Sylvania SKCR2613 Manuel utilisateur
UNDERCOUNTER CD RADIO
MODEL NO. SKCR2613
OWNER'S MANUAL
PLEASE READ BEFORE OPERATING THIS EQUIPMENT
1
2
3
4
CLOCK BACKUP BATTERIES
Install Batteries AAA x 2pcs (for clock backup)
Before installing batteries (not included), ensure that this product is disconnected
from the mains supply.
Remove the battery compartment cover on the back of the unit by carefully
pushing the one lug down. The battery cover can then be lifted away.
Fit 2 sets batteries AAA size (not included), referring to the polarity markings.
Finally, replace the cover.
CAUTION : Danger of explosion if batteries are incorrectly replaced. Replace only
with the same equivalent type.
NOTES FOR REMOTE CONTROL
To install or replace the battery:
1. Pull the battery tray out of the remote.
2. If you are replacing the battery, remove the old
battery and dispose of it properly. Note the
orientation of the + and - sides of the battery.
3. Insert the new battery into the battery tray,
orienting it the same way the old battery was
placed.
4. Close the battery tray.
Warning
There is danger of an explosion if you replace the battery incorrectly. Replace only
with the same or equivalent battery. You may need to remote protective covering
from the remotes battery compartment before using the remote control.
5
LOCATION OF CONTROLS
Front Panel Controls
Controls
1. CD TRAY
2. TIMER Button 11. RANDOM Button
12. PROG./CLK SET Button
3. SKIP/SEARCH/MINUTE/HOUR Buttons 13. DISPLAY Button
4. PLAY/PAUSE Button 14. LCD Display
5. VOLUME UP/DOWN Buttons 15. Remote Sensor Window
6. OPEN/CLOSE Button 16. POWER Button
7. FUNC(function) Button 17. Batteries Compartment for
clock backup
8. STOP/BAND Button
9. REPEAT Button 18. AUX In
10. TUNING Dial 19. AC Cord
20. FM Wire Antenna
6
LOCATION OF CONTROLS
Remote Controls
NOTES: You may need to remote protective covering from the remotes battery
compartment before using the remote control. Point the remote control toward the
remote sensor window on the pane of the main unit.
Controls
21. POWER Button 28. FUNC(function) Button
22. DISP(display) Button 29. OPEN/CLOSE Button
23. SKIP/SEARCH/MIN(minute) Button 30. PLAY/PAUSE Button
24. REPEAT Button 31. TIMER Button
25. STOP/BAND Button 32. SKIP/SEARCH/HR(hour) Button
26. PROG./CLK SET Button 33. VOLUME UP/DOWN Buttons
27. RANDOM Button
7
21
22
23
24
25
26
27
28
29
30
31
32
33
OPERATION INSTRUCTIONS
Checking FM /AM Radio Reception
This product has a built-in antenna for AM radio. To improve reception, you need to
rotate or move other place to your unit.
Unwind the external FM wire antenna and extend it to its full length to improve the
FM reception.
Unpacking and Set Up
Remove the main unit, and the remote control unit from the display carton.
Remove all packing materials from the components.
Unwind the AC power cord and extend it to its full length.
Unwind the external FM wire antenna and extend it to its full length.
Placement of the unit
The system should be placed on a stable, convenient to an AC outlet, away from
direct sunlight, and sources of excess heat, dust, moisture, humidity, vibration or
strong magnetic fields.
To Select Volume Sound
Press the VOLUME UP or DN Buttons to increase or decrease volume sound.
AUX In
The AUX in jack can be used to playback alternate audio signal sources on the unit
speakers (audio cable is not included).
Make sure that your radio is turned off and unplugged from the power outlet.
Plug the audio RCA cable into AUX jack of the unit.
Plug the other end of the audio cable into the Audio out jack on the other device.
Turn on your unit. Press the FUNCTION Button to AUX position.
Turn on the external audio device and use the device's controls to control playback.
.
8
OPERATION INSTRUCTIONS
Setting the Actual Time
1. With the power off, press and hold the PROG/CLK SET Button.
2. Press the SKIP/SEARCH Buttons to adjust the hour and minute of the clock.
3. Once set, release the CLOCK SET Button to confirm.
4. When in RADIO mode, press the DISPLAY Button to view the time, press
DISPLAY again to resume to Radio frequency display.
Setting the Kitchen Timer
1. Press the Timer Button consecutively to cycle through times from 180 minutes to
10 minutes in 10 minute intervals. Press the Skip/Search Buttons to change the
timer in one minute intervals.
2. Stop on the desired amount f time.
To reset the Timer, press and hold the Timer Button.
3. After the allotted time has expired an alarm will sound.
4. Press the POWER Button to stop the alarm sound.
Listening to Radio
1. Plug the AC Power cord into a power outlet.
2. Press the POWER button to turn on the unit.
3. Press the FUNCTION Button to radio mode.
4. Using the BAND Button to select FM / AM radio band.
5. The frequency will be show in display.
6. Rotate the TUNING Dial to search the desire station.
7. Off power - Press the POWER to power off the unit.
NOTES: When in RADIO mode, press the DISPLAY Button to view the time.
9
Autres manuels pour SKCR2613
1
Table des matières
Autres manuels Sylvania Radio-réveil
Sylvania
Sylvania SCR1371 Manuel utilisateur
Sylvania
Sylvania SCR1384 Manuel utilisateur
Sylvania
Sylvania SCR1345 Manuel utilisateur
Sylvania
Sylvania SCR1383 Manuel utilisateur
Sylvania
Sylvania SKCR2601 Manuel utilisateur
Sylvania
Sylvania SCR1384 Manuel utilisateur
Sylvania
Sylvania SYLVANIA SCR4975 Manuel utilisateur
Sylvania
Sylvania SCR4986 Manuel utilisateur
Sylvania
Sylvania SCR4947 Manuel utilisateur
Sylvania
Sylvania SYLVANIA SCR4975 Manuel utilisateur
Sylvania
Sylvania SCR1986BT-AS Manuel utilisateur
Sylvania
Sylvania SCR2608 Manuel utilisateur
Sylvania
Sylvania iMode SIP198 Manuel utilisateur
Sylvania
Sylvania SCR1320 Manuel d'utilisation
Sylvania
Sylvania SKCR2613B Manuel utilisateur
Sylvania
Sylvania SCR1320 Manuel utilisateur
Sylvania
Sylvania JUMBO SCR1206PL Manuel utilisateur
Sylvania
Sylvania SYLVANIA SCR4975 Manuel d'utilisation
Sylvania
Sylvania SCR1420 Manuel utilisateur
Sylvania
Sylvania SCR4503 Manuel utilisateur
