StarTech.com 8STHSB2535SATBK Manuel utilisateur

Manual Revision: 03/27/2019

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

HSB2535SATBK

5.25in Dual 2.5/3.5in HDD/SSD SAS SATA

Trayless Mobile Rack

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation.This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Product Diagram ....................................................................................1

Front View .................................................................................................................................................... 1

Rear View...................................................................................................................................................... 1

Introduction............................................................................................2

Packaging Contents ................................................................................................................................. 2

System Requirements.............................................................................................................................. 2

Hardware Installation............................................................................3

2.5/3.5in Hard Drive Installation.......................................................................................................... 4

2.5/3.5in Hard Drive Removal............................................................................................................... 5

How to Use ..............................................................................................6

Connecting the Hard Drive.................................................................................................................... 6

LED Indicator .............................................................................................................................................. 6

Initializing the Hard Drive.....................................................................6

Technical Support ..................................................................................8

Warranty Information............................................................................8

Instruction Manual

Product Diagram

Front View

1. 2.5” Drive bay

2. 2.5” Drive bay key hole

3. 3.5” Drive bay

4. 3.5” Drive bay key hole

5. 2.5/3.5in LED indicators

Rear View

1. 2.5” Drive SATA port

2. 3.5” Drive SATA/SAS Port

3. LP4 Power Connector

Instruction Manual

Introduction

Packaging Contents

• 1 x 2.5/3.5in SATA HDD Backplane

• 2 x 18” SATA Cable

• 1 x LP4 to SATA Power Adapter Cable

• 2 x Bay Key

• 1 x Installation Screw kit

• 1 x Instruction Manual

System Requirements

• 1 x Computer System with SATA connectivity and an available 5.25” bay

• 1 x Available SATA or LP4 Power Connection

• 1 x 2.5” SATA Hard Drive and/or 1 x 3.5” SATA/SAS Hard Drive

WARNING! Hard drives and storage docks require careful handling, especially when

being transported. If you are not careful with your hard disk, lost data may result.

Always handle your hard drive and storage device with caution. Be sure that you

are properly grounded by wearing an anti-static strap when handling computer

components or discharge yourself of any static electricity build-up by touching a large

grounded metal surface (such as the computer case) for several seconds.

Instruction Manual

Hardware Installation

1. Ensure your computer system is powered down, and the power cable has been

disconnected from the Power Supply.

2. Open your computer case (refer to the computer user manual for details), and place

the 2.5/3.5in SATA HDD Backplane into an available 5.25” slot, lining up the side

installation holes on the HSB2535SATBK (pictured below), with installation holes on

the 5.25” slot inside the computer.

3. Hold the HSB2535SATBK into place, and x 4 of the included screws through

the installation holes on the 5.25” slot, into the side installation holes on the

HSB2535SATBK.

4. Connect one of the included “18in SATA cables”from an available SATA host port on

your motherboard to the“2.5” Drive SATA port” on the back of the HSB2535SATBK.

5. Connect one of the included “18in SATA cables”from an available SATA host port on

your motherboard to the“3.5” Drive SATA port” on the back of the HSB2535SATBK.

6. Connect a LP4 Power header from your power supply to the“LP4 Power Connector”

on the back of the HSB2535SATBK. If you do not have an LP4 connector available,

use the included “LP4 to SATA Power Adapter Cable” with an available SATA Power

Header from your power supply.

Instruction Manual

2.5/3.5in Hard Drive Installation

1. Insert either of the included bay keys into the “2.5in/3.5in Drive bay key holes

depending on which type of drive you intend to install. And Turn the key clockwise

into the unlock position.

2. Pull the drive door handle to open the drive bay.

3. Insert your desired drive.

4. Close the drive door.

Instruction Manual

2.5/3.5in Hard Drive Removal

1. Insert either of the included bay keys into the “2.5in/3.5in Drive bay key holes

depending on which type of drive you intend to install. And Turn the key clockwise

into the unlock position.

2. Pull the drive door handle to open the drive bay.

3. Remove your drive.

4. Close the drive door.

Note: It is important to eject or unmount the hard drive from your computer system

before physically removing the drive. See How to Use - Disconnecting the Hard Drive

section for instructions.

Instruction Manual

How to Use

Connecting the Hard Drive

Once the drive has been installed in the drive bay, the drivers will install automatically,

and the inserted drive will be accessible as though it were installed within the system.

Prior to using the drive, it will need to be formatted according to your operating

system requirements.

Refer to Initializing the Hard Drive

LED Indicator

The HSB2535SATBK oers 2.5/3.5in LED indicators, to enable you to monitor drive

activity. The LED will ash while the hard drive is being accessed. Do not remove the

enclosure from the host computer while the LED is ashing, as it could damage the

drive or the enclosure, resulting in data loss.

Initializing the Hard Drive

1. If the SATA Hard Drive is blank it may need to be initialized and formatted before

use. From the main Windows desktop, right-click on “My Computer” (“Computer” in

Vista/ 7 / 8), then select Manage. In the new Computer Management window, select

Disk Management from the left window panel.

Instruction Manual

2. A dialog window should automatically appear, asking you to initialize the drive.

Depending on the version of Windows, it will give you the option of either creating

an “MBR” or “GPT”disk. GPT (GUID partition) is required for drives larger than 2TB but

is not compatible with some older operating systems, while MBR is supported by

newer and older operating systems.

3. Once initialized, locate the Disk that says it is “Unallocated” (check the listed hard

drive capacity to conrm it’s the correct hard drive) and then right-click in the

section that says “Unallocated” and select“New Partition”.

4. Several on screen prompts will follow walking you through the steps to create the

partition. Follow these prompts to complete partition creation.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels StarTech.com Support et étagère

StarTech.com

StarTech.com RKPNLHV2U Manuel utilisateur

StarTech.com

StarTech.com CABSHELF22 Manuel utilisateur

StarTech.com

StarTech.com 4POSTRACK U Series Manuel utilisateur

StarTech.com

StarTech.com DSIGNAGESTND Manuel utilisateur

StarTech.com

StarTech.com ARMWALLDS2 Manuel utilisateur

StarTech.com

StarTech.com ARMPIVOT2USB3 Manuel utilisateur

StarTech.com

StarTech.com ADJDINKIT Manuel utilisateur

StarTech.com

StarTech.com STNDTBLTMOB Manuel utilisateur

StarTech.com

StarTech.com ARMBARTRIO2 Manuel utilisateur

StarTech.com

StarTech.com HSB100SATBK Manuel utilisateur

StarTech.com

StarTech.com RK12WALLOA Manuel utilisateur

StarTech.com

StarTech.com HSB43SATSASB Manuel utilisateur

StarTech.com

StarTech.com FPWARTB2 Manuel utilisateur

StarTech.com

StarTech.com RK4OD2 Manuel utilisateur

StarTech.com

StarTech.com WALLMOUNTH4 Manuel utilisateur

StarTech.com

StarTech.com KBTRAYADJ2 Manuel utilisateur

StarTech.com

StarTech.com ARMPIVOTE Manuel utilisateur

StarTech.com

StarTech.com 2POSTRACK16 Manuel utilisateur

StarTech.com

StarTech.com ARMPIVOTV2 Manuel utilisateur

StarTech.com

StarTech.com SHELF-2U-14-CENTER-V Manuel utilisateur

StarTech.com

StarTech.com PROJWALLMNT Manuel utilisateur

StarTech.com

StarTech.com WALLMOUNT6 Manuel utilisateur

StarTech.com

StarTech.com MONSTND Guide de démarrage rapide

StarTech.com

StarTech.com ARMPIVOTB2 Manuel utilisateur

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur