Topcraft 09
CE DECLARATION OF CONFORMITY (GB)
We declare under our sole responsibility that
TTS-280 TRIANGULAR SANDER
is in conformity with the following standards or standardized documents:
EN50144-1, EN50144-2-4, EN55014-1, EN-55014-2,EN61000-3-2, EN61000-3-3,
in accordance with the regulations.
98/37EC, 73/23/EEC, 89/336EEC
from 01-10-2006
ZWOLLE NL
J.A. Bakker - van Ingen J. Lodewijk
CEO Ferm BV Quality Manager Ferm Global
It is our policy to continuously improve our products and we therefore reserve the right to
change the product specification without prior notice.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • The Netherlands
GB
04 Topcraft
7. Use right tool.
Do not force small tools or attachments to do the job of heavy duty tool. Do not use a tool
for purposes not intended.
8. Dress properly.
Do not wear loose clothing or Jewellery. They can be caught in moving parts. Rubber
gloves and nonskid footwear are recommended when working outdoors. Wear protective
hair covering to contain long hair.
9. Use safety glasses.
Also use face or dust mask when operation is dusty.
10. Connect dust extraction equipment
If devices are provided for the connection of dust extraction and collection facilities
ensure these are connected and properly used.
11. Do not abuse cord.
Never carry tool by cord or yank it to disconnect it from electrical socket. Keep cord from
heat, oil and sharp edges.
12. Secure work.
Use clamps or a vice to hold work. It’s safer than using your hand and it frees both hands to
operate tool.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep tools sharp and clean for better and safer performance. Follow instructions for
lubricating and changing accessories. Inspect tool cords periodically and, if damaged,
have repaired by authorized service facility. Inspect extension cords periodically and
replace if damaged. Keep handles dry, clean and free from oil and grease.
15. Disconnect tools.
When not in use, before servicing and when changing accessories such as blades, bits
and cutters.
16. Remove adjusting keys and wrenches.
Form the habit of checking to see that keys and adjusting wrenches are removed from tool
before turning it on.
17. Avoid unintentional starting.
Do not carry plugged-in tools with finger on switch. Be sure switch is off when plugging in.
18. Outdoor use extension cords.
When tool is used outdoors, use only extension cords intended for use outdoors and so
marked. Always use tool in conjunction with a residual circuit breaker device.
19. Stay alert.
Watch what you are doing. Use common sense. Do not operate tool when you are tired.
20. Check damaged parts.
Before further use of the tool, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A guard or other part
that is damaged should be properly repaired or replaced by an authorized service centre
unless otherwise indicated elsewhere in this instructions manual. Have defective
switches replaced by an authorized centre. Do not use tool if switch does not turn on and
off.
21. Warning.
GB
