TDR Eco Pro Manuel utilisateur
Initial Setup Attaching the bottle holder
Installing the polish and water
Removing the polish nozzle caps
Contents
Installing the chip
Powering up the machine
Setting up your machine
Locating the machine
Please keep packaging in case the machine needs to
be returned at any point.
1. Open box and lift out machine 2. Carefully remove contents
The contents of the box is listed on the back of this
sheet. Please check to make sure that the contents
are complete. If you have any queries with the
content please contact Technical Support, Monday to
Friday, 9am to 5pm on:
Your Eco Pro is designed so that you can set it up
quickly and start using it right away. Here are
the key tasks to complete before you turn on your
machine:
Place the machine on a
sturdy, flat surface near
a power socket.
Start by removing the thumbscrew on the back of the
machine. Locate the two hooks on the bottle holder
into the slots on the back of the machine, slide the
bottle holder to the left and then use the thumbscrew
to secure the bottle holder in place.
1. Remove the caps from the two bottles and store.
2. Hang the polish bottle on to the left slot on the
bottle holder (looking at it from the back).
3. Hang the water solution bottle on to the right slot
on the bottle holder.
4. The cap with the green text attaches to the polish
bottle, but you must remove the small black
rubber cap from the pipe first.
5. The cap with the blue text attaches to the water
solution bottle.
5. Ensure that the tubes reach the bottom of both
bottles.
There are two more black rubber caps on the polish
nozzles, inside the machine, that must be removed
before using the machine. It is not necessary to
keep these as they are only designed to prevent the
polish from drying out in storage
Locate the chip card
and install as shown
here
Once you have set up your machine you are ready
to repair your first disc. Plug the machine into a
grounded power outlet and switch on the mains
socket switch. Then switch the machine on using the
red power switch on the front of the machine.
The machine will bleep and the lid will open
automatically.
Now refer to the user guide in the information pack
for instructions on repairing your first disc.
0800 412 5424
Unpacking the machine
ne
2 Carefully remove contents
machine
on
a
a
t surface near
s
ocket.
Water
solution
Polish
Nozzle
cap 1
Nozzle
cap 2
* The slots are
different sizes
and cannot be
confused.
Initial Setup
Machine box contents
Machine
Key card
(300 mins)
Bottle of polish compound
(100ml) Bottle holder
Power lead
2 x Polishing pads
(Installed in the machine)
User guide
Bottle of water solution
(100ml) Cleaning cloth
Machine
box
contents
Machine
Bottle of water solution
B
ottle of
p
olish com
p
oun
d
(
100ml
)
Autres manuels TDR Autre
