TP-Link TL-WA801ND Manuel

The TP-Link TL-WA801ND is a multi-function access point. This document is intended to assist with

configuring the TL-WA801ND to allow the EG3000 to communicate on an existing WiFi network.

This guide is designed only for use with a TP-WA801ND purchased through eGauge Systems

For full documentation and other support issues, please visit the TP-Link website athttp://www.tp-

link.com/. The full TP-Link manual as of the writing of this article is available here. Please visit TP-

Links website for the most up to date information.

1. Attach the included two antennas to the back of the access point. Ensure the connections

are not loose.

2. Power the TP-Link TL-WA801ND using the barrel jack or PoE (Power-over-Ethernet)

injector, and connect a computer to the access point using an Ethernet cable (if using the

PoE injector, connect the LAN port to your computer, and the POE port to the access

point).

3. Ensure all wireless interfaces are disabled on the computer (such as WiFi and Bluetooth)

and that DHCP is enabled on the Ethernet interface. Open a web browser and access the

TL-801ND by visiting

http://tplinkap.net/

4. Log in using usernameadminand passwordadminand chooseLogin.

5. ClickQuick Setupfrom the left side, thenNext.

6. Change the admin password if desired and chooseNext.

7. ChooseClientas the operation mode and pressNext.

TP-Link Access Point Setup

(TL-WA801ND)

Configuration instructions



8. Find your wireless network, and chooseConnect.

9. Enter the wireless network password and choose Next.



10. If DHCP service is on the wireless network, leave the Type asSmart IP (DHCP)and

chooseNext.





11. Verify the settings that are chosen, and choose Finish.

The access point has been configured and the eGauge may be connected via Ethernet for network

communication.



I cannot reach the eGauge on the proxy server or locally.

Verify the TP-Link access point is powered up and configured. Connect a laptop to the Ethernet

port on the TP-Link access point, disable WiFi, bluetooth and any other wireless network interfaces

and try reaching the internet.

I don't see my network listed in the quick setup network list, or the signal is weak or

inconsistent.

Ensure the two antennas are secured on the back of the unit and that the wireless network is

within range of the access point.

I do not have network access through the TP-Link access point, or the network information

has changed and I cannot access the configuration interface.

Perform a factory reset on the TP-Link access point by using a paperclip or pin and holding down

the recessed reset button on the back of the unit, release the button when all the LEDs turn off or

flash. Then, re-configure the unit using the steps in this article.

Troubleshooting

Revision #2

Created Fri, Jan 31, 2020 10:15 PM by Andrew

Updated Wed, Mar 4, 2020 7:57 PM by Andrew

Autres manuels pour TL-WA801ND

8

Table des matières

Autres manuels TP-Link Point d'accès sans fil

TP-Link

TP-Link AP300 Manuel utilisateur

TP-Link

TP-Link TC-7610 Manuel utilisateur

TP-Link

TP-Link TL-WA901ND Manuel utilisateur

TP-Link

TP-Link TL-WA901ND Manuel utilisateur

TP-Link

TP-Link Auranet EAP330 Manuel utilisateur

TP-Link

TP-Link AP300 Manuel utilisateur

TP-Link

TP-Link AP200 Manuel utilisateur

TP-Link

TP-Link AURANET CAP300-Outdoor Manuel utilisateur

TP-Link

TP-Link Auranet EAP110 Manuel utilisateur

TP-Link

TP-Link Auranet EAP320 Manuel utilisateur

TP-Link

TP-Link omada OC200 Manuel utilisateur

TP-Link

TP-Link AP300 Manuel utilisateur

TP-Link

TP-Link Pharos CPE210 Manuel utilisateur

TP-Link

TP-Link Omada Pro AP9650 Manuel utilisateur

TP-Link

TP-Link 6935364097752 Manuel utilisateur

TP-Link

TP-Link AURANET CAP300-Outdoor Manuel utilisateur

TP-Link

TP-Link Auranet EAP115 Manuel utilisateur

TP-Link

TP-Link AP8635-I Manuel utilisateur

TP-Link

TP-Link TL-PA4010 Manuel utilisateur

TP-Link

TP-Link Auranet EAP330 Manuel utilisateur

TP-Link

TP-Link Auranet EAP110 Manuel utilisateur

TP-Link

TP-Link TL-WA901ND Manuel utilisateur

TP-Link

TP-Link TL-WA901N Manuel utilisateur

TP-Link

TP-Link Deco M5 Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

Draytek

Draytek VIGORAP 902 Manuel utilisateur