ENGLISH
ENGLISH-3
1.- Turn on the device that you want to program.
2.- Press the button which correspond to the device to be
programmed. In the screen you will see the selected device.
3.- Press and hold SET for 3 seconds, in the screen you will see
the message CODE SETUP.
4.- Press SELECT . Find the code for your device in the codes
list and enter the 3 digits code.
5.- If the code is correct, the screen will show the message
Success.
6.- Now aims the remote control at your device, and press
POWER. If your device switch on, you are ready to operate the
device. Watch and keep that your device works properly with
the remote control. If your device does not respond or is not
functioning properly, please try with each code listed for your
brand, repeating from step 2 to 5. If it’s necessary, try the Search
Method.
Do not use more than 10 seconds to press a button in each
step, otherwise you’ll leave the program mode and you must
start the process, again.
Probably there are more than one code for your device, but
only one of them will control almost the total of functions,
try to find the more appropriated code for your brand.
SEARCH METHOD
1.- Be sure the device to be programmed is ON, not in Stand-By.
2.- Press the button of the desired device in the remote
controller. In the LCD screen you will see the selected device
name.
3.- Press and hold SET for 3 seconds, CODE SETUP message
displays in the screen.
4.- Use the multi-control button to choose CODE SRCH option.
5.- Press SELECT to confirm the option.
6.- Aim the remote controller to the desired device while use
Search Method.
7.- Move the multi-control button, Up or Down, to see different
codes in the screen.
8.- When your device turns off, press SELECT to choose the
right code.
9.- Press POWER once again in the remote controller in order to
check if your device turns on. Test the remote control functions, it
must control almost the functions, otherwise repeat the
instructions.
