INSTALLATION
Parts included with each light tting:
1 x Eclipse 24W Solar Light
1 x Wall / Pipe Bracket
1 x Mounting Kit
• It is very important that the 2 connecting cables are attached to the light with the correct matching colour codes,
failure to do so may result in damage to the unit
• It is important that the Eclipse light tting is mounted on a pole or wall that places it in direct sunlight
• The recommended mounting height is 4-6m
• Please open the package and ensure all the part are complete
• Before installing the Eclipse, turn unit on and place the light on the ground with the solar panel facing
down and check to see that the unit illuminates to its low-light or courtesy light level. Sweep your hand
over the sensor and check the light increases it’s brightness to 100% power and stays on for a period
of time (30seconds) before returning to courtesy light. Once satised install the light
• The Eclipse is designed to be tted directly onto poles of diering sizes or, using half of the bracket, directly
onto a wall
BATTERY MANAGEMENT SYSTEM
The battery operation is digitally controlled by the built-in micro-processor and this programme ensures that as the
battery power is depleted, the tting will still operate in an ecient manner. The following table demonstrates how the
battery will perform as the % of power reduces.
100% - 60% Battery
Power
60% - 40% Battery
Power > 40% Battery Power
Full Light (PR) YES - 30 secs exposure YES - 30 secs exposure YES - 30 secs exposure
Courtesy Light YES YES NO
CLEANING THE SOLAR PANEL
Although no part of the Eclipse requires maintanence, routine cleaning of the solar panel will allow it to perform at peak
capacity. In winter, keep snow and ice from building up on the solar panel so the battery charges properly.
LIGHT DOES NOT OPERATE AT
If the Eclipse does not operate at dusk, despite observing the instructions of this manual, please try the following:
• Ensure the solar panel is not shaded or otherwise obstructed during the day
• Ensure the ON/OFF switch has been activated (i.e. In the ‘ON’ position)
Parts included with booster panel are as follows:
1 x Eclipse Booster Panel with 32.5W Li-ion battery
1 x Universal Bracket for pole mounting horizontally/vertically
(Can also be mounted direct to a wall)
4 x Sets Stainless Steel Nuts, Bolts and Locking Washers.
