StarTech.com PEX1000MMSC Manuel utilisateur

Manual Revision: 03/06/2012

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

PEX1000MMSC

PEX1000MMST

1000 Mbps Gigabit Multi Mode SC/ ST Fiber

PCI Express Card - 550m

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Introduction ...........................................................................................1

Features ........................................................................................................................................................ 1

Package Contents ..................................................................................................................................... 1

Installation ..............................................................................................2

Hardware Installation .............................................................................................................................. 2

Connecting to a Network ....................................................................................................................... 3

Software Installation ................................................................................................................................ 4

Specications ..........................................................................................6

Technical Support ..................................................................................7

Warranty Information ............................................................................7

Instruction Manual

Introduction

Thank you for purchasing a StarTech.com Multi Mode Fiber Gigabit Ethernet Card.

A simple solution for connecting a host computer directly to a ber network, the

PEX1000MMSC/ PEX1000MMST provides full gigabit performance, ensuring the fastest

network connections and reliable performance.

Features

• 1000Mbps-Full-duplex

• Advanced Conguration Power Management Interface (ACPI) 2.0

• Cable diagnostic utility

• Compliant with RFC 1157 SNMP v1 which allows you to manage remotely

• Complies with IEEE 802.1Q, 802.1p, 802.3ab standard

• Microsoft NDIS5 (IP, TCP, UDP) checksum ooad

• PCI Express 1.0a compliant Supports up to 9K Bytes jumbo frame

• Supports Wake-on-LAN remote wake-up

Package Contents

• 1 x PCI Express Gigabit Ethernet Fiber Network Adapter

• 1 x Driver CD

• 1 x Instruction Manual (on CD)

Instruction Manual

Installation

Hardware Installation

1. Turn OFF the computer power before installation.

2. Remove the chassis cover from your computer.

3. Locate an unused PCI Express slot and remove the corresponding slot cover from

the rear panel of the computer chassis. Retain the screw (if applicable) used to hold

the slot cover in place.

4. Align the PCI Express card with the unused PCI Express expansion slot. Applying

pressure evenly across the top edge of the expansion card, rmly but gently insert the

card into the slot, ensuring that the card is properly aligned with the rear panel slot.

5. Secure the card to the motherboard and rear chassis using the screw removed in

step 3 (if necessary). Secure the additional serial port provided by the daughter

board (smaller circuit board to an adjacent rear bracket.

6. Replace the chassis cover (removed in step 2).

7. Power on the computer. Once the computer has been rebooted, the operating

system will detect that the PCI Express card has been installed and request driver

installation, detailed in the next section.

WARNING! PCI Express cards, like all computer equipment, can be severely damaged by static

electricity. Be sure that you are properly grounded before opening your computer case or

touching your PCI Express card. StarTech.com recommends that you wear an anti-static strap

when installing any computer component. If an anti-static strap is unavailable, discharge yourself

of any static electricity build-up by touching a large grounded metal surface (such as the

computer case) for several seconds. Also be careful to handle the PCI Express card by its edges

and not the gold connectors.

Instruction Manual

Connecting to a Network

Please note: You must connect the PCI Express Fiber Gigabit Ethernet

Adapter to the network before installing the network driver.

For connector type, cabling requirements, and maximum segment distance when

connecting the PCI Express Gigabit Ethernet Adapter to your network, please refer to

the following tables.

Connector Type on Fiber

Adapter

Wavelength of 850nm;

Fiber Optic required

Maximum Distance

(*full-duplex)

SC/ST Multi-mode, 62/125 µm 55m

Connector Type on Fiber

Adapter

Wavelength of 1310nm;

Fiber Optic required

Maximum Distance

(* full-duplex)

SC/ST Single-mode, 10/125 µm 10 km

SC/ST Single-mode, 10/125 µm 50 km

Remove the protective covers from the PCI Express Fiber Gigabit Ethernet Adapter’s connector.

2. Prepare a network cable with corresponding connectors for the two end devices,

one end to the PCI Express Fiber Gigabit Ethernet Adapter and the other to a

1000Mbps ber port on the network switch.

3. Connect the network cable to the connector on the PCI Express Fiber Gigabit

Ethernet Adapter. This network cable consists of two individual cables: one for

‘transmission (TX)’, and the other for ‘reception (RX)’.

4. Connect the other end of the network cable to a 1000BASE-SX switch.

5. i. Insert the cable that is connected to the transmit (TX) connector on the PCI Express

Fiber Gigabit Ethernet Adapter into the receive(RX) connector on the network switch.

ii. Insert the cable that is connected to the receive (RX) connector on the PCI Express

Fiber Gigabit Ethernet Adapter into the transmit (TX) connector on the network switch.

Instruction Manual

6. When the cable is properly connected to two end devices, turn on the power to the PC.

7. Check the LNK (Link) LED. The LED will come on when the PCI Express Fiber Gigabit

Ethernet Adapter is receiving a good link signal from the connected device, a switch.

Software Installation

1. Once PEX1000MMSC/ PEX1000MMST has

been installed in the computer, turn on

the power to the computer.

2. When the Found New Hardware Wizard

window pops up, select Install from a list

or specic location (Advanced)and click

Next to continue.

3. Select Search for the best driver in these

locations. and then select Include this

location in the search. Click Browse to

specify the driver location and click Next

to continue.

