Separate Unirose Bodies
Separate the unirose bodies as shown
in the illustration. The latch side unirose
will be stamped with part # LP22ALN
or # LP22ALE. The lock side unirose will
be stamped with part # LP22ALNO or
# LP22ALEO.
Chassis Disassembly
Use #2 square drive or #2 phillips screwdriver to remove chassis
from lock side unirose. The unirose will be stamped with either
part # LP22ALNO or # LP22ALEO.
If this is a 2" door installation (L3)
there will be spacers between
the chassis and unirose
at the 4 and 10
o’clock positions.
Tools needed to Change SOSS®
UltraLatch® Privacy Stops
Instructions for changing Privacy Stops from standard
Pull Side Configuration to Push Side Configuration
• #2 Sq. Drive Screwdriver (Robertson)
• #2 Phillips Screwdriver (Asian Model)
• 1/16" (1.59mm Hex Bit)
1
2
34
1
Remove Stop and Retainers
Use 1/16" (1.59 mm) hex bit to remove stops and retainers from
above assemblies and layout as shown below. The stops will be
stamped with their part numbers LPBAA3 and LPBAA4.
Note: The stop part numbers are located on the back side of
the part.
Orient Stops
Orient the stops into position shown below.
Stop
Stop
2-Hole Retainer
3-Hole Retainer
ScrewsScrews
Stop
Part # LPBAA3
Stop
Part # LPBAA4
3-Hole Retainer
2-Hole Retainer
ScrewsScrews
Screw at
10 O’clock
Spacer for
2” Doors Only
Spacer for
2” Doors Only
Chassis faces
9 O’clock Position
Chassis faces
3 O’clock Position
Unirose Set Up for
Left Hand Door (Factory Setup)
Unirose Set Up for
Right Hand Door (Chassis Rotated 180°)
Screw at
4 O’clock
Screw at
4 O’clock
Spacer for
2” Doors Only
Spacer for
2” Doors Only
Part #
Stamp
Location
Lock Side UniroseLatch Side Unirose
