Sony SSM-175A Manuel utilisateur
2
Owner’s Record
The model and serial numbers are located at the rear.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your Sony
dealer regarding this product.
Model No. SSM-175A Serial No. ______________
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
This symbol is intended to alert the user to
the presence of uninsulated “dangerous
voltage” within the product’s enclosure that
may be of sufficient magnitude to constitute
a risk of electric shock to persons.
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
CAUTION:
TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS
POLARIZED AC PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
This unit is not intended to be used with computer work
stations.
English
3
English
For the customers in the U.S.A.
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
For the customers in Canada
The Class A digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
CAUTION:
These potential hazards shall be considered common to
most rack installation.
1) Elevated Operating Ambient Temperature
After installed, the operating temperature may be greater
than room ambient. Consideration shall be given to the
environment temperature compatible within the
Manufacturer’s specified limit ofAmbient Temperature of
0°C – +35°C.
2) Reduced Air Flow
After installed, the amount of air flow required for safe
operation of this equipment shall not compromised.
3) Circuit Overloading
Before installing, refer to rated current on this equipment
and make sure that no overloading to the supply circuit
on the rack.
Please confirm the rated current described on this
Operating Instructions.
4) Providing Protective Earth
When this product is installed in a rack and supplied
power from an outlet on the rack, please confirm that the
outlet is provided with a reliable protective earth
connection.
5) Prevention against achieving hazardous condition
due to uneven mechanical loading
When this product is in a rack, please make sure that the
rack does not achieve hazardous condition due to
uneven mechanical loading.
4
Table of Contents
Features .............................................................................. 4
Precautions ......................................................................... 5
Location and Function of Controls .................................. 6
Front Panel ...................................................................... 6
Rear Panel ....................................................................... 7
Connections ........................................................................ 8
Connecting a Video Camera or a VCR ........................... 8
Connecting the Monitors................................................. 9
Specifications.................................................................... 10
Features
•This unit can be used as a closed circuit television monitor
or a video preview/playback monitor.
•Loop through connection allows up to three monitors to
display the same picture.
•Electronic circuits provide safeguards against interference,
noise and change of signal strength to maintain a clear and
stable picture.
•This unit can be mounted in an EIA standard rack.
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
5
Precautions
Cleaning
Clean the unit with a lightly damp soft cloth. Use a mild
household detergent. Never use strong solvents such as
thinner or benzine as they might damage the finish of the
unit.
If you have any question or problem concerning your unit
that is not covered in this manual, please consult your
nearest Sony dealer.
Safety
•The unit operates on 120 VAC, 60 Hz.
•Should any liquid or solid object fall into the cabinet,
unplug the unit and have it checked by qualified personnel
before operating it any further.
•Unplug the unit from the wall outlet if it is not going to be
used for several days or more. To disconnect the cord,
pull it out by the plug. Never pull the cord itself.
•Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.
•Height and vertical linearity controls located at the rear
panel are for special adjustments by qualified personnel
only.
Installation
•Do not install the unit in an extremely hot or humid place
or in a place subject to excessive dust or mechanical
vibration.
•The unit is not designed to be waterproof. Exposure to
rain or water may damage the unit.
6
1
2
3
4
5
6
Location and Function of Controls
1INPUT select switch
Keep this switch released (øA) to monitor the signal from
the VIDEO A IN connector.
Depress this switch (ØB) to monitor the signal from the
VIDEO B IN connector.
2H-HOLD (horizontal hold) control
When the picture has slanting horizontal bars, turn the H-
HOLD control in either direction until a stationary picture is
obtained.
3V-HOLD (vertical hold) control
When the picture rolls up or down on the screen, turn the V-
HOLD control until a single stationary pictures is obtained.
4POWER switch and indicator
To turn on the monitor, depress this switch. The green
indicator lights up.
To turn off the monitor, press the switch again.
5CONTRAST control
Turn clockwise to increase picture contrast and
counterclockwise to decrease it.
6BRIGHT (brightness) control
Turn clockwise for a brighter picture and counterclockwise
for a darker picture.
Front Panel
POWER switch
and indicator
CONTRAST
control
BRIGHT control
INPUT
select
switch
H-Hold
control
V-HOLD
control
7
7VIDEOA connectors and 75ΩON/OFF switch
8VIDEO B connectors and 75ΩON/OFF switch
Two video input connectors (VIDEO A and VIDEO B) for
the composite video signals and their loop-through output
connectors.
To monitor the signals input to the VIDEO A IN connector,
keep the INPUT select switch released (øA).
To monitor the signals input to the VIDEO B IN connector,
keep the INPUT select switch released (ØB).
