3
• Do not let the mains cable run across an open space, such as
between a low power socket and a table, or across any hot area,
such as a cooker. Heat may damage the mains cable.
• The connections on both sides of the mains cable (the appliance
and the power socket) should never be strained. If the mains
cable is damaged it must be replaced by a qualified person or
service to avoid any hazards.
• This appliance must not be operated by an external timer or a
remote control system.
• The top of the base unit oshould always be kept dry,
especially around the connection area.
• Before drying, disconnect the power supply; ensure that
the base unit ois completely dry before you reconnect the
appliance to power supply.
• Pour the water out of the kettle jug tslowly and carefully,
do not over tilt or tip the kettle too fast to prevent spillage and
splashing. Remove the kettle jug t from the base unit o
before filling or pouring.
• Do not move the kettle jug twhen it is switched on. Use
extreme caution when moving a kettle containing hot water.
• Do not switch the kettle on unless it contains at least two cups
of water.
• Avoid filling it up above the MAX mark to prevent the hot
water spewing out.
• Always remove the kettle jug tfrom the base unit obefore
you fill it.
• Always close the lid eand have the filter qin place before
you switch the kettle on. Do not open the lid ewhile the water
is boiling.
• Avoid contact with steam while the water is boiling and after the
kettle is switched off.
• Avoid using the kettle near or below curtains, shelves,
cupboards or anything that might be damaged or deformed by
hot steam.
• Use the handle wand lid release button ron the appliance
and avoid touching any hot surfaces.
• The switch ishould never be held fixed in the ON position as
this may cause damage to the switch-off mechanism.
• Do not remove the kettle jug tfrom the base unit owithout
switching it off first. Unplug the base unit owhen not in use.
• Unplug the kettle from the power socket before cleaning or
removing any parts. Ensure that the kettle is completely cooled
down before cleaning and storing away. Keep the kettle jug t,
base unit o, mains cable, and plug away from sources of heat
and store in a dry place.
• Do not use the kettle for any purpose other than heating water.
• Use the kettle jug tonly with the base unit osupplied and
do not tamper with the connector in any way.
A scald hazard can last for a long time after boiling.
Take care when opening the lid e as steam will
escape from the opening. If scalding does occur,
immediately run cold water over the affected area
and seek medical assistance.
BEFORE FIRST USE
Fill to the MAX mark, boil, discard the water, then rinse. Do
this three times, to remove manufacturing dust. Ensure that the
electrical connections are completely dry before use.
SAFE HANDLING
• Pour water from the kettle jug tslowly to prevent splashing
and scalding with the hot water.
• Press the lid release button rand fill the water from the top to
help free the filter qfrom limescale build-up. There should always
be a minimum amount of water in the kettle jug tbefore you
switch it on (MIN mark on the water level indicator y).
• To save time and electricity, only boil the necessary amount of water.
SWITCHING ON
• Place the kettle jug ton the base unit omaking sure that it is
secure on the 360˚connector.
• Plug the mains cable of the base unit ointo a power socket
before switching the power on.
• Switch the kettle ON. The power indicator light awill light up
and the kettle will start heating the water.
SWITCHING OFF
• Once the water is boiled the kettle will automatically switch off.
• Lift the kettle jug tfrom the base unit oand hold it level to
avoid splashing the hot water.
• To boil the water again, place the kettle jug tback on the base
unit oand switch it on again.
• If there is not enough water in the kettle jug t, it will switch
off automatically. To switch it back on, refill the kettle and wait a
few minutes to cool down.
Using insufficient water will shorten the service life
of the appliance.
