SUP’AIR Walibi 2 Manuel utilisateur

SUPAIR-VLD

PARC ALTAÏS

34 RUE ADRASTÉE

74650 ANNECY CHAVANOD

FRANCE

45°54.024’N / 06°04.725’ E

RCS 387956790

Revision Indice

English version

User’s manual

Thank you for your choice of a WALIBI². We are proud to join you on your journey

in our common passion : paragliding.

SUP’AIR has been designing, producing and selling accessories for free ying

activities since 1984. By choosing a SUP’AIR product you benet from almost

thirty years of expertise, innovation and listening. This is also our philosophy :

working endlessl

We trust that you will nd this user’s manual comprehensive, explicit and hopefully

pleasant to read. We advise you to read it carefully !

On our website www.supair.com, you will nd the last up to date information about

this product. If you have any further questions, feel free to ask one of our retailers.

And of course, the entire SUP’AIR team are at your disposal through info@supair.

com

We wish you many safe ying and enjoyable hours, and happy landings

The SUP’AIR team

List of contents 3

Introduction 4

Technical specications 5

Harness overview 6

Components 6

Rescue parachute setup assembly. 7

Adjustable reserve parachute pocket. 8

Reserve parachute installation in the pocket. 8

Installing the reserve parachute in its pocket. 9

Position setting 11

Leaning angle setting 12

Shoulders’ straps adjustments. 12

Chest strap adjustment. 12

Flight behavior 13

Pre-Flight control 14

Take-off 15

In ight 16

Landing 16

Wash and care of your harness 17

Storage and transport 17

Lifetime 17

Care 17

Repair 18

Materials 18

Recycling 18

Environmental friendly practices 18

Warranty 19

Disclaimer 19

Pilot’s gear 19

Service Book 20

List of contents

Pictures credits: SUP’AIR

Welcome to the tandem world.

With the WALIBI², you are equipped with a tandem harness designed with an integrated

reserve parachute pocket and an AirBag protection. This harness is targeting intensive

professional use.

The split-leg design facilitates the running phase and enables the pilot to adopt an ergo-

nomic posture with the passenger seat locked in place between his legs after takeoff.

Introduction

After reading this manual, we suggest you check your harness by hanging in it before ying.

N.B : Three important icons will help you when reading this manual

Advice Caution ! Danger !!

Taille S Taille M/L

Pilot size 155-175 cm 170-195 cm

Harness weight (+ carabiners+speedbar) 3610 g 3650 g

Designed for Paragliding only Parapente uniquement

Back height (cm) 58 68

Leaning setting height (cm) 28 34

Seat length (cm) 40 47

Carabiners height (cm) 40 40

Impact damping system : Airbag (Volume) Ye s Ye s

Impact damping system : Bumpair (Thick-

ness) No No

Homologation EN 1651 - LTF EN 1651 - LTF

Flight : tandem (Pilot- Passenger) Pilot Pilot

Flight : acrobatic ying No No

Take-off: Winching No No

Quick-out carabiners compatibility No No

Technical specications

Back height (cm)

Leaning setting height (cm)

Seat length (cm)

Seat width (cm)

Carabiners height (cm)

Carabiners distance (cm)

This harness is delivered with two 30 mm Biners ( 138 g. for the set ).

Harness

30 mm Aluminium self-locking biner

Reserve parachute handle (W)

Components

123

Harness overview

Automatic ventral buckle

Rectangular push-through leg straps

buckles.

Ventral width adjustment

Leaning setting

Shoulders straps adjustment

Reserve parachute handle (W)

This illustration will help you during your reading.

4Mini Bump

5Walibi Palte Wood

Connecting the handle to the rescue parachute’s deployment bag

Place the handle inside the

middle webbing loop and

make a lark’s head knot with

the handle.

Fasten tightly the lark’s head

knot and verify the solidity of

the link.

The handle must be connected to the central loop.

Rescue parachute setup assembly.

Thank you for comprehensively reading the following ! We will

recommend you to have your reserve parachute initially installed

by someone competent and familiar with the procedure.

Open the Mini-Bump zip located at the bottom of the dorsal pocket. Insert

the Mini-Bump through the dorsal pocket and slide it behind the reserve

parachute pocket.When done, close the Mini-Bump pocket.

Installing the reserve parachute in its pocket.

Thank you for comprehensively reading the following ! We will recommend

you to have your reserve parachute initially installed by someone com-

petent and familiar with the procedure.

