. Error Messages
(1) B
rok
en Detection Terminal Indi
catio
n
If the detection terminal of the probe gets broken or the probe is not
connected, "Err"is indicated on the display as in the right figure. [-
Err
I
If so indicated, replace or connect the probe.
(2) Over R
ang
e I
ndi
cation
If the temperature being measured goes beyond the measurable range,
"or" or "-or" is indicated on the display.
C
~
• This indication may appear when the detection terminal of the probe is
almost broken. If it is clear that the temperature being measured is I - or I
within the measurable range, check the probe. In addition, if the
instrument reading abnormally fluctuates, check the probe.
(3) Low Battery Indication I • :JU 9I
If the battery voltage gets low, the low battery voltage indication Ii! Will C
-'0
°C
flash with 5 hours of life left.
In addition, the whole display is programmed to blink with 30 minutes of lifo lelt.
• The duration of the low battery voltage indication varies depending on Ihe battery type and
environment.
(4)
Troubleshootinq
If you have found a problem with the display or features, usc II thin stick to press tho reset button
located on the battery compartment.
Pressing the reset button will reset the unit to the same selling as it has just beon turnod ON.
~
[:
"""
" 1
,.- __,. -- -
'
~
"!Bi
I::
I
'
~
:"
,a.= - ;:':::::'
"::
~
@ 10
ill>
~
ill>
@ •
_
.
~
-
Reset button
• If the unit will not operate properly even after pressing the reset button, tho urlll may have been
damaged. In such a case, contact your authorized dealer.
[5. How to Place the
Prob
~
Place the probe perpendicular to the contact surface or
facing to the direction wind is coming from. In addition,
note that the unit will not operate properly if the surface is
rough or uneven.
• Before measurement, check the measurable range of
the probe. If you measure a temperature beyond the
range, there is a risk of failure and/unexpected injury.
o
~
~
o
"'"
16.
Maintenanc
~
(1)
Storage
When you store the unit, avoid such places as follows:
• Place exposed to direct sunlight
• Place that oscillates violently
• Place where the humidity is high (above 80%R.H )
• Hot atmosphere (above 50' C)
• High electromagnetic field
(2) If the Housi ng Gets Dirty
Ii the housing gets dirty, immerse a shop towel in water or oil to wipe the housing. The housing is
made of ABS resin. Do not use organic solvents such as thinner, benzine and alcohol. These
solvents may deform and/or discolor the housing and keyboard
5 6
