Sunra Miku Max Manuel utilisateur
Jiangsu Xinri E-vehicle Co.,Ltd.
No.501 Xishan Road, Anzhen，Xishan District ,Wuxi, Jiangsu Province, P.R.China
www.sunraev.com www.mikuev.com
Email: [email protected] Tel: 86- 0510-88109820
Operator’s Manual
Electric Scooter
Miku Max
Cool to be cool
Powered by Sunra EV
TABLE OF
CONTENTS
WARNING!
Read and understand all safety precautions in this manual before operating.
Failure to comply with instructions in this manual could result in personal injury,
property damage, and/or voiding of your warranty.
SECTION 01
SECTION 02
SECTION 03
SECTION 04
SECTION 05
SECTION 06
SECTION 07
SECTION 08
Safety Guidelines-definitions
General Precautions
The Manual Of Smart Chip Charger
Performane
Fast Assembly
Pre-ride Checklist
Power Pack & Charging
Maintenance Tips
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
WARNING!
It is your responsibility to know and obey all applicable local, state, and federal
laws at all times while operating this electric scooter including but not limited to
traffic safety, vehicle registration, emissions, and noise.
Safety Guidelines-Definitions01
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
This manual contains important information that you need to know and understand in order to protect
YOUR SAFETY and to PREVENT EQUIPMENT PROBLEMS. The following symbols help you recognize this
information. Please read the manual and pay attention to these sections.
DANGER: Damages indicate a certainty or strong possibility of personal injury or death if
instructions are not followed.
WARNING! Improper operation or maintenance of this scooter could result in serious injury and property
damage. Read and understand safety instructions tips and operating instructions before using this scooter.
Always obey all applicable local, state, and federal laws when operating this scooter.
Read and understand all of these safety instructions. Be sure to retain them for future use.
Save These Important Safety Instructions!
Traffic safety
WARNING: Warning indicates a strong possibility of equipment damage or possibility of
personal injury if instructions are not followed.
CAUTIONS: Cautions indicates a possibility of equipment damage if instructions are not
followed.
01/02
General Precautions02
Read and follow all instructions in the manual of MIKU products, before attempting to operate this scooter. Don’t
discard this Operator’s Manual, or any other material or documentation included with this scooter.
Modifying the scooter and/or removing original equipment and/or safety decals could make this scooter unsafe for operation.
Replace any safety decals that become unreadable or detached from the scooter. Decals provide critical warning
about potential hazards or safety requirements.
Always follow the entire pre-ride
checklist prior to starting or
operating the scooter.
Your safety while riding this scooter depends entirely on your
ability to exercise proper judgment. You must be of sufficient
age,understanding,mental capacity,and physical capability to
safely operate this scooter.
Excessive vehicle speed is a leading cause
of accidents, which can cause death or
serious harm to you, other people,
and/or property.Always obey all
applicable traffic safety laws while
operating this scooter, being sure
to account for current weather and
traffic conditions and slow down if necessary.
Above
16
Always obtain mature, supervised
instruction and sufficient practice
in an uncongested area before
this scooter on any public
thoroughfare.
Don’t
The charger should be matched with the alternating voltage of local power supply before connecting charger.
Traffic safety
Instruction
Use extreme caution when riding
on wet, slippery, rough, or sloped
terrain. There is an increased risk
of loss of control, which can
result in injury,death, and/or
property damage.
Stop the scooter and shut off the motor
immediately if the scooter makes unusual
noises or vibrations. Check the
scooter for damage. Excessive
noise or vibration is a sign
of loose or worn parts.
Never operate scooter while under the
influence of alcohol, drugs or medication
of any kind. Such operation is dangerous
to yourself and/or others and may be
illegal in your location.
Use extreme caution when riding on
wet, slippery, rough, or sloped terrain.
There is an increased risk of loss of
control, which can result in injury,
death, and/or property damage.
Never use this scooter to perform
any type of racing, stunt riding,
jumps, spin-outs, donuts, or
other maneuvers. You could
kill or injure yourself or others
and/or cause property damage.
