Toro 73547 Manuel
The T
oro Company – 1999
Printed in USA All Rights Reserved
FORM NO. 3321–967
SET UP
INSTRUCTIONS
MODEL NO. 73547–9900001 & UP
520Lxi GARDEN TRACTOR
Loose
Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Seat Assembly
Shoulder Bolt – 5/16”
Locknut – 5/16”
1
2
2
Installing the seat
Steering Wheel
Boot W
asher
Nut
Lock W
asher
T
rim Cover
1
1
1
1
1
Installing the steering wheel
Bolt – 1/4”-20 x .88” Long
W
asher– 1/4”
Hex Nut – 1/4”-20
2
2
2
Attaching the battery cables
Hitch Pin
Hairpin Cotter
Flat W
asher – .50” I.D.
1
1
1
Installing the drawbar hitch pin
Key 2
Use in ignition and “Key Choice” switches
Operator’
s Manual
Engine Operator
’
s Manual
1
1
Read before operating the tractor
Riding Mower Safety V
ideo 1
Attach to the tractor
“Thank Y
ou” Card
1 Mail
Set-Up Instructions
2
Installing
the Seat
1. Mount the seat to the seat base using two 5/16”
shoulder bolts and lock nuts (Fig. 1).
2. Insert the seat switch wire through the center
opening in the seat base (Fig 1).
3. Push the seat switch wire connector into the wire
harness connector
.
1
2
5
m–3453
3
4
6
Figure 1
1. Seat
2. Seat
base
3.
5/16” shoulder bolt (2)
4.
5/16” Locknut (4)
5.
Seat switch wire
connector
6.
Opening for seat switch
wire
Installing
the Steering Wheel
1. Install the boot washer onto the steering shaft
(Fig. 2).
2. Remove the plastic trim cover from the steering
wheel (Fig. 2)
3. Install the steering wheel onto the shaft,
carefully aligning the splines (Fig. 2).
Note: There is no fixed straight ahead
position on power steering models.
4. Secure the steering wheel to the shaft with a lock
washer and nut (Fig. 2). Tighten the retaining nut
to 45–50 ft–lbs.
5. Install the trim cover on the steering wheel.
m–2482
1
3
2
4
5
6
Figure 2
1. Boot
washer
2.
Steering shaft
3.
Steering wheel
4.
Lock washer
5. Nut
6. T
rim cover
Checking
Front Wheel T
oe–In
With the tractor on a level surface, check to make
sure the front wheel toe-in is between 1/8” and 1/4”.
For instructions on adjusting toe-in, refer to the
Maintenance section in Operator’
s Manual.
Set-Up Instructions
3
Check
to Insure that the
Steering Linkage is Centered
1. With the tractor on a level surface, turn the
steering wheel fully to the left and check the
clearance of the left hand spindle stop to the stop
on the front axle. There should be a slight
clearance between the stops (Fig. 3).
m–4265
1
2
3
Figure
3
1. Left
hand spindle stop
2.
Axle stop
3. Clearance
2. Repeat for the right front tire in a right turn.
3. If the stops on one side hit, and on the other side
have clearance, shorten the tie rod on the side
that hits, and equally lengthen the tie rod on the
opposite side until both sides have clearance.
Recheck the toe in.
Checking
T
ire Pressure
Check front and rear tire pressure. The correct front
and rear tire pressure is 20 psi (138 kPa).
Activating
the Battery
POTENTIAL
HAZARD
•Battery electrolyte contains sulfuric acid
which is a deadly poison and it causes
severe burns.
WHAT CAN HAPPEN
•If you carelessly drink electrolyte you could
die or if it gets onto your skin you will be
burned.
HOW TO AV
OID THE HAZARD
•Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
•Fill the battery where clean water is always
available for flushing the skin.
•Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the tractor (refer to
Removing the Battery in your tractor Operator’s
Manual).
Note: Never fill the battery electrolyte with
the battery installed in the tractor.
2. Remove the filler caps from the battery. Slowly
pour electrolyte into each cell until the
electrolyte level is up to the lower part of the
tube (Fig. 4). Use an electrolyte with a specific
gravity of 1.265.
Set-Up Instructions
4
1
2
3
1262
Figure 4
1. Filler
caps
2. Electrolyte 3.
Lower part of tube
POTENTIAL
HAZARD
•Charging battery pr
oduces gasses.
WHAT CAN HAPPEN
•Battery gasses can explode.
HOW TO AV
OID THE HAZARD
•Keep cigarettes, sparks and flames away
from battery.
3. Leave the filler caps off and connect a 3–4 amp
battery charger to the battery posts (Fig. 5).
Charge the battery at a rate of 4 amperes or less
for 4 hours (12 volts).
4. When the battery is fully charged, unplug the
charger from electrical outlet, then disconnect
the charger leads from the battery posts (Fig. 5).
