GENERAL
Thank you for choosing the Teqball One table. We would like to give you some advice for
the assembly. Please read and follow these instructions carefully.
SAFETY NOTICE
ASSEMBLY
The Teqball One table must be assembled by at least two adults following the numerical
order of the assembly instructions. Before assembling, please check that all the proper parts
are contained in the packages. The indicated quantities of parts make it possible to go
through the assembly stages. Use the tools recommended on page 5.
IMPORTANT: Assembly should be carried out on a clean, dry, level surface. Please ensure
there is nothing on the oor that could scratch the tabletop. During the assembly put the
packages to the ground and hold the parts above them to prevent the damage that is
caused by falling or impact. During assembly remove the protection foil from the PMMA net
and from the tabletop.
Any person handling or using the Teqball One table must follow the instructions as
described in this document. The person in charge of assembling and using the Teqball
One table must ensure that the recommendations for use given in this document and in
the Owner's Manual of the Teqball One table are seen by all users. In communal use, it is
strongly recommended that the instructions and diagrams are displayed.
Only use the Teqball One table after it has been fully assembled and after checking that
the screws are tightened properly. Later, depending on frequency of use (but at least
twice a month) check all screws regularly to ensure that their condition is good. The
fasteners are coated with adhesive which is inactive until the coated fasteners are used.
During assembly the adhesive is activated. The adhesive can prevent the self-loosening
of fasteners, but the eect of the adhesive decreases with every assembly. Please do not
remove the adhesive from the fasteners.
Assembly must be carried out at least by two adults during all stages.
2