Insert the reserve parachute inside the harness

parachute pocket by opening all the aps. The

POD must be positioned with the handle at the top

with risers and lines at the bottom. Push the risers

through the guiding sleeves ( the risers must be

located behind the parachute ).

Push the cord through the right loop ( if

the handle is located to the right ).

Push the loop through the lower ap grom-

met. The yellow cable will also be pushed

through the lower ap guide located near

the grommet.

Push the cord through the upper ap grom-

met.

The reserve parachute pocket volume is va-

riable in size.You rst must adjust its volume

according to that of your reserve parachute.

Adjustable reserve parachute pocket.

Reserve parachute installation in the pocket.

The pocket volume can slightly be in-

creased by using the lateral aps external

grommets.

The harnesses are delivered by default,

with the “small” volume setting correspon-

ding to the X-TRALITE BI-SUP’AIR reserve

parachute size.

Small volume default set-

ting.

Pull on the rear ap, remove

the cord from it grommet.

Push the piece of line/cord,

underneath the connection

strap, then through the exter-

nal grommet.

8910

Upon setup completion, conduct an extraction sequence

during a hang-test to verify that all works properly before

duplicating the installation procedure again...

Push the yellow cable through the loop and gently

pull the cord out. Push the cord through the left loop. Push the loop through the lower ap grom-

met.

Push the loop through the upper grommet

ap grommet and push the yellow cable

through it ( loop ).

The yellow cable locks the reserve parachute pocket

aps in place. Tuck the upper ap inside its lower

stretchable pocket. Check before every igth for the

yellow cable to be properly inserted through the two

loops keeping the reserve parachute pocket securely

Position the handle in its folding sleeve. It

may not protrude from the harness.

Handle positioning in it holding sleeve.

Pilot Passenger.

Parachute riser.

Toward the « B « or

« C « wing risers.

« André Rose «

System.

Install the risers inside the lateral guiding sleeve.

The risers come out of each strap guide.

Connect the risers atop each spreader-bar (

main hooking location ), with the maillon rapide

trapeze stainless steel 6 mm + the ﬂexible elastic

rings.

On both sides, push the small recoil » André Rose

« strap / webbing, through the main paraglider

carabiner riser, and connect it to the « B « or «

C « paraglider riser using a triangular ( Delta

shaped ) Maillon - riser denomination can vary

from manufact

Pilot Passenger.

Table des matières

Autres manuels SUP’AIR Accessoires

SUP’AIR

SUP’AIR SKYPPER FR Manuel utilisateur

SUP’AIR

SUP’AIR Strike Manuel utilisateur

SUP’AIR

SUP’AIR XP2 Manuel utilisateur

SUP’AIR

SUP’AIR ACCESS 2 BUMP Manuel utilisateur

SUP’AIR

SUP’AIR MINIMAX BUMP Manuel utilisateur

SUP’AIR

SUP’AIR DELIGHT 4 SPORT Manuel utilisateur

SUP’AIR

SUP’AIR EVO XC3 Manuel utilisateur

SUP’AIR

SUP’AIR Skypper2 Manuel utilisateur

SUP’AIR

SUP’AIR ACCESS 2 AIRBAG Manuel utilisateur

SUP’AIR

SUP’AIR ALTIRANDO 2 RS Manuel utilisateur

SUP’AIR

SUP’AIR ALTIRANDO LITE Manuel utilisateur

SUP’AIR

SUP’AIR EVO Lite Manuel utilisateur

SUP’AIR

SUP’AIR PIXAIR 2 Manuel utilisateur

SUP’AIR

SUP’AIR EVASION BUMP Manuel utilisateur

SUP’AIR

SUP’AIR EVEREST3 Manuel utilisateur

SUP’AIR

SUP’AIR ALTIRANDO 3 Manuel utilisateur

SUP’AIR

SUP’AIR PERMANENT AIRBAG Manuel utilisateur

SUP’AIR

SUP’AIR SHAMANE Manuel utilisateur

SUP’AIR

SUP’AIR PARAMOTEUR EVO Manuel utilisateur

SUP’AIR

SUP’AIR ACRO 3 Manuel utilisateur

SUP’AIR

SUP’AIR DELIGHT 4 Manuel utilisateur

SUP’AIR

SUP’AIR Pixair Manuel utilisateur

SUP’AIR

SUP’AIR Bump'Air Series Manuel utilisateur

SUP’AIR

SUP’AIR VIP2 Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur