TAAG TK-JS Manuel utilisateur
1
WARRANTY
All new machines are sold with a one-year limited warranty, on factory defective parts. The
warranty is limited to the original user. TAAG Machinery Co. at its option, will repair, replace or
refund the purchase price of any part, tool or machine that fails during the warranty period.
TAAG Machinery Co. will pay normal shipping charges for replacement parts. After 90 days
from date of purchase, all express or overnight delivery charges are the responsibility of the
customer. Purchaser must deliver to TAAG Machinery Co., at the address below, any written
claim, with proof of original purchase. Replacement parts will be invoiced to purchaser and
credit issued when the failed part is delivered to TAAG Machinery Co. Removal, reinstallation
or replacement parts shall be at purchasers’ / user’s expense. Failure due to improper use of the
machine voids the warranty.
NOTE:
1. This machine has been tested and adjusted prior to shipment, but can and often does require
readjustment due to vibration and bouncing during transport. Following the procedures described
within can easily readjust. These are procedures with which you, as a user, should be familiar, as
you will use them repeatedly over the life use of the machine. If you have difficulty in
performing these procedures, we are here to support you. Call us at: (800) 640-0746.
2. Opening rolls (for Philipsburg Lock) are consumable items and not subject to warranty
SPECIFICATIONS
Maximum Capacity:
Galvanized/Stainless steel: 26 Gauge
Aluminum: 22 Gauge
Table top height
or working surface height
34"
Maximum Bulk Roll Weight Capacity
400 lbs.
Maximum Dimensions
L55" x W74" x H70"
Approximate Shipping Weight
650 lbs.
2
RECEIVING THE MACHINE
Upon receipt and before signing the Bill of Landing carefully examine the machine for damage
that may have occurred during shipping. Be certain you have two handles. Any loss or damage
should be noted in detail on the delivery receipt and reported to your distributor immediately.
Free replacement from TK International is dependent upon the notation and the Bill of Landing
on delivery slip.
SAFETY PRECAUTIONS
•The blade is sharp and can easily cause injury if used incorrectly.
•Never operate the shear without the cage guard in place.
•When performing maintenance on the shear without the cage guard in place, block
the shear blade up or, if the spring is removed, tie the blade down to avoid
accidental injury.
REPLACEMENT PARTS
Part No.
Name
JS001
Spring
JS002
Top Blade
JS003
Bottom Blade
JS004
Roll Support (mandrel)
JS005
Safety Guard
3
ASSEMBLY
The TK Jacketing Shear will come with mostly assembled. To save shipping volume, the legs,
horizontal supports, spring, spring support, and cage do not come pre-installed
1. Install legs and horizontal supports.
a. The table top will be delivered upside down
b. While the table top is upside down match the legs with their corresponding
numbered corners 1,2,3, & 4.
c. There will be numbered stickers and/or stamped numbers on the legs, horizontal
supports, and the table top
d.
e. Bolt the all four legs to the table top
f. Bolt horizontal supports to legs
2. Flip the table over
a. This is typically at least a two-person job
3. Install the cage and spring support
a. The cage attaches directly to the table top with four bolts, two on each side.
b. The spring support is attached to the #2 leg with two bolts
4. Install the spring
a. Untie the blade from the table top
b. Swing the blade to the topmost position
c. Hook the spring on the blade’s middle hole
d. Hook the spring on the spring support’s middle hole
e. Adjust the spring tension by changing holes.
4
3
1
2
Table des matières
Autres manuels TAAG Outils électriques
