Toro 98-9880 Manuel utilisateur

FORM NO. 3321–698

TOWER REPAIR KIT

for LAWN TRACTORS

PART

No. 98–9880

INSTALLATION

INSTRUCTIONS

Loose

Parts

Note: Use the chart below to identify parts used for assembly.

DESCRIPTION QTY. USE

Pivot rod

Hex Spacer nut, 3/8–16 x 1” (26 mm)

Screw

, 3/8–16 x 1/2” (13 mm) hex socket head

Threadlocker adhesive #242

Installation Instructions

Read before installing

Installation

1. Drain the fuel tank; refer to operator’s manual.

POTENTIAL HAZARD

•In certain conditions gasoline is extremely

flammable and highly explosive.

WHAT CAN HAPPEN

•A fire or explosion from gasoline can burn

you, others, and cause property damage.

HOW TO AV

OID THE HAZARD

•Drain gasoline from the fuel tank when the

engine is cold. Do this outdoors in an open

area. Wipe up any gasoline that spills.

•Never drain gasoline near an open flame or

where gasoline fumes may be ignited by a

spark.

•Never smoke a cigarette, cigar or pipe.

2. Remove the left side screw securing the fuel tank

rod and tilt rod up. Set the fuel tank on engine to

gain access to the back side of the dash (Fig. 1).

Figure 1

1. Fuel

tank rod

2. Screw 3. Tower

3. Loosen flange nuts on deck lever pivot rod. Tap

pivot loose from mounting position (Fig. 2).

4. Remove pivot rod, pivot rod clamps, flange

nuts,washers, haripins and wedge nuts. Discard

all pieces except the flange nuts, washers, and

haripins (Fig 2).

Note: In removing the pivot shaft, rotate it

upward and slide out of deck

engagement lever.

m–4047

Figure 2

1. Pivot

rod

Pivot rod clamp

3. W

edge nut

Flange nut

Flat washer

6. Hairpin

5. Place a straight edge aligned across the ends of

the depressed areas (Fig. 3) on the tower. Scribe

a short mark, in line with the ends, at the center

of the third rib from the top on both sides. With

the straight edge aligned through the center of

the third rib, scribe a short mark across the

vertical mark. Drill a 13/32” diameter hole on

each side of the tower at these locations.

m–4042

Figure 3

1. 13/32”

Dia. hole

Depressed area

Rib #3

6. Install the new pivot rod through the deck

engagement lever. Install the two washers and

hairpins, previously removed, on either side of

the deck engagement lever.

7. Install the flange nuts, previously removed

(Fig. 4), with the flange toward the outside.

m–4043

Figure 4

1. Pivot

rod

Hex spacer

Socket head screw

Flange nut

5. Hairpin

Flat washer

8. Thread a hex spacer nut onto each end of the

pivot rod. Equally adjust each spacer so that the

assembly just fits inside the tower (Fig. 4).

Note: If rod is not threaded equally into each

spacer, screws may not fully screw into

the spacers.

9. Tighten the flange nuts against the hex spacers,

while holding the spacers with a wrench.

10. Apply Loctite adhesive, supplied with the kit, to

the threads of the 3/8–16 x 1/2” (13mm) screws.

Thread the screws into the spacers. Tighten

sufficiently, being careful not to deform the

plastic.

11. Reinstall the fuel tank.

Autres manuels Toro Accessoires pour tracteurs

Toro

Toro 04651 Manuel utilisateur

Toro

Toro 04720 Manuel utilisateur

Toro

Toro 136-8545 Manuel utilisateur

Toro

Toro Wheel Horse XT Series Manuel utilisateur

Toro

Toro 03667 Manuel utilisateur

Toro

Toro Greensmaster TriFlex 3300 Series Manuel utilisateur

Toro

Toro 119-9604 Manuel utilisateur

Toro

Toro 132-4164 Manuel utilisateur

Toro

Toro Field Pro 604 Manuel utilisateur

Toro

Toro 30728 Manuel utilisateur

Toro

Toro 08733 Manuel utilisateur

Toro

Toro 111-6032 Manuel utilisateur

Toro

Toro Greensmaster 04654 Series Manuel utilisateur

Toro

Toro Z MASTER 79402 Manuel utilisateur

Toro

Toro 04504 Manuel utilisateur

Toro

Toro 79181 Manuel utilisateur

Toro

Toro 08865 Manuel utilisateur

Toro

Toro Direct Drive Power Box Rake Manuel utilisateur

Toro

Toro BU-003867 Manuel utilisateur

Toro

Toro 30517 Mode d’emploi

Toro

Toro 08752 Manuel utilisateur

Toro

Toro 25427 Manuel utilisateur

Toro

Toro 22414 Manuel utilisateur

Toro

Toro Sitework Systems 22420 Manuel utilisateur

Manuels Accessoires pour tracteurs populaires d'autres marques

Land Pride

Land Pride SGC0548 Manuel utilisateur

Swisher

Swisher Versa Commercial Pro VSP50 Manuel utilisateur

matev

matev FPS-FKH-Kioti CX 2510 Manuel utilisateur

matev

matev SCA-130 Manuel utilisateur

Avantco

Avantco A425119 Manuel utilisateur

FTS

FTS G-FTL Series Manuel utilisateur

Sami

Sami 150-50 Manuel utilisateur

CAMSO

CAMSO TTS 30 Series Manuel utilisateur

Luda

Luda tractorCam S Manuel utilisateur

HLA

HLA BALE KNIFE Series Manuel utilisateur

P.Lindberg

P.Lindberg 9059890 Instructions de fonctionnement

Ventrac

Ventrac KD482 Manuel utilisateur

Original Tractor Cabs

Original Tractor Cabs 4421381 Fiche technique

Grouser Products

Grouser Products 760 Manuel utilisateur

Degelman

Degelman Landroller Manuel de programmation

Bush Hog

Bush Hog BS1 Series Manuel utilisateur

MX MX A104 Manuel utilisateur

Bush Hog

Bush Hog DSP8 Manuel utilisateur