Titon TP325 Manuel utilisateur

ventilation systems

First Fix Base

Product Manual

TP325

Warnings, Safety information and

Guidance

Important Information

Important: read these instructions fully before the

installation of this appliance

1. Installation of the appliance and accessories must be carried

out by a qualied and suitable competent person and be car-

ried out in clean, dry conditions where dust and humidity are

at minimal levels.

2. All wiring must conform to current I.E.E. Wiring Regulations

and all applicable standards and Building Regulations.

3. The appliance must be connected to a local double pole

isolation switch with a contact separation of at least 3mm.

Ideally located adjacent to the unit.

4. The appliance must be earthed.

5. Seperate cables must be used for power and boost control.

6. Units are suitable for 230V ~ 50/60Hz single phase with a

fuse rating of 3A.

7. Q Plus models - Boost cable - Unshielded 4 Core 18-24AWG

Stranded, Tinned Copper.

8. Boost cables should not be placed within 50mm or on the

same metal cable tray as any 230V lighting or power cables.

9. The unit must be stored in a clean and dry environment.

10. Do not install the appliance in areas where the following may

be present or occur;

• Excessive oil or a grease laden atmosphere,

• Corrosive or ammable gases, liquids or vapours,

• Ambient temperatures above 40°C or below -5°C,

• Humidity levels above 90% or is a wet environment.

11. The appliance is not suitable for installation to the exterior of

the dwelling.

12. This appliance can be used by children aged from 8 years and

above and persons with reduced physical, sensory or mental

capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning use of the

appliance in a safe way and understand the hazards involved.

13. Children should be supervised to ensure that they do not

play with the appliance.

14. Ensure that external grilles are located away from any ue

outlet, in accordance with relevant Building Regulations.

15. The unit must not be connected to a tumble dryer.

16. The unit must not be connected to a cooker hood.

17. Precautions must be taken to avoid the back-ow of gases

into the room from an open ue appliance.

18. Ensure all ducting,is free from debris and blockages before

switching on the unit.

Warnings, Safety information and Guidance

Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2

Product Overview

Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6

Component Identication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7

Packaging Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8

Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9

Installation

Fixing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10

Ducting Connections. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

How to Convert Port Cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13

Wiring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

Cable Entry Position. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

CME1 TP350 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14

CME1 Q Plus TP301A/301HA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

CME2 &2.1 Q Plus TP303A/303HA TP 303A/303HA/TP313A/TP313HA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

CME2 & 2.1 Q Plus LS TP305HA/TP313HALS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21

CME2.1 Q Plus TP313CH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .25

Contents

Product Overview

This booklet is required for the rst part of a two stage installation of one of the

following Units:

CME1 TP350

CME1 Q Plus TP301A

CME1 Q Plus TP301HA

CME2 Q Plus TP303A

CME2 Q Plus TP303HA

CME2.1 Q Plus TP313A

CME2.1 Q Plus TP313HA

CME2 Q Plus LS TP305HA

CME2.1 Q Plus LS TP313HALS

CME2.1 Q Plus TP313CH

The installer must be aware which specic model has been specied before

commencing installation.

CME1 TP350

CME1 Q Plus TP301A/301HA

CME2 & 2.1 Q Plus TP 303A/303HA/TP313A/TP313HA

CME2 & 2.1 Q Plus LS TP305HA/TP313HALS

CME2.1 Q Plus TP313CH

have dierent wiring requirements.

Ensure the correct wiring diagram is used for the installation.

The unit may be damaged if wired incorrectly.

The installer of the second stage will receive further documentation to complete

the installation and commissioning.

Dimensions

This diagram details the overall size of the unit and the additional space required

around the unit to allow for commissioning and future servicing and maintenance.

450

421

355

390

252

550

450

590

Service Void

All dimensions in mm

Component Identication

Base

Cover / Scroll / Inlet Ring assembly

Supplied as second x.

Packaging Contents

Inspect the unit when taking delivery. Check the unit for damage and that all

accessories have been supplied. The box contains:

CME Base x 1.

Port covers x 3.

This Product manual x 1.

All shortages or damage must be immediately reported to the supplier.

Notes

Installation

Fixing

1. The unit must be securely xed to a

smooth at surface, any orientation

is possible.

2. Mark the four xing hole centres

using the Base as a template.

3. Drill holes for xings, use 4mm

Pan Head screws. Always use a

xing type and length suited to

the substrate type. The unit weighs

approximately 5kg.

4. Mount the Base, ensuring it is not

distorted by the xings or mounting surface.

5. Clip the Motor and Lid assembly to the Base, ensure that all 6 clips have

engaged.

Tighten screws by hand, DO NOT over tighten screws or use power tools.

260

EXTRACT

PORT

Table des matières

Autres manuels Titon Ventilateur

Titon

Titon TIFC100HT Manuel utilisateur

Titon

Titon HRV1.25 QPtus ECO Manuel utilisateur

Titon

Titon HRV10 Q Plus Manuel utilisateur

Titon

Titon Titon Ultimate dMEV Manuel utilisateur

Titon

Titon CME2 Q Plus LS Manuel utilisateur

Titon

Titon CME1 Q Plus Manuel utilisateur

Titon

Titon H200 Manuel utilisateur

Titon

Titon TP221T Manuel utilisateur

Titon

Titon CME2.1 Q Plus TP312CH Manuel utilisateur

Titon

Titon CME3.1Q+ Manuel utilisateur

Titon

Titon HRV1.25 Q Plus ECO Manuel utilisateur

Titon

Titon MVHR Manuel utilisateur

Titon

Titon TP406HMB Manuel utilisateur

Titon

Titon TP302A Manuel utilisateur

Titon

Titon CME2Q+ Manuel du propriétaire

Titon

Titon TP461BC Manuel utilisateur

Titon

Titon CME MEV Manuel utilisateur

Titon

Titon CME1 Manuel utilisateur

Titon

Titon HRV1.25 Q Plus ECO Instructions d'installation

Titon

Titon Vent Trex Manuel utilisateur

Titon

Titon SF Xtra Vent Series Manuel utilisateur

Titon

Titon TP408HMBE Manuel utilisateur

Titon

Titon Solace TP200/RT Manuel utilisateur

Titon

Titon PIV L3 Manuel utilisateur

Manuels Ventilateur populaires d'autres marques

ELTA FANS

ELTA FANS H03VV-F Manuel utilisateur

Hunter

Hunter 20714 Manuel d'instructions

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manuel utilisateur

Hunter

Hunter Caraway Manuel d'instructions

Panasonic

Panasonic FV-15NLFS1 Manuel utilisateur

Kompernass

Kompernass KH 1150 Manuel utilisateur

VES

VES FALA100/12V/TR Manuel utilisateur

Vertiv

Vertiv Liebert DCD Manuel utilisateur

Westinghouse

Westinghouse GFP Series Manuel utilisateur

Venmar

Venmar KUBIX HRV PLUS Series Manuel utilisateur

Maico

Maico ECR 31 Manuel utilisateur

Sonnenkonig

Sonnenkonig Dinky Manuel utilisateur

S&P

S&P ECOWATT HXBR Manuel utilisateur

Wider

Wider IMP03369BH Manuel utilisateur

Panasonic

Panasonic F-60DHN Manuel utilisateur

Hinkley

Hinkley HIGHLAND Manuel utilisateur

Broan

Broan 766BN Manuel utilisateur

Premium

Premium PFS16022 Instructions de montage