4
1
23
1254
Figure 5
1. Positive
battery post
2.
Negative battery post
3.
Red (+) charger lead
4.
Black (–) charger lead
5. Slowly pour electrolyte into each cell until the
level is once again up to “UPPER” line on the
battery case (Fig. 4), then install the filler caps.
6. Install the battery in the tractor and connect the
battery cables (refer to Installing the Battery in
your tractor Operator’s Manual).
Note: Do not run the tractor with the battery
disconnected.
Installing
the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch
and secure it with a .50” I.D. flat washer and hairpin
cotter (Fig. 6).
Set-Up Instructions
5
2
1
3
m–2481
4
Figure 6
1. Drawbar
hitch pin
2.
Drawbar hitch
3.
.50” Flat washer
4.
Hairpin cotter
Checking
the W
iring and
Fasteners
•Inspect the tractor for any loose electrical
connections and secure them as required. Check
the wire routing to make sure moving parts do
not interfere with wires and cause a short.
•Assure all fasteners are tight.
Burnishing
the Clutch
The following break–in procedure must be performed
as part of predelivery service or when a new clutch is
installed.
Note: There must be a PTO driven
attachment installed to provide a load
in order to burnish the clutch facings
properly.
1. Run the engine at full throttle and engage the
clutch bringing the load to full speed. Then
disengage the clutch.
2. Let the load come to a full stop, then engage
again.
3. Repeat these procedures (1 and 2) 5 times.
Test
Driving the T
ractor
1. Check the oil level in the crankcase (refer to
Engine Oil in your tractor Operator’s Manual for
oil type, viscosity and crankcase capacity).
2. Check the oil level in the transaxle (refer to
Transaxle Fluid in your tractor Operator’s
Manual for oil type, viscosity and capacity).
3. Check the coolant level in the coolant recovery
tank.
4. Check to make sure all lubrication points have
been greased as shown in the Maintenance
section of tractor Operator’
s Manual.
5. Fill the tank with unleaded regular gasoline with
an octane rating of at least 85. Open the fuel
shutoff valve and check the fuel hose and fittings
for leaks.
6. As applicable, check and test the operation of the
following:
•Engine, choke and throttle controls
•Gauges
•
Headlights and taillights
•Indicator lights
•PTO clutch and brake
•Lift system
•Service and parking brakes
•T
ransmission controls
•Steering
•Tractor operation in forward and reverse
7. Test the operation of the safety interlock system
(refer to the tractor Operator’s Manual for the
correct procedure).
Table des matières
Autres manuels Toro Tondeuse à gazon
Toro
Toro 20831 Manuel utilisateur
Toro
Toro Z Master G3 Manuel
Toro
Toro TurfMaster 22207 Manuel utilisateur
Toro
Toro TimeCutter MX 5075 Manuel utilisateur
Toro
Toro 30314TE Manuel utilisateur
Toro
Toro 30031 Manuel utilisateur
Toro
Toro SUPER RECYCLER 20055 Mode d’emploi
Toro
Toro Z MASTER Z557 Manuel utilisateur
Toro
Toro 73570 Manuel
Toro
Toro Recycler 20954 Manuel utilisateur
Toro
Toro 74401 Manuel utilisateur
Toro
Toro 20333 - BBC Personal Pace Walk Power Mower Mode d’emploi
Toro
Toro Super Recycler 20792 Manuel utilisateur
Toro
Toro 30821 Manuel utilisateur
Toro
Toro Recycler 20349 Manuel utilisateur
Toro
Toro Greensmaster eTriFlex 3360 Manuel utilisateur
Toro
Toro 74253CP Manuel utilisateur
Toro
Toro Greensmaster TriFlex 3300 Manuel utilisateur
Toro
Toro 44409 Manuel utilisateur
Toro
Toro 74661 Manuel utilisateur
Manuels Tondeuse à gazon populaires d'autres marques
RHINO
RHINO 1958 Manuel utilisateur
Wolf Garten
Wolf Garten Compact plus 40 B Manuel utilisateur
Cub Cadet
Cub Cadet LTX 1045 Manuel utilisateur
Craftsman
Craftsman 917.378461 Manuel utilisateur
GGP ITALY SPA
GGP ITALY SPA CR/CS 434 SERIES Manuel utilisateur
Challenge
Challenge CH18V2 Instructions de fonctionnement
TALEN TOOLS
TALEN TOOLS AVR HGM30 Manuel utilisateur
DEWEZE
DEWEZE ATM-725 Manuel d'utilisation
Weed Eater
Weed Eater 180083 Manuel utilisateur
Husqvarna
Husqvarna Poulan Pro PP185A42 Manuel utilisateur
Better Outdoor Products
Better Outdoor Products Quick Series Manuel utilisateur
Cub Cadet
Cub Cadet 23HP Z-Force 60 Manuel d'utilisation
