Topfield CBC-5200 Manuel utilisateur
CBC - 5200
User Guide
Digital Cable Receiver
CONAX
Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer or sold with
the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to
avoid injury from tip-over.
•
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
•
The mains plug, which is used as a disconnect device,
shall remain readily operable.
The lightning flash with arrowhead symbol, within an
equilateral triangle, is intended to alert the user to the
presence of uninsulated “dangerous voltage” within the
product’s enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to a person.
The exclamation point, within an equilateral triangle, is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the product.
iv CONTENTS
Contents
Contents iv
1 Introduction 1
1.1 Features ............................... 1
1.2 Controlling the digital receiver .................. 2
1.2.1 The front panel ....................... 3
1.2.2 The remote control ..................... 4
2 Setup 6
2.1 Unpacking .............................. 6
2.2 Safety precautions ......................... 6
2.3 Rear panel connections ....................... 8
2.4 Connecting up your digital receiver ............... 9
2.4.1 Connecting to the broadcasting cable .......... 9
2.4.2 Connecting to your television set ............ 9
2.4.3 Connecting to your video cassette recorder ....... 11
2.5 Inserting batteries in the remote control ............. 11
2.6 Switching on for the first time ................... 12
2.6.1 Powering on and checking picture ............ 12
3 Preference Settings 13
3.1 Language settings .......................... 13
3.2 Video and audio settings ...................... 14
3.2.1 Television standard .................... 14
3.2.2 Colour model ........................ 15
CONTENTS v
3.2.3 Video cassette recorder .................. 15
3.2.4 Television aspect ratio ................... 16
3.2.5 Audio mode ........................ 16
3.3 Local time setting .......................... 17
3.4 Parental control ........................... 19
3.5 Adjusting the On-Screen Display ................. 20
4 Service Search 22
4.1 Searching broadcasting services .................. 22
4.2 Resetting to factory settings .................... 23
5 Daily Usage 25
5.1 Volume control ........................... 25
5.2 Watching television ......................... 25
5.2.1 The services list ....................... 25
5.2.2 The favourite services list ................. 26
5.2.3 Viewing programme information ............ 28
5.2.4 Selecting audio tracks ................... 29
5.2.5 Selecting subtitle tracks .................. 29
5.2.6 Viewing teletext ...................... 29
5.3 Viewing electronic programme guide .............. 29
5.4 Watching multifeed programme ................. 31
5.5 Making timer events ........................ 31
6 Listing Services 34
6.1 Editing the services list ....................... 34
6.2 Editing the favourite list ...................... 36
6.3 How to use on-screen keyboard .................. 38
6.4 Transferring receiver data ..................... 38
7 Firmware Update 40
7.1 Checking the firmware information ............... 40
7.2 From your computer via RS-232 port ............... 42
7.3 From another digital receiver via RS-232 port .......... 43
Index 44
1
Chapter 1
Introduction
The CBC - 5200 digital receiver is fully compliant with the inter-
national Digital Video Broadcasting (DVB) standard, and thus
is able to receive digital broadcasts of that standard.
NOTE
In general we equate a channel with a frequency. However,
unlike analogue broadcasts, digital broadcasts are not all as-
signed to their own frequencies; instead, multiple television
broadcasts are transmitted through a single frequency. The fre-
quency in digital broadcasting is usually called transponder. To
reduce confusion in this manual, the word
service
is preferably
used than
channel
as a term to indicate one television or radio
broadcast.
1.1 Features
The CBC - 5200 digital receiver has the following features:
• Can store up to 2000 television and radio services.
• You can edit the services list.
2 Introduction
• Can create favourite lists of your favourite services.
•
Can view information about the current television or
radio programme.
•
Has an electronic programme guide that provides an
overview of scheduled programmes.
1.2 Controlling the digital receiver
You can operate the digital receiver with the remote control or
the buttons on the front panel.
NOTE
When the digital receiver is off but plugged into a wall outlet,
we say that it is in standby mode; on the other hand, when it is
on, it is in operation mode. Even when you are not using the
digital receiver, you should keep it plugged into a wall outlet
to be in standby mode so that it can run timer events at any
time.
1.2 Controlling the digital receiver 3
1.2.1 The front panel
The front panel of the digital receiver has buttons to control
the digital receiver, specific lamps and a display to indicate its
status. The following indicates what they mean.
Front display
shows the current time in standby mode, and
displays the current service in operation mode.
button switches the digital receiver between standby
mode and operation mode.
CHANNEL
c
,
a
buttons switch to previous or next service.
They are also used to navigate in menus and interactive
screens.
STANDBY
lamp lights up while the digital receiver is in
standby mode.
MESSAGE lamp is not used.
IR/RADIO
lamp blinks whenever you press a button on the
remote control.
You have to insert your subscription card into the front slot to
watch pay services.
4 Introduction
1.2.2 The remote control
1
button switches the digital re-
ceiver between standby mode and
operation mode.
2
mutes the sound. Press again to
switch it back on.
3
Numeric buttons are used to enter a
service number for service change or
to specify values for menu options.
4
switches between the current ser-
vice and the previously viewed one.
5
FAV displays the favourite lists.
6
MENU
displays the main menu. It is
also used to return to the previous
menu from a submenu.
7
EXIT
is used to exit a menu or to hide
on-screen info.
8
EPG
displays the electronic pro-
gramme guide.
9
displays the service information
box. It is also used to display more
information about a programme.
10
c
,
a
buttons switch to previous or
next service. They are also used to
navigate in menus and interactive
screens.
11
b
,
d
buttons decrease or increase the volume. They are
also used to change values for menu options.
12
OK
displays the services list. See
§
5.2.1 for more details.
Autres manuels pour CBC-5200
1
Table des matières
Autres manuels Topfield Récepteur
Topfield
Topfield TF 6000 PVRt Manuel utilisateur
Topfield
Topfield TRF-7260 Manuel de service
Topfield
Topfield TF 400 PVRt Manuel utilisateur
Topfield
Topfield TF 7710 HSCI Manuel utilisateur
Topfield
Topfield TF-T6000 Manuel de service
Topfield
Topfield TRF-7260 Manuel utilisateur
Topfield
Topfield TF 5800 PVR Manuel utilisateur
Topfield
Topfield TF 500 PVRc Manuel utilisateur
Topfield
Topfield TBF-100HD Manuel utilisateur
Topfield
Topfield TF 7010 HT Manuel utilisateur
Topfield
Topfield TF 6000 Fe Manuel utilisateur
Topfield
Topfield TF 5200 PVRc Manuel utilisateur
Topfield
Topfield TF 6060 CI Manuel utilisateur
Topfield
Topfield Digital Satellite Receiver TF 6000 PVR Manuel utilisateur
Topfield
Topfield SBP-2070 Manuel utilisateur
Topfield
Topfield TF6000T Manuel utilisateur
Topfield
Topfield TF 7700 HSCI Manuel utilisateur
Topfield
Topfield TF 7720 HSIR Manuel utilisateur
Topfield
Topfield TF 5100 PVR Manuel utilisateur
Topfield
Topfield TRF-7170 Manuel utilisateur
