PolosSpin150i/200i
rev.: 1.0 Operating instruction
SPS-Europe B.V. page 4
JH131115
1 General information
This documentation is an integral part of the Polos spin processor. The system
should not be activated or operated without this documentation.
Please read completely the manual carefully prior to installation, starting and
operation of the unit.
1.1 Safety instructions
All safety instructions will be found in section 2 of these manual and following
ones.
Prior to installation, starting-up and operation of the system relevant safety
instructions have to be read carefully and considered accordingly.
In addition to the operating instructions generally applicable legal regulations
and other provisions for the prevention of accidents and environmental
protection of the relevant country apply.
In the EU directive 89/391EWG, implemented in Germany in the Ordinance
on Industrial Safety and Health (BetrSichV), Technical Rules for
Operational Safety (TRBS 1203) and Workplaces Ordinance (ArbStättV),
the legislator demands amongst others that the working appliances are
subjected to regular and competent maintenance by trained staff and
checked for operability (effectiveness).
The piping system, especially joints, must be maintained and serviced.
Regular checks for leaks must be performed on all screwing connections
especially in case of temperature-controlled recirculation systems. A sight
inspection should be performed before the beginning of each shift.
If an exhaust module is required by chemical MSDS it has to be ensured
that the quantities of incoming and outgoing air are controlled before
commissioning, i.e. pressure differences in the working range must be
adapted.
1.2 Liability
The manufacturer will not take any liability of object, person and secondary
damage caused by improper use or ignoring of safety instructions as well as
caused by the owner’s manual due to missing updating after the system or its
software have been modified, nor will the manufacturer take any liability of
damages due to loss of data. In case of later modifications of the plant or user
software by the operator liability becomes inapplicable as well.
In addition, the terms of business that are part of the order/contract will apply.
Our products are continuously modified and improved due to innovation, legal
requirements and standards. As a consequence, the information given in this
documentation may not accurately reflect every detail of the system actually
delivered.
Please contact the manufacturer in cases of uncertainty.
