Page 6
• Do not install MyReserve in atmospheres that are cor-
rosive or contain alkali and do not store corrosive or
ammable materials in its vicinity
• Do not install MyReserve in areas at risk of ooding,
in environments with moisture / atmospheres having
a high salt content, near heat sources or in areas at
risk of re
• Do not operate MyReserve on inverters with special
topologies, on module optimizers or battery connec-
tions of hybrid inverters (e.g. Solaredge)
• Do not install MyReserve outdoors without splash-wa-
ter protection
• Do not expose MyReserve to air humidity levels above
85%
• Do not install MyReserve in escape routes or bed-
rooms
Any manipulation/modication of the CAN communica-
tion of the MyReserve will void any warranty claims. Re-
fer to the data sheets of the respective components for
information about the climatic installation, storage and
transport conditions. Disregarding the information pro-
vided in this installation and operating manual will void
any warranty claims.
Safety notices and general sources of danger
DANGER
Damage due to incorrect handling!
Failure to comply with the following instructions regarding device usage and handling can result in danger to
life and limb and/or property damage to the product and other equipment; SOLARWATT assumes no liability for
such hazards.
• The MyReserve battery storage system may only be
commissioned by trained electricians with specic
SOLARWATT training. There is a risk of electric shock.
• Animals, children, persons with reduced physical,
sensory or mental capacities, and persons lacking
sucient experience and knowledge must not be
left unattended in the vicinity of the device.
• Install the product in a dry interior room or in a
splash-water protected outdoor area.
• Do not store corrosive substances in the installation
location.
• Do not place the MyReserve above or below other
equipment.
• Make sure that the device is properly attached to the
wall.
• Keep it away from direct heat emitted by other
equipment, and maintain the minimum safe distanc-
es to other devices specied by the manufacturers of
those devices.
• Do not clean the unit with alcohol or other chemi-
cal agents. In the process, follow the instructions in
chapter “Cleaning / care and maintenance”.
• The maximum current and voltages characteristics
according to the data sheet specications of the re-
spective product must be observed. Otherwise, the
product can be damaged.
• Only use spare parts and accessories that are ap-
proved or recommended by SOLARWATT.
• Always observe all applicable national standards and
directives for connection of battery storage systems.
• Do not expose the product to corrosive substances
like ammonia.
• Repairs or system updates must be carried out by
qualied personnel who are authorized and trained
by SOLARWATT.
• Electrical cables must be protected from improper
use so that no damage can occur due to twisting,
clamping or similar abuse. Do not use cracked or
frayed electrical cables or plug connectors. Inspect
electrical cables from time to time for damage and
immediately decommission them if any defects are
found.
• Never ground the MyReserve with a lightning con-
ductor, telephone wire or gas line.
• MyReserve must never be exposed to dripping or
splashing water. It must be ensured that containers
lled with liquid are not placed on the product.
• The temperature of the MyReserve Command hous-
ing can increase to over 60°C.
• The product must not be disposed of with the house-
hold waste. The applicable disposal regulations in
the respective country must be observed.
