Product Code: RLLDWB
Made in China to TQB Brands Pty Ltd specifications Page 4
Visit us at www.tqbbrands.com.au
Assemble the Work Bench:
1. Attach Side Beams (4) to Front (1) and Back Posts (2).
2. Attach Rubber Feet (3) to bottom of each post.
3. Attach Bottom Beams (5) to Front and Back Posts.
4. Attach Side Beam (4) and Side Beam (4A) to the top 2 holes on Front Posts and the
middle 2 holes on Back Posts. Note: Side Beam with Power Strip Opening can be
attached to either the right or left side.
5. Attach Power Strip (22) to Side Beam with Power Strip Opening using U Brackets (F)
and Screws (E).
6. Attach Top Beams (6) to the top 2 holes on Front Posts and the middle 2 holes on
Back Posts. Note: Make sure the Front Top Beam carries the Warning Label and is
right-side up.
7. Attach Front (7F) and Back (7B) Drawer Brackets to Top Beams.
8. Attach Middle Drawer Mount (8) to Front and Back Drawer Brackets.
9. Attach Left (9L) and Right (9R) Drawer Mounts to Front and Back Posts. Tighten
hardware.
10. Attach Drawer Handle (14) to the Front Drawer Panel (11) using Bolts and Nuts (A).
Repeat for second Front Drawer Panel. Tighten hardware.
11. Lay Drawer Bottom (13) down on a flat surface. Attach Right (10R) and Left (10L)
Drawer Panels to the Front and Back (12) Drawer Panels. Tighten hardware. Repeat
for second Drawer.
12. Install Drawers, making sure the runners on the Drawers are level with the Drawer
Mounts.
13. Attach left and right Back Upper Posts (15) to left and right Back Posts.
14. Attach Back Shelf Beam (16B) to Back Upper Posts.
15. Attach Left Shelf Beam (17L) and Right Shelf Beam (17R) to the back Shelf Beam.
16. Attach Front Shelf Beam (16F) to Left and Right Shelf Beams.
17. Attach Pegboard (18) to Back Upper Posts and Middle Drawer Mount using Bolts and
Nuts (C).
18. Attach Bench Top (19) to Upper Side Beams and Bottom Shelf (20) to Lower Side
Beams using Bolts and Nuts (D).
19. Make sure all components are level and square, then tighten all hardware securely.
20. Attach Top Shelf (21) to Shelf Beams using Bolts and Nuts (D).
Fig.A
