LIABILITY
It is not permitted to make alterations or additions to the construction of the machinery supplied, to parts of the machinery supplied
or to accessories. Any warranty and liability claims become void in such case.
SETTING UP THE MACHINE
The anti-rust protection must be removed from the bright machine parts before first use.
The machine is completely installed an mounted.
Place machine at final destination, use a water level to level the machine , adjust with the M12 screws which
are fixed at the feet.
Do not srew/tighten the machine resp. legs to the floor !
LIFTING AND MOVING
Due to the heavy weight of the machine it can be lifted and moved by a forklift or with a pallet truck
Never lift the machine below of the tool box !
If it is necessary to disassemble the machine to move it at the final place: there is a special instruction on request
ELECTRIC CONNECTION
The lathe is supplied complete with a 16A CEE- plug, connected 1 x 230 V
Blue = neutral wire
Brown = L1/Phase
Green/yellow = ground wire
Power requirement 20 Ampere, fuse protection with circuit breaker
Attention
If any other plug than the CEE-plug supplied is used , the connection must be done from a professional electrician
The inverter is mounted at the lefthandside foot
If any work is done at the lefthandside foot pull off the plug from electric mains.
The Inverter parameters are set up for the right rpm in relation to the vee-belt-pulley steps
Any alterations made at the inverter warranty is expired as a result.
SPEED REGULATION
Inside the vee-belt-cover is an additional safety switch to meet the CE-conformity
the machine automatically will stop If the vee-belt-cover is opened or not properly closed
Infinitely variable speed with 3 pulley-steps
changing vee-belt to requested pulley:
loosen the motor clamping by handle, hold motor at grip and move it forwards (loosening of tension)
change vee-belt onto the requested pulley step by “moving” the pulley by hand forward/reverse
fasten clamping lever but do not use too much tension: high tension can cause
vibration, wear of bearings and veebelt, could also cause damage on the motor-schaft
close vee-belt pulley correctly otherwise the motor will not run (safety switch inside)
If working with the lowest speed i.e. 300 rpm/min use the pulley-step with 40-850 rpm/min to ensure
a sufficient power in the lowest speed
Regulation of spindle speed only while the spindle is running!
the spindle speed is controlled by an inverter
start the spindle running
turn speed regulation knob to change speed
clockwise = increasing of speed
anticlockwise = decreasing of speed
speed is shown on the speed digital diagram
Before the machine is switched it is recommended first to check if the Potentionmeter is adjusted to “Zero”
SPINDLE SPEED AND WORKPIECE DIAMETER
The maximum permissible peripheral speed = 3.000 U for a maximum workpiece diameter of 130 mm
Watch the stickers on headstock for the adjusted speed and the max. workpiece diameter
