cell

( battery needs to be purchased separately ) .

Battery cover

4×1.5V AA battery

Mobile Phone Installation

③Open the clip of mobile phone.

①Straighten the antenna.

Gently pull up the clip

from the notch.

Back of transmitter Back of transmitter

Front of transmitter

②Pull to the bottom and stop

the metal shaft.

④Place the phone in the upper and lower

clamps, and the clamp will automatically

clamp the mobile phone. Pay attention to

don't clip the buttons on the side of the

phone.

Flight Operations

Mobile phone connect with Drone

Download and install APP: UDIGPS

This software is suitable for mobile phones in

the IOS and Android system.

For detailed operation, please check the

system “HELP” of APP.

Compass calibration

Tips: It’s a must to have the right compass adjustment first each time you start

the drone, or it can’t work normally.

Rotate the drone horizontally until the transmitter will sound "di... " , horizontal correction

to complete. When the left navigation light turns to long light and the right navigation light

flashes, enter vertical correction. Rotate the drone vertically until the transmitter will sound

"di... ", vertical correction over. The four navigation lights are spinning and flashing.

Horizontal Correction Vertical correction

②Pull the left stick to the lowest position

and let go, the indicator light changed to

slow flash.it indicates the transmitter enters

the frequency state.

Transmitter connect with Drone

Frequency Pairing

① Turn on the prower,

the transmitter indicator

light will flash quickly.

It must be placed on the horizontal ground！

③ Press the key of power for two

seconds to start the drone, it makes the

right frequency successfully. Then the

left navigation light keeps shiny, while

the right navigation light is off. Thus

shows that it enters the state of compass

horizontal calibration.

Control stick operation

Left stick

Counterclockwise turn

clockwise turn

Go up

Go down

GPS signal search

After the frequency matching is successful, the drone automatically searches for

GPS signals. When the left blue indicator light of the transmitter changes from

flashing to long bright, indicating that the GPS connection is successful. But if you

don’t connect the GPS, the flight height defaults to about 3 meters.

Unlocking the drone

Push the left and right stick inward to the 45

degree angle simultaneously.

On standby drone, motor rotation, drone Unlocked.

When the drone is not take off, the motor

stops rotating and the drone is locked.

The drone can only take off when the motor is unlocked.

Calibration

Tips: When the drone doesn’t appear to use the trim correction flight status, or being hit hard

(or falling abnormally). thus cause the difficulties in controlling. Now frequency making and

adjustment are needed again, drone should be placed on horizontal ground.

After finishing the compass adjusted, push the

right stick to the bottom right 45 degrees, the

Navigation light flash and when you release it,

this means the gyroscope is calibrated.

Automatic return

During the flight, press the "return " button, and the

transmitter will sound "di", and the drone will

automatically return to the take off point.

(during returning, the transmitter will continuously

sound "di". To stop homing, just press this button

again.)

During the automatic return, the remote stick is locked. When the drone returns

to the take off point and aligns with the take off direction, the remote stick is

automatically unlocked.

Take off

Landing

After unlocking the motor, press the "take off" button,

and the drone will automatically rise and hover at a

height of about 1.2 meters .

During the flight, press the “landing” button,

the transmitter make a sound of “di”and the

drone slowly land until landing.

Notice：Don’t operate the left stick during landing, otherwise the current

command will automatically fail.

Right Stick

Fly to the left

Fly to the right

Forward

Backward

In flight, press the right stick down, and the transmitter will make the sound of "di".

Then it goes to the function of encircling flight. The drone will fly to a default radius

then it waits for the direction controlled by the user. Adjust the speed and direction

of the drone by manipulating the right stick. It is the minimum radius of the default

radius acquiescently ,so drone flies only in the sub range.

Encircling flight

While flying, press left stick down, the transmitter

sounds “di”, drone enters the function of following.

Now it can be controlled by the user.

The function is standard by the mobile phone APP signal,

so it’s a must to make the drone and APP connected

normally, turn on the mobile location service at the same time,

otherwise this function is invalid.

Following mode

Turn left, the drone flies clockwise; Move

further, the flying speed will become faster.

Go downside to enlarge the radius of

encircling.

Go upward to narrow the radius of

encircling.

Turn right, the drone flies counterclockwise;

Move further, the speed will become faster.

In the state of

encircling flying,

the left stick could

only control the

height of the drone.

Press down

Turn on / turn off GPS signal

Turn off:

Turn on:

Press “H/L” button for about 2 seconds, the transmitter will sound “di”, the blue

indicator of the transmitter is out to indicate

that the function of GPS is off.

(When the GPS is connected)

Tip:

The function is suitable for using in the situation of weak GPS signal or indoors; When

the function of GPS is off, so is the fixed function. The function can only be used when

the motor is locked.

