Operation
1-2-3-4-5 keypad buttons: For entering and programming lock codes.
Program button: Initiate the lock programming mode by pressing the front thin edge of the black button inward toward the mounting surface the MicroIQ is mounted to.
Infrared Receiver:
The Infrared Receiver will receive a signal from an electronic TriTeq key-fob when
it is pointed at the receiver located behind the Program button. The Program
button is slightly opaque so the key-fob signal will penetrate the button.
Knob:
To move the lock mechanism 90 or 180 degrees clockwise or counterclockwise from
the locked and unlocked states.
The Green and Red LED’s will flash and illuminate to indicate operating conditions
per the descriptions below.
The Yellow LED will flash 5 times after the lock is operated to signify the
battery level is low and should be replaced.
Green
Proceed
LED
Red
Error
LED
Yellow
Low battery
LED
Knob
in locked
position
Location to
point the
key-fob
Battery
holder
with cover
Keypad
Fig. 5
Program
button
Push thin
front edge
inward
Press
Here
The mounting screw for the Lock Housing must be installed before
installing the MicroIQ battery.
1
2
Battery
If mounted on sheet metal :
If mounted to wood panel with
threaded insert:
Select appropriate mounting screw. If a lock
spacer is required, a mounting screw must be
#4 Sx.375 sheet-metal screw
M3 x25mm (1”) screw
In addition, the double stick tape can
be used solely or in conjunction with
the mounting screw to further secure
the lock. Allow tape to cure for 72 hours.
Fig. 3
2 3
56
Battery
Holder
Battery
Cover
LIFT
UPWARD
1
4
Battery
Holder
Battery
Strip
(optional)
Battery
Strip
(optional)
SWING OVER
AND SNAP THE
COVER DOWN
PULL SRTIP
BEFORE USING
Hex
Tool
Screw
Battery
Strip
(optional)
Battery
Strip
(optional)
NOTE: If the assembled lock is going to be transported or
shipped, it is required that the battery assembly includes the
battery strip. If the lock is being set up for use, the battery
strip is not needed (skip step 1 and 6).
Rotate the knob to the unlocked position
Insert the battery strip into the housing.
Insert the battery holder assembly (battery, holder, and
cover) into the lock housing making sure the cover is
open. If the assembly is not fully seated, make sure the
battery holder screw is flush with the bottom of the
assembly and that it is not interfering with the fit.
Insert the provided M2 screw in the battery holder.
Use the hex tool to attach the battery assembly to the
lock housing.
Swing the battery cover closed and snap in place.
If transporting/shipping the lock assembly, the battery
strip must be removed prior to use. Remove by pulling
the strip out of the housing.
1
2
3
4
5
6
7
