Important Safeguards and Warnings
1. Electrical safety
All installation and operation here should conform to local electrical safety codes.
Use a certified/listed 12VDC 1A or more Class2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same time; it
may result in device damage! The product must be grounded to reduce the risk of electric
shock.
Improper handling and/or installation could run the risk of fire or electrical shock.
2. Environment
Heavy stress, violent vibration or exposure to water is not allowed during transportation,
storage and installation.
This product should be installed in a cool, dry place away from direct sunlight and heat
sources.
Do not install the product in extreme temperature conditions.
Do not expose the camera to electromagnetic radiation. Otherwise it may result in CMOS
sensor failure. Do not block any ventilation openings.
Do not allow water and liquid intrusion into the camera.
3. Operation and Daily Maintenance
Do not attempt to disassemble the camera; in order to prevent electric shock, do not remove
screws or covers.
There are no user-serviceable parts inside. Please contact the nearest service center as soon as
possible if there is any failure.
Avoid from incorrect operation, shock vibration, heavy pressing which can cause damage to
product.
Do not use corrosive detergent to clean main body of the camera. If necessary, please use soft
dry cloth to wipe dirt; for hard contamination, use neutral detergent. Any cleanser for high
grade furniture is applicable.
Avoid aiming the camera directly towards extremely bright objects, such as, sun, as this may
damage the image sensor.
Please follow the instructions to install the camera. Do not reverse the camera, or the reversing
image will be received.
Do not operate it in case temperature, humidity and power supply are beyond the limited
stipulations. Keep away from heat sources such as radiators, heat registers, stove, etc.
Do not expose the product to the direct airflow from an air conditioner.
This manual is for using and managing the product. We may reserve the rights of amending the
typographical errors, inconsistencies with the latest version, software upgrades and product
improvements, interpretation and modification. These changes will be published in the latest
version without special notification.
All pictures, charts, images in this manual are only for description and explanation of our
products. The ownerships of trademarks, logos and other intellectual properties related to
Microsoft, Apple and Google belong to the above-mentioned companies.
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may
cause undesired operation.
FCC compliance:
This equipment has been tested and found to comply with the limits for a digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communication. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Note:
Before installation, check the package and make sure that all components are included.
Contact your rep or Speco customer service department immediately if something is broken or
missing in the package.
