TPI 1450 Series Manuel utilisateur
Replacement inner ap
TPI air inlet valves
1450-series
2.
2
3 4
1
Exercise cauon when unscrewing the old innerap! The spring unit is located
underneath the le side of the ap. If that side is unscrewed and the ap
pulled up, the spring will jump back. This may injure your ngers! Wear safety
glasses during replacement!
Mounng instrucons
1. Start with the right side of the innerap. Simply slide the ap into the frame. Do
not forget the plasc washer, also shown in picture 3.
Pull up the ap on the le side. Place the plasc washer as shown in picture 3.
Then replace the black bracket and place the transparent plasc strip over the
spring as shown in picture 4.
3.
4.
Turn the spring one complete revoluon clockwise as shown in pictures 5 & 6 and
push the ap down as shown in picture 7.
The spring should point towards the front of the inlet before it is pushed down!
NOTE: Cauon!! Use a good pair of tongs and take care not to injure your ngers!
Turn the spring counter clockwise in case of self-closing execuon.
Mount the last two screws as shown in picture 8.
5
7
6
9
8
Telephone: +31 (0)73-656 91 94
Fax: +31 (0)73-656 69 33
E-mail: inf[email protected]
Internet: www.tpi-polytechniek.com
TPI-Polytechniek BV
De Steenbok 24
5215 ME ‘s-Hertogenbosch
Holland
Table des matières
Autres manuels TPI Support et étagère
Manuels Support et étagère populaires d'autres marques
Salamander
Salamander Acadia AC/W/L400/WH Manuel utilisateur
Fohhn
Fohhn VAT-09 Guide de l'utilisateur
ricoo
ricoo FS0522 Manuel utilisateur
AMSOIL
AMSOIL BMK-22 Guide rapide
Kargo Master
Kargo Master 48220 Manuel utilisateur
Milestone AV Technologies
Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur
