OPERATING INSTRUCTIONS
Read this manual in its entirety before rst operation and keep it
available for future reference.
Before Operating:
1. Be sure unit is properly grounded.
2. Be sure you are plugging the unit into a 110 volt outlet.
3. Always turn o the machine when not in use.
4. Be sure to grasp handle rmly when opening.
5. Always keep children away from this machine.
6. Do not attempt to use on products that are not intended for
normal heat transfer use.
Operating Procedures:
1. Plug into standard 110V power supply and turn on power
switch, the red light will illuminate.
2. Adjust the temperature by pressing the SET button; the
top LCD screen should be blinking. Use the UP and DOWN
buttons to select the desired temperature and press the SET
button again; the bottom LCD screen should start blinking,
this allows you to set the timer.
3. Time is set in seconds; use the UP and DOWN buttons to
select the time and press SET to set the time.
4. Allow 20-30 minutes for machine to heat to set temperature.
5. Set locking pressure to provide a rm but comfortable lock-
down of the heating plate. The pressure may need to be
adjusted again depending on the material or the specic
transfer application. Turn pressure knob to the right to
increase pressure, turn left to reduce pressure. Note that
when the pressure is set too high the handle will not lock.