Instruction Manual

4. Installation will begin...

5. Click Finish to complete the driver installation.

Instruction Manual

Specications

Applicable Standards

IEEE802.3 10Base-T,

IEEE802.3u 100Base-TX/100Base-FX

IEEE802.3ab 1000Base-T

IEEE802.3z 1000Base-SX

IEEE802.3x

IEEE802.1Q

IEEE802.1p

IEEE802.3ad

LED Indicators Link, Activity

Operating Temperature 0°C ~ 45° C (32°F ~ 113°F)

Storage Temperature -10°C ~ 70°C (14°F ~ 158°F)

Humidity 5% ~ 95% RH non-condensing

Chipset Realtek RTL8168B

Marvell 88E1111

Maximum Connection

Distance Up to 550m (1804 ft)

OS Support Windows XP/Vista/7(32/64-bit)/Server

2008 R2, Linux, and Mac OS X

Instruction Manual

Technical Support

StarTech.com’s lifetime technical support is an integral part of our commitment to

provide industry-leading solutions. If you ever need help with your product, visit

www.startech.com/support and access our comprehensive selection of online tools,

documentation, and downloads.

For the latest drivers/software, please visit www.startech.com/downloads

Warranty Information

This product is backed by a two year warranty.

In addition, StarTech.com warrants its products against defects in materials

and workmanship for the periods noted, following the initial date of purchase.

During this period, the products may be returned for repair, or replacement with

equivalent products at our discretion. The warranty covers parts and labor costs only.

StarTech.com does not warrant its products from defects or damages arising from

misuse, abuse, alteration, or normal wear and tear.

Limitation of Liability

In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their

ocers, directors, employees or agents) for any damages (whether direct or indirect,

special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,

or any pecuniary loss, arising out of or related to the use of the product exceed the

actual price paid for the product. Some states do not allow the exclusion or limitation

of incidental or consequential damages. If such laws apply, the limitations or exclusions

contained in this statement may not apply to you.

Autres manuels pour PEX1000MMSC

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels StarTech.com Carte PCI

StarTech.com

StarTech.com PEXSATA22I Manuel du système

StarTech.com

StarTech.com PCI1224PUSB Manuel utilisateur

StarTech.com

StarTech.com PCI1PECPDV Manuel utilisateur

StarTech.com

StarTech.com PR22GI-NETWORK-CARD Manuel utilisateur

StarTech.com

StarTech.com PEXSAT31E1 Manuel utilisateur

StarTech.com

StarTech.com PCI2S485 Manuel utilisateur

StarTech.com

StarTech.com PEX4SFF8643 Manuel utilisateur

StarTech.com

StarTech.com PEXMSATA3422 Manuel utilisateur

StarTech.com

StarTech.com PCI1P_LP Manuel utilisateur

StarTech.com

StarTech.com PEX2S952PW Manuel utilisateur

StarTech.com

StarTech.com PEX2EC35 Manuel utilisateur

StarTech.com

StarTech.com DUAL-M2-PCIE-CARD-B Manuel utilisateur

StarTech.com

StarTech.com ST100SLP Manuel

StarTech.com

StarTech.com PCI4S550N Manuel utilisateur

StarTech.com

StarTech.com ST10GSPEXNB Manuel utilisateur

StarTech.com

StarTech.com PCI1394MP Manuel utilisateur

StarTech.com

StarTech.com PEXUSB3S2EI Manuel utilisateur

StarTech.com

StarTech.com PCIUSB3S22 Manuel utilisateur

StarTech.com

StarTech.com PCI420USB Manuel utilisateur

StarTech.com

StarTech.com PEX1394B3 Manuel utilisateur

StarTech.com

StarTech.com 8STPEXUSB3S11 Manuel utilisateur

StarTech.com

StarTech.com PCI1PM Manuel utilisateur

StarTech.com

StarTech.com PEXUSB3S400 Manuel utilisateur

StarTech.com

StarTech.com PEXESAT322I Manuel utilisateur

Manuels Carte PCI populaires d'autres marques

ERMA

ERMA SSI 1417 Manuel utilisateur

SIIG

SIIG CyberSerial Dual PCI Instructions de montage

Moxa Technologies

Moxa Technologies CP-102E Manuel utilisateur

I-Bus

I-Bus IBC2602 Manuel utilisateur

Exsys

Exsys EX-60102 Manuel utilisateur

Chelsio Communications

Chelsio Communications T5 Series Manuel utilisateur

Conrad Electronic

Conrad Electronic 97 46 71 Manuel utilisateur

Micro Innovations

Micro Innovations USB650A Manuel utilisateur

KTI Networks

KTI Networks KF-310 Manuel utilisateur

Asus

Asus SpaceLink WL230 Manuel utilisateur

SIIG

SIIG SC2475 Manuel utilisateur

TRENDnet

TRENDnet TEW-703PI Manuel utilisateur

Belkin

Belkin F5D7000F Manuel utilisateur

Pericom

Pericom PI7C7100 Manuel utilisateur

ADLINK Technology

ADLINK Technology cPCI-3548 Manuel utilisateur

Digium

Digium TE200 Series Manuel utilisateur

Allo.com

Allo.com 2nd Gen E1/T1/J1 Manuel utilisateur

Western Digital

Western Digital FireWire PCI Adapter Manuel utilisateur