Check tire pressure before operating
the scooter using a property
calibrated tire air pressure gauge.
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
03/04
The manual of smart chip charger
03
1
The charger is designed and tested for original battery from manufacturer. Do not use them for the other
mismatching batteries.
2
The charger is tested and matched with its scooter. If the charger is used on other scooter, it might make different
charging effect and/or cause battery damage.
3
Please connect charger and scooter before connect to local power supply, while you are going to charge the
battery. Please disconnect the charger from local power supply while the battery is fully charged. Don’t
disconnect charger and scooter while the charger is connected with local power supply for safety reason.
4
Do not violently shake the charger. It might cause damage of the charger.
5
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
05/06
Keep the charger away from any water, dust or high temperature.
6
The charger creates the heat while working. It should be stored in well ventilated place and keep away from
any inflammable things.
7
Keep it away from children.
8
If any wire or shell was broken, Please send it to the professional repairing service. Don’t open or repair it
yourself. This action will cause danger and lose warranty of the charger.
9
The charger is designed and made for electric scooter battery charging use. Don’t make it for other use.
10
Any incorrect usage which does not follow this instruction will lose guarantee from seller.
11
While the charger is connected with battery,green light is turned on to indicate the testing status of charging.
Using direction
1
While the charger is connected to 110V/220V/250V local AC power supply,the green light turns to red to indicate
charging status.
2
After 4-6 hours charging, the red light turns to green to indicate the battery charging is finished.
3
While the charging is finished, the charger will cut off power from AC power supply automatically.
4
children
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
07/08
The performance of an electric scooter is different from gasoline engine driven or human powered vehicles.
It’s very important to understand how the MIKU electric scooter works before riding.
performance
04
low Speed High Speed
Stop & Go
Elevation Changes
Soft Gravel
Fewer Stops
Flat
Smooth Pavement
Route
More Less
Aggressive Riding
Fully Upright
Heavier
Modulated Riding
Streamlined
Reduced Cargo
Rider
Test condition: New vehicle with new battery, Temperature at 20°C, No wind, All lights (on the scooter) off,
loading weight at 75kg, standard pressure.
Riding habit, Road conditions, environment and temperature might shorten the riding distance of per charge.
Tire pressure and loading weight shorten driving distance of per charge.
The riding distance of per charge might shorter in Winter because of battery’s peculiarity.
Riding distance of per charge will be shortened by battery lifetime loss.
Inflated Tires Underinflated Tires
Unbalanced Power Pack
Balanced Power Pack
Warm Weather Cold Weather
High Head Winds
Slippery Roads
No Wind
Dry Roads
Weather
Scooter
Riding distance of per charge
WARNING! Always perform the entire pre-ride checklist before using the scooter as this can
help you spot problems that could interfere with safe scooter operation. Failure to follow this
entire checklist before every ride can cause death, serious injury, and/or property damage
to yourself and/or others.
Pre-Ride Checklist06
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
09/10
Step : Fasten mirrors on the fixing holes
at steering bar and tighten with a wrench.
Step : Adjust mirrors in proper position.
You can prepare for your first riding after simple 2-step assembly.
FAST ASSEMBLY
05
1 2
Headlight
Turn signals
Footstep
Side stand
1685mm
1065mm
780mm
Mirror
Left switch
Right switch
Ignition switch
Throttle grip
Rear brake lever
Dashboard
Front brake lever
Storage case
Battery case
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
11/12
DANGER!
Use extreme caution when engaging the front brake to avoid locking the front wheel.
Locking the front wheel can cause a serious accident.
Throttle grip : The rotary throttle grip is on the right handlebar.Accelerate by rotating the throttle towards
you. Decelerate by rotating the throttle away from you. The throttle includes a safety spring that snaps the throttle
back to end when released.
7
Rear brake lever : When stopping the scooter, squeeze the left brake lever smoothly and firmly to engage the
rear brake.Always engage the rear brake first.
5
Front brake lever : Squeeze the right lever to engage the front brake. The right lever must be squeezed gently
at first to avoid locking the front wheel.
6
Brake Levers & Throttle
56
7
Ⅰ
Ⅱ
Ⅲ
巡航
Ignition Switch
1
1
2
3
This position is used for operating the scooter.
Install the key and turn clockwise.At this position
the following sequence occurs:
Lights turn ON Dashboard turns ON
ON Position
This position is used to turn the scooter
OFF, disabling the electrical system.
OFF Position
Sound the alarm for tracking position
of the scooter.
Alarm
2
Turn on anti-theft system.
Lock
3
Turn off anti-theft system.
Unlock
To operate the steering lock:
Turn the handlebar all the way to the left.
With the key in the OFF position, push the
key down and turn the key counter-clockwise.
To unlock the steering lock:
Install the key and turn clockwise.
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
13/14
Right switch
Left switch
High & low beam
1
Turn signal
2
Horn
3
4
Headlight switch
5
Cruise control key :
The speed will be kept without throttle by press Cruise
control key.
The cruise performance will be canceled by any braking
operation.
6
1
2
3
Ⅰ
Ⅱ
Ⅲ
巡航
4
5
6
Left&Right Switch
7
Right turn signal
9
8
Total odometer
Trip odometer
5
5
Riding time indicator
6
High Beam Indicator
4
Left turn signal indicator
2
Speedometer
3
1
Energy level indicator
km
TRIP
ODO
km／h
READY P
%
A
1
2
3 4
6
7
8
9
Dashboard
Daylight Indicator
Tires
Ensure that both tires have at least 1/8 inch tread depth at center.
Both tires must be inflated to the pressure indicated on the tire sidewalls.
Replace the tires if tread height is less than 1/8 inch at the center of tires.
Throttle
Check for smooth operation. Make sure throttle grip could return to cut off power.
Check for frayed cable or damaged cable housing. Replace damaged cable to avoid electricity shock.
Check for mud, debris and ice in the throttle mechanism. Clean out any contamination.
Fasteners
Check that all axle nuts and lug nuts are secure.
Check for missing fasteners. Replace as necessary.
Check that all other fasteners are secure. Tighten as necessary.
Steering
Make sure steering turns freely.
Check for proper “toe-in” of wheels
Lubricate/adjust as necessary. See the Maintenance section.
Chassis frame
Check for bent/damaged components. Replace as necessary.
Battery
Check the power level to ensure it’s enough for riding.
Lights
Check for proper operation. Replace bulbs as necessary.
Before Starting the Engine/Motor
1
2
3
1
2
3
1
2
3
1
2
3
Energy level indicator
This indicator and readout displays the amount of energy
remaining in the power pack, similar to the fuel gauge on
a gasoline powered scooter.
1
High Beam Indicator
When the headlight high beam is on, this indicator illuminates
blue, and remains on until the high beam is turned off.
Speedometer
The speedometer is a digital display in kilometers per hour (km/h).
2
Daylight Indicator
When the scooter is starting, the daylight indicator is turned
on automatically.
3
Left turn signal indicator
Flashes green when a left turn is selected by the turn signal
switch. This arrow remains flashing until the turn signal
request has been canceled.
4
Riding time indicator
The clock displays riding time of single trip.
5
6
Right turn signal
Flashes green when a right turn is selected by the turn signal
switch. This remains flashing until the turn signal request has
been canceled.
7
Total odometer
The total odometer displays the total distance the
scooter has been ridden in kilometers.
8
Trip odometer
The trip odometer displays the distance of single riding in
kilometers.
9
DESIGNED BY MIKU TEAM
DESIGNED BY MIKU TEAM
15/16
Table des matières
Manuels Scooter populaires d'autres marques
First Choice Mobility
First Choice Mobility Roma Medical Corella S741 Manuel utilisateur
Carrera
Carrera impel Manuel utilisateur
Afikim
Afikim Superlight SL-3 Manuel utilisateur
CareCo
CareCo ZOOM Manuel utilisateur
Douglas
Douglas Vespa G.S. Manuel utilisateur
Gazelle
Gazelle with BOSCH System Manuel utilisateur