Repeat above action after five seconds,

you can restart the function of GPS.

GPS defaults to be on.

Notice: Drone must be connected to GPS properly in order to give full play to

fixed-point hovering function. Atmospheric pressure or wind force affects

hovering stability.

Intelligent Hover

The intelligent flight control system calculates the levitation height and the GPS positioning

coordinate axis, so that the aircraft can stay in the air better. The drone is like a camera

fixed in the air, Aerial photography and control are very convenient.

Short press “photo”once to take a picture.

When taking photos, the transmitter will

sound "di" .

Long press the "video" button for 1 second

to enter the recording state, to repeat this

action to stop recording and save video.

When taking video, the transmitter will

sound“di..”.

Photo Video

Notes for Filming

①Photos taken will be saved to mobile picture library and drone TF card; Video can be saved in

TF card first, which can be downloaded to mobile picture library for viewing. Please

download video according to APP prompt. When downloading, maintain the normal

connection between the mobile phone and the flyer, and the TF card is in the card slot.

②The APP must be authorized to read the phone gallery to view the aerial photos.

③Turn off the power supply of the drone before taking out the TF card.

④When aerial video is read by computer,it must have corresppnding playback software.

Speed mode switch

Low speed: suitable for beginners to practice without wind.

Medium speed: suitable for skilled operator operating in

light breeze.

High speed: suitable for professional operation in outdoor

wind resistance.

Back of transmitter

Press the "H/L" button, the transmitter will sound "di.di.di", to enter High Speed Mode "H".

Press again, the transmitter will sound "di", to enter Low Speed Mode “L”.

Press again, the transmitter will sound “di.di”, to enter Middle Speed Mode “M”.

Table des matières

Autres manuels UDI R/C Drone

UDI R/C

UDI R/C UDIO22 Manuel utilisateur

UDI R/C

UDI R/C U89S Manuel utilisateur

UDI R/C

UDI R/C U818A WIFI Manuel utilisateur

UDI R/C

UDI R/C VOYAGER U845Wifi Manuel utilisateur

UDI R/C

UDI R/C VOYAGER U845Wifi Manuel utilisateur

UDI R/C

UDI R/C U64 Manuel utilisateur

UDI R/C

UDI R/C U39S Manuel utilisateur

UDI R/C

UDI R/C VOYAGER U845Wifi Manuel utilisateur

UDI R/C

UDI R/C VOYAGER U845Wifi Manuel utilisateur

UDI R/C

UDI R/C U37 Manuel utilisateur

UDI R/C

UDI R/C U65 Manuel utilisateur

UDI R/C

UDI R/C U46S Manuel utilisateur

UDI R/C

UDI R/C Swan U42 Manuel utilisateur

UDI R/C

UDI R/C VOYAGER U845Wifi Manuel utilisateur

UDI R/C

UDI R/C U42W Manuel utilisateur

UDI R/C

UDI R/C U46S Manuel utilisateur

UDI R/C

UDI R/C TIMY U846 Manuel utilisateur

UDI R/C

UDI R/C U38S Manuel utilisateur

UDI R/C

UDI R/C U818A WIFI Manuel utilisateur

UDI R/C

UDI R/C U95 Manuel utilisateur

UDI R/C

UDI R/C U46W Manuel utilisateur

UDI R/C

UDI R/C VOYAGER U845Wifi Manuel utilisateur

UDI R/C

UDI R/C U67 Manuel utilisateur

UDI R/C

UDI R/C Neon U51 Manuel utilisateur

Manuels Drone populaires d'autres marques

Ryze

Ryze Tello Manuel utilisateur

PowerVision

PowerVision PowerRay Manuel utilisateur

Force1

Force1 rogue F72 Manuel utilisateur

Zerotech

Zerotech DOBBY Manuel utilisateur

Protocol

Protocol VIDEODRONE AP Manuel utilisateur

dji

dji Matrice M210 Manuel utilisateur

MAKE

MAKE Terry Kilby Manuel utilisateur

SYMA

SYMA X440 Manuel utilisateur

RUKO

RUKO F11 Manuel utilisateur

SYMA

SYMA X5UW(720P) Manuel utilisateur

Dynali

Dynali 25 H Mode d’emploi

dji

dji PHANTOM 4 Manuel utilisateur

Atlas

Atlas AtlasPRO Manuel utilisateur

Twodots

Twodots TVVIN BOARD Manuel utilisateur

GDU

GDU SAGA Manuel utilisateur

Ares

Ares ETHOS QX 130 Manuel utilisateur

Walkera

Walkera ZHUN Manuel utilisateur

dji

dji WIND-4 Manuel utilisateur