IN connector (BNC type)
Connect the video output of a VCR, video camera, or
another monitor for loop-through connection.
OUT connector (BNC type)
Connect the video input of a VCR, video camera, or another
monitor for loop-through connection.
75ΩON/OFF switch
Set this switch to ON when only the IN connector is used.
Set this switch to OFF, when both the IN and OUT
connectors are used together for a loop-through connection.
9DC CLAMP ON/OFF switch
When the switch is set to OFF, the black and white areas
may become slightly gray.
To reproduce clear black and white definition, set this switch
to ON.
Rear Panel
ON OFF ON OFF ON OFF
IN OUT
IN OUT
VIDEO BVIDEO A DC CLAMP
7
9
8
DC CLAMP ON/OFF switch
VIDEO A
connectors and
75ΩON/OFF
switch
VIDEO B
connectors
and 75ΩON/
OFF switch
8
ON OFF ON OFF ON OFF
IN OUT
IN OUT
VIDEO BVIDEO A DC CLAMP
Connections
Connecting a Video Camera or a VCR
Connect the VIDEO IN connector to the video output of a
video camera or a VCR.
Video camera
VCR
Video camera
VCR
to video output
to video output
9
Connecting the Monitors
Using the loop-through feature of this unit, the same picture
can be obtained on all the monitors connected. You can
connect up to three monitors.
Adjust the picture contrast and brightness of each monitor.
ON OFF ON OFF ON OFF
IN OUT
IN OUT
VIDEO BVIDEO A DC CLAMP
ON OFF ON OFF ON OFF
IN OUT
IN OUT
ON OFF ON OFF ON OFF
IN OUT
IN OUT
VIDEO BVIDEO A DC CLAMP VIDEO BVIDEO A DC CLAMP
Video camera
to video output
First monitor Second monitor Third monitor
OFF OFF ON
10
General
System EIA standard
Picture tube 17-inch picture measured
diagonally
90-degree deflection
Resolution More than 850 TV line
(horizontal)
Video input Composite: 0.5 – 2 Vp-p, sync
negative (×2)
Video input impedance High impedance for loop-
through; 75Ωterminated
Video output Composite: 0.5 – 2 Vp–p, sync
negative (×2)
Video output impedance Over 10 kΩ
Power requirements 120 VAC, 60 Hz
Power consumption Approximately 35W
Operating temperature 0°C to +35°C (32°F to 95°F)
Storage temperature –10°C to +40°C (14°F to 104°F)
Dimensions 424 ×409 ×380 mm (w/h/d)
(16 3/4×16 1/8×15 inches)
Mass Approx. 17.5 kg (38 lb 5 oz)
Supplied Accessory Operating Instructions (1)
Optional Accessory Mounting Bracket RMM-171
Specifications
Design and specifications are subject to change without
notice.
Autres manuels pour SSM-175A
1
Table des matières
Langues :
Autres manuels Sony Moniteur
Sony
Sony FD Trinitron HMD-A220 Manuel utilisateur
Sony
Sony SDM-S71 Manuel utilisateur
Sony
Sony PlasmaPro PFM 42V1 Manuel utilisateur
Sony
Sony HS75 Manuel utilisateur
Sony
Sony SDM-X95FB Manuel utilisateur
Sony
Sony TRINITRON BVM-20M4DE Manuel utilisateur
Sony
Sony KL-W7000 Manuel utilisateur
Sony
Sony Trinitron CPD-200GS Manuel utilisateur
Sony
Sony SSM-Q177 Manuel utilisateur
Sony
Sony PS3 CECH-ZED1E Manuel utilisateur
Sony
Sony CPD-GF200 VIVITRON 700 Manuel utilisateur
Sony
Sony SDM-S75EB Manuel utilisateur
Sony
Sony KLH-W32 Manuel utilisateur
Sony
Sony PVM-2541 PVM-1741 PVM-740 LMD-2451W LMD-1751W LMD-4251TD LMD-2451TD LMD-2341W LMD-2041W LMD-1541W LMD-940W LMD-1530W LMD-2110W... Manuel utilisateur
Sony
Sony Trinitron GDM-500PST9 Manuel utilisateur
Sony
Sony Trinitron PVM-14M2MDU Manuel utilisateur
Sony
Sony Trinitron GVM-1316TSQ Manuel utilisateur
Sony
Sony Multiscan GDM-2036S Manuel utilisateur
Sony
Sony FW-55BZ35L Instructions de fonctionnement
Sony
Sony TRINITRON BVM-14F5U Manuel utilisateur
