SAFETY INSTRUCTIONS
Please read the instructions carefully as they include important
information about the installation, operation and maintenance.
• Please keep this user’s guide for future consultation. If you sell the unit to
another user, be sure that they also receive this instruction booklet.
• All fixtures leave the manufacturer intact. Please note that any damages
incurred by the user is not covered by the guarantee.
• Unpack and check carefully that there is no transportation damage before
using the unit.
• The unit is for indoor use only. Use only in a dry location.
• Use a safety bond when attaching the fixture to a lighting rig. Handle by
the hanging bracket when fixing.
• The unit must be installed in a location with adequate ventilation at least
50 cm from adjacent surfaces.
• Make sure that no ventilation slot is blocked, otherwise the unit will overheat.
• Before operating, ensure that the voltage and frequency of the power
supply match the power requirements of the unit.
• Make sure all equipment is properly earthed.
• Do not operate the unit if the ambient temperature is higher than 40°C.
• Do not hardwire to any mains dimmer.
• On the first start, there may be some normal operational start-up smell.
• Make sure that there is no flammable material close to the unit while operating,
as it is a fire hazard.
• Look over power wires carefully and replace immediately if there is any damage.
• Never run on for a long time lest shortening lifespan. Avoid any inflammable
liquids, water or metal objects entering the unit. In case it happens, cut off
the mains power immediately.
• Do not operate in a dirty or dusty environment. Clean fixtures regularly.
• Do not allow unsupervised children to operate the fixture.
• Do not touch any wire during operation as there might be electric shock
hazard.
• Avoid placing power wires next to other cables.
