thomann Millenium MPS-600 Manuel utilisateur
MPS-600
e-drum set
assembly instructions
Musikhaus Thomann
Thomann GmbH
Hans-Thomann-Straße 1
96138 Burgebrach
Germany
Telephone: +49 (0) 9546 9223-0
E-mail: [email protected]
Internet: www.thomann.de
20.07.2015, ID: 230833
Table of contents
1 Safety instructions.......................................................................................................................................................................................................... 4
2 Contents of package....................................................................................................................................................................................................... 5
3 Assembly.............................................................................................................................................................................................................................. 7
4 Protecting the environment.................................................................................................................................................................................... 13
Table of contents
MPS-600
3
1 Safety instructions
DANGER!
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children.
Choking hazard!
Ensure that children do not detach any small parts (e.g. knobs or the like) from the unit. They could swallow the pieces and
choke!
Never let children unattended use electrical devices.
Safety instructions
e-drum set
4
2 Contents of package
Rack components
Before you assemble your kit, make sure the contents of package is complete according to the following illustrations.
Content of the box ‘Accessory’
Content of the boxes ‘Drum Module’ and ‘11''-Drum Pads’
Contents of package
MPS-600
5
Content of the box ‘Kick Pad and 9''-Drum Pads’
Content of the boxes ‘Bass Drum Pedal’ and ‘Hi-Hat Pedal’
Content of the boxes ‘Cymbal 14''’ and ‘Cymbal 12''-Crash, 12''-Hi-Hat’
‘Pillar Box’
Without illustration. This box contains the little left side arm of the rack.
The boxes ‘Empty Box A/B/C’ are empty and just serve as packaging material.
The rack components are located in individual compartments at the bottom of the packaging carton.
Contents of package
e-drum set
6
3 Assembly
Assembling the rack
Loosen the screws of each terminal with the drum key before inserting the pipes. The positions of the pads, cymbals, etc. are
shown in the table below.
CAUTION!
Danger of cuts on hands and fingers
When plugging the connections, take care for sharp edges on the metal pipes.
Assembly
MPS-600
7
1. Connect the centre pipe (1) with the upper terminal and the centre pipe (2) with the lower terminal of the (L1).
2. Roughly align the height of the terminals on pipe (L2) according to the height of their counter-terminals on pipe (L1). Con‐
nect the centre pipe (1) to the upper terminal and connect the centre pipe (2) to the lower terminal on pipe (L2).
3. Tighten the screws of the four terminals with the drum key evenly hand-tight.
4. Connect the side arm (L1) with the terminal on pipe (L2) and tighten the screws of the terminal with the drum key evenly
hand-tight.
5. Connect the side arm (R) with the terminal on pipe (R2) and tighten the screws of the terminal with the drum key evenly
hand-tight.
Assembly
e-drum set
8
6. Connect the side arm (L1) with the terminal on pipe (L1) and tighten the screws of the terminal with the drum key firmly
and evenly hand-tight.
7. Connect the side arm (R) with the terminal on pipe (R1) and tighten the screws of the terminal with the drum key firmly and
evenly.
8. Connect the short side arm (L2) with the terminal on pipe (L1) and tighten the screws of the terminal with the drum key
firmly and evenly.
9. Position the rack horizontally and vertically to suit your needs and tighten all terminal screws with the drum key evenly.
Assembly
MPS-600
9
Mounting pads on the rack
1. Attach the supplied L-pieces (box "Accessory") to the five pads. First, tighten the wing nuts on the pads by hand.
2. Then slide the plastic ends of the L-pieces up to the stop into the designated terminals on the rack, see
Ä
‘Assembling the
rack’ on page 7.
3. Align the pads on the rack to meet your needs, then tighten the wing nuts of the pad brackets and the bolts of the pad
terminals on the rack evenly.
Mounting cymbals on the rack
Assembly
e-drum set
10
Autres manuels pour Millenium MPS-600
2
Table des matières
Autres manuels thomann Tambour
thomann
thomann Millenium Drums Mobile Drum MD-100 Manuel utilisateur
thomann
thomann Millennium Drums Rookie Manuel utilisateur
thomann
thomann Millenium MPS-100 Manuel utilisateur
thomann
thomann millenium mps-150 Manuel utilisateur
thomann
thomann Millenium R1 Manuel utilisateur
thomann
thomann MILLENIUM MPS-425 Manuel utilisateur
thomann
thomann Millenium HD-100 Manuel utilisateur
thomann
thomann HITMAN HD-30 Marauder Manuel utilisateur
thomann
thomann millenium Manuel utilisateur
thomann
thomann millenium mps-150 Manuel utilisateur
thomann
thomann Millenium MPS-1000 Manuel utilisateur
thomann
thomann Millenium MPS-500 Manuel utilisateur
thomann
thomann MILLENIUM MD-90 Manuel utilisateur
thomann
thomann mps-250 USB Manuel utilisateur
thomann
thomann Hitman HD-7 Sonic Manuel utilisateur
thomann
thomann Millenium Transformer E-A Manuel utilisateur
thomann
thomann Millenium MPS-600 Manuel utilisateur
thomann
thomann MILLENIUM MD-90 Manuel utilisateur
thomann
thomann Millenium MPS-750X Manuel utilisateur
thomann
thomann EPS-100 Manuel utilisateur
